- sitl_gazebo-classic in PX4/Firmware (a3f398943e): 0d53638452
- sitl_gazebo-classic current upstream: c8ac7ff39b
- Changes: 0d53638452...c8ac7ff39b
c8ac7ff 2023-07-18 Martina Rivizzigno - Add gimbal device id to mavlink messages DeviceAttitudeStatus and DeviceInformation (#994)
Since we changed the threshold for allowing arming from TRIM/2 to AIRSPEED_MAX
is is very unlikely that one needs to disable this check.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Experience from tuning different VTOL backtransitions showed only having a
I controller is beneficial over a combined FF/I breaking controller.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Case: A vehicle is already operating but has no stick input or another
source than RC. When RC stick input is switched to either because it gets
first time available or as a fallback to joystick then the mode was
immediately changed to the switch position. This can lead to loss of
control e.g. when the vehicle is flying far away and the
mode switch of the RC is in some fully manual piloted mode.
I added tests to cover the cases where RC mode initialization is expected
and also unexpceted because the vehicle is already armed.
modules__ instead of module__ prefix
The module depends on the hysteresis library and probably because
it compiles with the still prevalent global includes the dependency
is not declared.
also for the other linux target builds. It's a follow up to
e5503480e3
I wasn't aware that there are multiple different
container versions used for almost the same build.
in air bias estimation is usually really accurate and should be weighted
more heavily compared to the calibration parameters that are often
more approximate given the worse magnetic environment near the ground.
- since last_us is set to 0 every time the bias is not observable, the
total time was also reset -> needed 30 consecutive seconds in mag 3D
to be declared "stable"
- after landing, the mag_aligned_in_flight flag is reset. Using this for
bias validity makes it invalid before we have a chance to save it to
the calibration.
Opt flow raw innovations can be really large on ground due to the small
distance to the ground (vel = flow / dist). To make the pre-flight check
more meaningful, scale it with the current distance.
Matthias Grob
Daniel Agar
PX4 BuildBot
Ramon Roche
Martina Rivizzigno
Beat Küng
henrykotze
bresch
bresch
Silvan Fuhrer
Sergei Grichine
Loic Fernau
alexklimaj
Eric Katzfey
mjturi-mai