Commit Graph

148 Commits

Author SHA1 Message Date
Andrew Tridgell 913004beb0 Plane: added OVERRIDE_CHAN parameter
this allows both for testing PX4IO override on the ground, and for
forced manual override while flying, including re-arming after in-air
reboot
2014-11-07 10:39:07 +11:00
Andrew Tridgell 240e87dc2c Plane: update for new AP_InertialSensor API 2014-10-24 12:10:38 +11:00
Andrew Tridgell 2fc69c7c4c Plane: disable CLI by default
it really isn't needed any more, and saves 20k of flash on APM2
2014-10-22 18:27:08 +11:00
Andrew Tridgell 1fa03a49c9 Plane: disable the CLI if AFS failsafe enabled on APM2
the flash space is a bit too low for both CLI and AFS
2014-09-24 12:02:38 +10:00
Andrew Tridgell 21ed86004a Plane: raise the default WP radius
with L1 a large radius doesn't mean it turns too early
2014-08-30 07:43:11 +10:00
Andrew Tridgell 4f57467aa5 Plane: build AFS (formerly known as OBC) failsafe on Pixhawk
this gives an advanced failsafe system which may be useful for other
than OBC use
2014-08-08 13:48:03 +10:00
Matthias Badaire 57253fc2ee Rover: Add SERIAL2_PROTOCOL for GCS and FRSky telemtry
This allows selection of protocol type on telem2. The default is MAVLink, but can be selected as FrSky protocol
2014-07-29 17:08:20 -07:00
Andrew Tridgell ae29a24348 Plane: use sensors from board subtypes 2014-07-14 09:44:35 +10:00
Andrew Tridgell f6bba74fb6 Plane: enable MPU9250 for Linux build 2014-07-14 09:44:34 +10:00
Víctor Mayoral Vilches fc57bdedde ArduPlane/config.h: Add the PXF hardware setup 2014-07-14 09:31:41 +10:00
Emile Castelnuovo a111d174c1 Plane: added VRBRAIN #defines and #includes 2014-04-08 16:19:20 +10:00
Andrew Tridgell e19341ca32 Plane: convert to new GPS driver API 2014-04-01 06:38:24 +11:00
Andrew Tridgell e3952112ad Plane: raise default LIM_PITCH_MAX to 20 degrees
15 is often not enough to climb
2014-03-03 15:49:04 +11:00
Andrew Tridgell 6b9e1edf38 Plane: disable GPS2 in HIL 2014-02-27 08:16:28 +11:00
Andrew Tridgell 07826096a2 Plane: support a 2nd GPS 2014-02-26 09:24:23 +11:00
Andrew Tridgell d9cb101a03 Plane: default LOG_BITMASK to 32767 on non-APM 2013-12-31 10:28:38 +11:00
Andrew Tridgell ce773f085a Plane: make the defaut for FS_GCS_ENABL clearer 2013-12-20 11:44:44 +11:00
Andrew Tridgell 8383abc1fe Plane: added SERIAL2_BAUD and rename SERIAL3_BAUD to SERIAL1_BAUD 2013-11-26 13:00:03 +11:00
Andrew Tridgell a05a32dbda Plane: added RCIN and SRVO logging 2013-11-26 09:04:43 +11:00
Andrew Tridgell 7e10811673 Plane: send firmware and git version in tlog 2013-11-09 10:09:20 +11:00
Andrew Tridgell 5e1f5ffb7f Plane: removed some old defines 2013-10-14 14:40:30 +11:00
Andrew Tridgell e6af7dad3d Plane: switched to L3G4200D driver for Linux 2013-10-08 11:50:54 +11:00
Randy Mackay c64d444b5a Plane: integrate BattMonitor 2013-10-03 11:16:08 +09:00
Andrew Tridgell 444d053dc2 Plane: enable Oilpan and BMP085 on Linux 2013-09-29 01:02:05 +10:00
Andrew Tridgell 287db19119 Plane: updates for Stub -> HIL 2013-09-28 22:04:15 +10:00
Andrew Tridgell c3d0b315cf Plane: added HAL_LINUX includes 2013-09-28 21:24:02 +10:00
Mike McCauley 18c6b00b5b Plane: Added definitions for Flymaple 2013-09-24 13:51:28 +10:00
Andrew Tridgell 21a4da0d29 Plane: removed flash_leds() calls 2013-09-19 18:38:28 +10:00
Andrew Tridgell 4bd6b2f428 Plane: use new usb_connected() function 2013-09-19 16:23:58 +10:00
Andrew Tridgell b16e3e4c85 Plane: changed FBW min to 9 m/s
6 m/s is too dangerous for widely used planes
2013-08-18 11:42:23 +10:00
Andrew Tridgell 5cfdf52381 Plane: change default modes to FBWA not STABILIZE 2013-08-13 13:42:27 +10:00
Andrew Tridgell c083c15240 Plane: use a larger serial buffer
this makes higher rate MAVLink possible again
2013-08-02 18:46:54 +10:00
Andrew Tridgell b8fa83ff54 Plane: change default slewrate to 100%/second 2013-07-22 12:50:02 +10:00
Andrew Tridgell c8a83e17d0 Plane: remove old AIR_START code
this was never used or tested
2013-07-22 12:50:01 +10:00
Andrew Tridgell 4087fde140 Plane: enable CTUN log message by default 2013-07-14 21:10:12 +10:00
Andrew Tridgell 3c177867a4 Plane: allow enable/disable of camera log messages in CLI 2013-07-10 12:23:36 +10:00
Paul Riseborough d62636d309 Plane: added new TECS altitude controller
Includes improvements to takeoff/launch detect logic to support hand
launching for X-8 flight
2013-07-04 16:56:57 +10:00
Andrew Tridgell f7697574db Plane: use the new airspeed driver interface
the choice of analog source is now in the airspeed driver
2013-06-03 11:51:09 +10:00
Andrew Tridgell dd633fcf3f Plane: make voltage and battery capacity failsafe settable at runtime
this also fixes issue #292
2013-05-22 20:33:57 +10:00
Andrew Tridgell 001d18b51d Plane: removed scaling of pitot source 2013-05-13 15:19:05 +10:00
Andrew Tridgell 9c6f80c42b Plane: moved some default values to Parameters.pde 2013-05-05 21:51:09 +10:00
Andrew Tridgell 4e2b88f6e6 Plane: added ATT_CONTROLLER option to select attitude controller
set to 1 for the new APM_Control library
2013-05-05 21:51:09 +10:00
Andrew Tridgell 0d97f417ec Plane: enable compass on all boards by default
if not present, then mag init will fail and it will disable
2013-05-02 15:01:33 +10:00
Andrew Tridgell a019e3740e Plane: updates for new compass API 2013-05-02 12:48:14 +10:00
Andrew Tridgell de3fcbc413 Plane: removed the MANUAL_LEVEL option
levelling on every startup is far too error prone. This was just
another parameter that everyone changed.
2013-04-29 14:19:53 +10:00
Bill Bonney 3ec891265f Plane: Enable CURRENT logging by default onto Dataflash 2013-04-21 07:24:02 +10:00
Andrew Tridgell 0c5b393919 Plane: added compass logging 2013-04-20 13:52:36 +10:00
Andrew Tridgell 11eb0cfce1 Plane: update for new AP_Navigation controller class
this switches ArduPlane over to use the L1 navigation controller, via
a generic nav_controller object pointer.

Note that the nav_controller controls all types of navigation now,
including level flight and heading hold. This provides a cleaner
abstraction than the old method of special case navigation handling

Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2013-04-12 12:48:09 +10:00
Andrew Tridgell dfb14d760b Plane: added HIL_SERVOS option
this allows for real servo output in HIL
2013-03-30 14:38:43 +11:00
Andrew Tridgell c989099665 Plane: enable PX4IO dual telemetry devices 2013-02-18 13:56:21 +11:00