this is for little used options to allow standard firmware builds to
enable those options for development purposes
First option is for MAVLink based ADSB avoidance
this adds TKOFF_NAV_ALT which controls the altitude above takeoff that
navigation can begin. It is meant for unstable vehicles such as helis
to prevent blade strike during initial takeoff.
This also adds a new parameter class ParametersG2 which can hold 64
parameters. This is to avoid running out of parameters in the first
256 block
this is the descent rate for the first part of a landing. Separating
this from WPNAV_SPEED_DN allows for independent tuning of fast fwd
flight from landings
The is commit adds a new flight mode called 'Throw' to Copter that enables the copter to be thrown into the air to start motors. This mode can only be netered when the copters EKF has a valid position estimate and goes through the following states
Throw_Disarmed - The copter is disarmed and motors are off.
Throw_Detecting - The copter is armed, but motors will not spin unless THROW_MOT_START has been set to 1. The copter is waiting to detect the throw. A throw with an upwards velocity of at least 50cm/s is required to trigger the detector.
Throw_Uprighting - The throw has been detected and the copter is being uprighted with 50% throttle to maximise control authority. This state transitions when the copter is within 30 degrees of level.
Throw_HgtStabilise - The copter is kept level and height is stabilised about the target height which is 3m above the height at which the throw release was detected. This state transitions when the height is no more than 0.5m below the demanded height.
Throw_PosHold - The horizontal motion is arrested and the copter is kept at a constant position and height.
* Retains ability to read from Analog Pin
* Adds ability to read RSSI from PWM channel value as is done in OpenLRSng, EazyUHF, and various other LRS.
* Handles any type of RSSI that provides RSSI values inverted - i.e. when the low value is the best signal and the high value is the worst signal.
* Has different key names from all existing RSSI parameters to provide for a clean break and easier distinguishing.
* Existing parameters are marked as obsolete
This commit changes the way libraries headers are included in source files:
- If the header is in the same directory the source belongs to, so the
notation '#include ""' is used with the path relative to the directory
containing the source.
- If the header is outside the directory containing the source, then we use
the notation '#include <>' with the path relative to libraries folder.
Some of the advantages of such approach:
- Only one search path for libraries headers.
- OSs like Windows may have a better lookup time.
Mathieu OTHACEHE
Andrew Tridgell
Leonard Hall
Randy Mackay
chambana
Daniel Ricketts
Lucas De Marchi
Paul Riseborough
Jonathan Challinger
pepevalbe
Peter Barker
Tom Pittenger
Robert Lefebvre
Stewart Loving-Gibbard
Gustavo Jose de Sousa