When on the ground it is likely the flow sensor will be returning data that does not meet the minimum quality requirements selected.
The previous check was for the presence of valid data. This has been loosened to look for the presence of data.
When the vehicle becomes airborne, the quality of flow data normally improves as the image comes into focus.
1) Un-used public methods to report height and position drifting have been removed
2) A time-out has been added to the airspeed innovation consistency check so that if we are relying on airspeed to constrain velocity drift, a filter divergence or other fault that causes the airspeed to be continually rejected will trigger a change in health status.
3) A timeout of velocity, position or height measurements does not cause a filter fault to be reported. Timeouts can be due to sensor errors and do not necessarily indicate that the filter has failed.
4) Time-outs of various measurements are used to present a consolidated bitmask which inidicates which parts of the solution can be used, eg attitude, height, velocity, relative position, absolute position, etc.
The time required for GPS to be lost or rejected before vehicles with airspeed sensors either reset to GPS or invoke the zero side-slip assumption to constrain drift has been reduced from 15 to 10 seconds
A duplicate zeroing of the GPS position offset has been removed
If the vehicle is a non hovering vehicle (eg a plane) then the speed at which the GPS offset is pulled back to zero after a reset is increased from 1 to 3 m/s
This also improves recovery from bad inertial data for planes
Doing this can cause large height and height rate errors if large GPS velocity errors cause the GPS tn be rejected for long enough to cause a timeout and reset of states.
This reverts commit 13df6fb1c9.
This patch was a result of an incorrect merge of the optflow branch
into master. It reintroduced the bug fixed by this commit:
AP_NavEKF : Fix bug in reset of GPS glitch offset
8aa267f75f
This provides the calling vehicle software the abiity to request the EKF to not use GPS.
An integer is returned that indicates the type of operation available:
0 = request rejected (request will only be accepted if the EKF is in static mode, eg pre-armed)
1 = request accepted, attitude, vertical velocity and position estimates available
2 = request accepted, attitude, height rate, height, horizontal velocity and relative position estimates available
This takes into account the inter-sampling delay between the flow driver and the APM software which depends on the rate at which the dirver is being checked. This is 50Hz for plane and rover, and 200Hz for Copter.
priseborough
Randy Mackay
Andrew Tridgell