- this is one of the last pieces of the system that still depend on DriverFramework
- add new SIM_GPS_NOISE_X parameter for optionally increasing the GPS noise multiplier (was previously a gpssim command line option)
- add SIM_x_BLOCK parameters to block sensor publication
- SIM_GPS_BLOCK
- SIM_ACCEL_BLOCK
- SIM_GYRO_BLOCK
- SIM_MAG_BLOCK
- SIM_BARO_BLOCK
- SIM_DPRES_BLOCK
* parameter and logic to commander for triggering failsafe from external automatic trigger system.
* logic to startup script for enabling ATS. Added uORB publishing to pwm_input module.
* Refactored out CDev usage from pwm_input and ll40ls. Refactored out ll40ls specifics from pwm_input and cleaned up dead code.
This target was never fully supported and is heavily dependent on a number of DriverFramework drivers that have no in tree equivalents (bebop bus, flow, rangefinder, etc). Deleting this will make it easier to fully drop DriverFramework shortly.
When running in HITL mode, pwm_out_sim publishes actuator_outputs.
px4io unconditionally publishes the uOrb actuator_outputs. When HITL
is configured, the px4io copy of the uOrb has all zeros.
The result is that there are two publications, one valid, and one
all-zeros. This causes the HIL_ACTUATOR_CONTROLS mavlink message
to be incorrect (all-zeros) and the SERVO_OUTPUTS_RAW mavlink
message to be inconsistent, as it takes the data from one or the
other uOrb randomly each cycle.
The fix is to let px4io know that HITL is in effect when it is
started, and modify px4io to suppress publication in this case.
This is a bigger more complicated fix than I would like, but I
think it is conceptually correct.
Signed-off-by: Nik Langrind <langrind@gmail.com>
* Draco-R sensor orientation correction
* LL40LS sensor is not stable during I2C probing. More trials have been implemented.
* px4flow execution has been removed as rc script already running it
* GPS LED script repaired
* Off ICM20608 due to some bug?
* Removed i2c speed adjustment due to SMBUS.
* ms5611 test2 does not exist
* Baud rate has changed.
* Draco-R airframe parameters are updated.
* IFO and Draco parameters are updated
* Draco-R sensor orientation corrected
* Draco-R DSHOT supports
-moved rc.mavlink to the boards optional rc additions (now it's called rc.board_mavlink) to handle board specific mavlink needs (mavlink over usb, ethernet, additional streams, etc.)
-mavlink module will be responsible to usb defaults, therefore less args are needed to be passed to mavlink module if one wants to use mavlink over usb.
-the way to check if connection is usb is by it's designated variable and not by config mode.
Daniel Agar
Jacob Dahl
Lorenz Meier
Julian Oes
JaeyoungLim
Ricardo Marques
Matthias Grob
RomanBapst
Julien Lecoeur
Nik Langrind
TSC21
Oleg Kalachev
xdwgood
Jacob Dahl
Jaeyoung-Lim
Beat Küng
BazookaJoe1900
garfieldG
mcsauder
Silvan Fuhrer
Hyon Lim