Andrew Tridgell
401534ac89
Plane: added ONESHOT_MASK parameter
...
after discussion with Paul on servo latency
2021-08-28 14:41:27 +09:00
Andrew Tridgell
d67f82e02d
Plane: added manual input expo for MANUAL, ACRO and TRAINING
...
this is easier than setting up mode specific expo in radios for flying
in manual modes
2021-08-28 14:41:27 +09:00
Peter Barker
055e82276e
ArduPlane: remove HIL support
2021-06-15 09:47:31 +10:00
Hwurzburg
e958306343
Plane: Add options to USE_REVERSE_THRUST to cover all flight modes
2021-06-15 07:05:02 +10:00
Andrew Tridgell
0937d903a1
Plane: use HAL_EFI_ENABLED
2021-06-09 18:07:00 +10:00
Iampete1
60d26723ae
Plane: make TERRAIN_FOLLOW at AP_int32 bitmask, per mode option
2021-03-24 10:15:18 +11:00
Iampete1
cca5e62c89
Plane: move RST_SWITCH_CH to RCx_OPTION
2021-03-17 19:18:46 +11:00
Iampete1
7226a3a9dc
Plane: move FBWA_TDRAG_CHAN to RC Options
2021-03-17 19:18:46 +11:00
Iampete1
5f555e5314
Plane: move CHUTE_CHAN to RC Options
2021-03-17 19:18:46 +11:00
Iampete1
eeab196d91
Plane: move RST_MISSION_CH to RC option
2021-03-17 19:18:46 +11:00
James O'Shannessy
aae092b88f
ArduPlane: Remove all unused geofence capability
...
ArduPlane: Remove missed geofence logic
2021-03-05 14:52:46 +11:00
James O'Shannessy
17fb585bf1
ArduPlane: Add support for AC_Fence
...
ArduPlane: Remove some geofence logic from ArduPlane
ArduPlane: Refactor action and mode return implementation
ArduPlane: Use polyfence to find the return point.
2021-03-05 14:52:46 +11:00
Tom Pittenger
c653ff880a
Plane: extend Stream rates param count to match MAVLINK_COMM_NUM_BUFFER
2020-12-29 07:52:09 -07:00
Andrew Tridgell
52f61c7ac1
Plane: make FENCE_AUTOENABLE an AP_Enum
2020-12-02 18:33:07 +11:00
Samuel Tabor
10111f92d5
Plane: Rename SOARING_ENABLED to HAL_SOARING_ENABLED and don't compare to ENABLED.
2020-09-24 07:30:48 +10:00
Siddharth Purohit
fb180fa431
Plane: move to using CANManager library
2020-08-19 17:31:09 +10:00
Buzz
0f5177b291
Plane: Support a set of offboard MAVLink guided controls with rates
...
+ 3 rounds of fixes
2020-05-20 15:03:21 +10:00
Andrew Tridgell
8b21f5117a
Plane: implement RTL_CLIMB_MIN parameter
...
this allows for an initial climb on RTL where roll is limited to
LEVEL_ROLL_LIMIT
2020-05-18 13:04:04 +10:00
Paul Riseborough
40cc5a5006
ArduPlane: Improve EKF failsafe in VTOL modes
...
Replicates Copter behaviour with a three step process if the EKF sustains a loss of navigation as detected by high GPS innovation test ratios:
1) Attempts a yaw reset using the GSF estimate if available
2) Attempts a lane switch
3) Falls back to a non-position mode
2020-05-14 10:40:48 +10:00
Iampete1
3ded030fa8
Plane: compensate forward throttle for battery voltage drop
2020-05-05 09:46:41 +10:00
Peter Hall
660c9a8a60
Plane: move from FLAP_IN_CHANNEL to RCx_Option
2020-01-01 08:11:01 +11:00
Andy Piper
eca398e7a2
Plane: create generic vehicle management and move runcam to it
2019-12-30 13:02:04 +11:00
Peter Barker
33a0e55b32
Plane: correct duplicate button instance
2019-12-10 09:29:52 +09:00
Andrew Tridgell
2b27cd2ce9
Plane: Add EFI Support
2019-11-17 20:10:54 +11:00
Andrew Tridgell
ff400243e0
Plane: added a new TAKEOFF flight mode
...
takeoff then circle in direction of takeoff
2019-10-17 12:19:43 +11:00
Mark Whitehorn
f054301ec2
Plane: add QACRO roll/pitch/yaw rate params
2019-04-23 09:46:38 +10:00
IamPete1
520f5f7894
Plane: add crow flap options paramiter
2019-04-04 09:18:11 +11:00
Peter Barker
73707077b5
Plane: move enabled parameter into compass library
2019-04-02 10:24:49 +11:00
Andrew Tridgell
3907466f9d
Plane: added TKOFF_TIMEOUT parameter
...
this allows for a timeout on auto-takeoff. This can be combined with
other takeoff parameters to allow the user to abort a hand-launch
after the motor has started without GCS interaction.
The 4m/s threshold is a bit arbitrary. We could make that a parameter
in the future if it is needed
2019-03-18 14:48:08 +11:00
Peter Barker
40856fef56
Plane: remove vestiges of old PX4_MIXER code
2019-01-19 19:31:03 +11:00
Peter Barker
b47733142f
GLOBAL: rename DataFlash_Class to AP_Logger
2019-01-18 18:08:20 +11:00
Andrew Tridgell
1d00d26b9e
Plane: added parameters for crow flaps
...
DSPOILER_CROW_W1 and DSPOILER_CROW_W2 for inner and outer control
surfaces
2018-11-20 10:00:38 +11:00
Eugene Shamaev
01178a75e9
Plane: added landing gear support
2018-11-09 14:35:14 +11:00
Andrew Tridgell
d5c29fc57e
Plane: use IOMCU mixing if available
2018-11-07 07:35:45 +11:00
Andrew Tridgell
a00e06ea13
Plane: added TKOFF_ACCEL_CNT for multi-shake to start
...
this allows you to setup shake to start with a lower accel threshold,
but with multiple fwd/back movements needed.
This implements https://github.com/ArduPilot/ardupilot/issues/2221
2018-10-31 18:53:36 +11:00
Michael du Breuil
3aed07a83a
Plane: Create a scripting object
2018-10-09 10:08:52 +11:00
Peter Barker
b574f4c1fc
Plane: move support for inverted flight to rc-aux-switch
...
Functional change here; if someone de-configures the rc aux switch in
flight they will remain inverted
2018-09-07 09:07:40 +10:00
Michael du Breuil
8417bcc7d5
Plane: Add flight options bitmask
2018-08-28 09:40:53 +10:00
Peter Barker
9ce02bc504
Plane: minimal support for inheritting from RC_Channel
2018-08-01 12:11:30 +09:00
Andrew Tridgell
1d675390ab
Plane: make soaring an optional build feature
...
this disables soaring on px4-v2, saving 5k of flash
This is needed to consider pr #9042 , which takes a lot of flash space
2018-07-30 13:09:15 +10:00
Andrew Tridgell
bc503cc600
Plane: moved OSD to top level params
...
this is to give lots of depth for OSD params (which will be very
complex)
2018-06-27 14:55:00 +10:00
Alexander Malishev
75bf6984f5
Plane: added OSD support
2018-06-27 14:55:00 +10:00
Michael du Breuil
44f2a652f3
Plane: Remove software type param
2018-06-05 09:14:12 +10:00
Michael du Breuil
7405bb7b85
Plane: Support new battery failsafes
2018-03-27 22:12:21 +01:00
night-ghost
98b8a61ca8
Plane: allow AP_Stats to be optional
2018-03-02 07:23:35 +11:00
David Ingraham
a6aeebad4b
Plane: Add support for AP_Gripper
2018-03-01 14:14:43 +11:00
Tom Pittenger
512b327cd4
Plane: failsafe events to use enums instead of magical numbers : Non-functional change
2017-12-07 00:19:32 -08:00
Michael du Breuil
8630037fd7
Plane: Parameterize the home altitude reset conditions
2017-08-29 13:09:46 -07:00
Andrew Tridgell
d541ac509f
Plane: removed TRIM_RC_AT_START parameter
...
this option caused a lot more problems than it solved, and is buggy
2017-08-29 07:35:49 +10:00
Peter Barker
1a665280e9
Plane: remove CLI
2017-08-14 10:23:50 +09:00