add UART6 and VBUS to BETAFPV F405
add alt config to BETAFPV-F405 to support RELAY2 instead of UART6_TX as per betaflight
enable SBUS input on BETAFPV-F405 on UART5_RX
enable IMU temperature calibration for BETAFPV-F405
correct current scale on BETAFPV-F405.
BETAFPV-F405 SPL06 Baro
correct baro SPI read rate on BETAFPV-F405
use SPL06 with background updates on BETAFPV-F405
Update README.md: add bluetooth introduction to features
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: fix description about SERIAL8
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: fix description about RC
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: add description about "LED" pin
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: fix description about Loading Firmware
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: fix description about update firmware
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
remove defaults.parm and defined default params in hwdef file
Update README.md: fix description about osd
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
remove parameter define about serial4
Update README.md: add a section about BlueTooth
Update README.md: uses internal esc
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: introduction about RC input
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
Update README.md: introduction about PWM groups
Co-authored-by: Henry Wurzburg <hwurzburg@yahoo.com>
remove defaults.parm and defined default params in hwdef file
on H730 we are overflowing the ITCM area for SPRacingH7RF and other boards are not far behind.
Step away from the edge by removing this function which should never be in a fast path
The CAN port as it was is a valid CAN port for the nucleo, but on the development board the CAN silkscreen is actually on PD0 and PD1. This change makes it easier to get the example running on the Nucleo
