internal PX4IO safety_off state is removed and replaced with a normal safety button event. From this 'commit' commander is taking care of the PX4IO safety.
- limit to handling only 1 motor failure
- Log which motor failures are handled
- Remove motor from effectiveness matrix without
recomputing the scale / normalization
- add logic for detecting high wind speed in Commander,
and handle it toghether with wind speed warning
- trigger and enforce RTL if COM_WIND_MAX is breached
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
[4] is reserved for Flaps, so also having the tilt on it was preventing us from
using flaps on tiltrotors, and other ripple effects.
By using [8] the tilt is separated from all other channels - it requires to increase the size of
actuator_controls by 1 to 9.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- sensor_baro.msg use SI (pressure in Pascals)
- update all barometer drivers to publish directly and remove PX4Barometer helper
- introduce baro cal (offset) mainly as a mechanism to adjust
relative priority
- commander: add simple baro cal that sets baro offsets to align with
GPS altitude (if available)
- create new sensors_status.msg to generalize sensor reporting
- ekf2: expose dead reckoning as control status flags
- commander:
- add GPS validity check
- in AUTO MISSION if dependent on GPS then a loss of GPS will
This is a bigger refactor of vmount to clean it up and plug some holes
in functionality.
The changes include:
- Fixing/simplifying the test command.
- Changing the dependencies of the input and output classes to just the
parameter list.
- Adding a separate topic to publish gimbal v1 commands to avoid
polluting the vehicle_command topic.
- Removing outdated comments and author lists.
- Extracting the gimbal v2 "in control" notion outside into control_data
rather than only the v2 input.
If we receive gimbal_device_attitude_status by mavlink we should not
re-send it as we are already supposed to be forwarding mavlink traffic
from the gimbal to the ground station.
- move vehicle at reset detection ekf2 -> land_detector
- ekf_unit: reduce init period
- Fake fusion is when at rest is quite strong and makes the variance reduce rapidly. Reduce the amount of time we wait before checking if the variances are still large enough.
- ekf_unit: reduce minimum vel/pos variance required after init
- Fake pos fusion has a low observation noise, making the vel/pos variances reduce quickly.
Co-authored-by:: bresch <brescianimathieu@gmail.com>
Daniel Agar
Igor Misic
Matthias Grob
mcsauder
Silvan Fuhrer
Alessandro Simovic
Beat Küng
Alex Mikhalev
bresch
RomanBapst
Junwoo Hwang
Hovergames
Daniel Mesham
Julian Oes
CUAVmengxiao
Roman Dvořák
Thomas Stastny