Change PID to 0x4b:
Holybro obtained their own PID and VID but APM did not follow
the PX4 convention of makeing the board_id (0x8b) match the PID)
Incorporated the Upstream Bootloader state sequencing checking change.
Change the usb cout to send all chars in 1 write.
This issue was found by @khabir and reported over slack.
It resulted from the split up of the big pr #12072 into #13262.
I took over the interface while the internal states still stayed the
hard to understand internal ones. One of the follow up refactors will
fix this completely and the entire legacy setpoint restore block can
be removed.
* FW attitude controller, FW position controller and VTOL attitude controller subscribe to airspeed_validated topic
* add possibility to switch off the airspeed valid checks
* remove airspeed valid checks from commander
* clean up of VTOL transition logic
* Airspeed Selector: remove dynamic allocation of airspeed validators (depending on number of connected sensors) but do it statically for the maximum number allowed. Check for number of connected sensors not only during start up, but always when vehicle is disarmed.
* Airspeed Selector: change work queue from lp to att_pos_ctrl as this module is safety-critical
* add airspeed selector to px4_fmu-v2 defaults
* fix formatting
* RoverPositionControl: Support Actuator Control Setpoints (fixes#13192)
* RoverPositonControl: remove control modes, that aren't currently implemented
* RoverPositionControl: use new Publication API
When running in HITL mode, pwm_out_sim publishes actuator_outputs.
px4io unconditionally publishes the uOrb actuator_outputs. When HITL
is configured, the px4io copy of the uOrb has all zeros.
The result is that there are two publications, one valid, and one
all-zeros. This causes the HIL_ACTUATOR_CONTROLS mavlink message
to be incorrect (all-zeros) and the SERVO_OUTPUTS_RAW mavlink
message to be inconsistent, as it takes the data from one or the
other uOrb randomly each cycle.
The fix is to let px4io know that HITL is in effect when it is
started, and modify px4io to suppress publication in this case.
This is a bigger more complicated fix than I would like, but I
think it is conceptually correct.
Signed-off-by: Nik Langrind <langrind@gmail.com>
Matthias Grob
Julian Oes
David Sidrane
TSC21
Silvan Fuhrer
Daniel Agar
Julien Lecoeur
Tanja Baumann
Julien Lecoeur
Beat Küng
Jannik Beyerstedt
Jannik Beyerstedt
Nik Langrind
Claudio Micheli