Analysis of copter logs has shown cases with a healthy EKF where spikes in EKF4.DS of up to 25% of the threshold have occurred.
A value of closer to 10% for normal operation is preferred.
Don't do bias estimation if tilted by more than 60 degrees to prevent scale
factor errors affecting result unnecessarily.
Prevent Kalman gain from having the wrong sign due to numerical errors
associated with small process noise values.
Allow smaller Z accel bias process noise values to be set
Bring Plane glitch protection thresholds into alignment with copter and
rover
Slight increase in accelerometer bias process noise to prevent bias
estimate divergence into limits (Rover and Plane only as Copter does not
seem respond as well to this change)
effective increase in threshold on divergence test to allow increased
margin for bad GPS velocities
Divergence is now detected by looking for very large changes in the gyro
bias. This will cause the filter to be reset and declared unhealthy for
10 seconds.
Don't reset filterDiverged status immediately during reset
Set filterDiverged true if covariance blows up
Add fault status reporting
This will enable in-flight magnetometer calibration to be inhibited unconditionally,
This is required for long balloon carriage flights where ground speed can be high
enough to put it into in-air state, but with very poor observability of magnetic field
states causing bad state estimates and heading offsets to develop over time.
The covariance matrix no longer has rows and columns artificially zeroed when in static
mode. Instead booleans indicating whether wind or magentic field state estimation is
active are used to:
a) Set the process noise on these states to zero to stop their variances from increasing
unchecked when not being updated, and
b) Turn off updates for these states when measurement fusion is being performed.
This reduces the likelihood of a badly conditioned covariance matrix forming
during static mode operation.
A filter divergence check has also been added that will declare the filter unhealthy if
position, velocity and magnetic field observations are all failing their innovation
consistency checks. This unhealthy status will persist for 10 seconds after the
condition clears.
AP_NavEKF: Remove unnecessary zeroing of wind covariances
A magnetometer axis that fails the innovation consistency check will cause
all axes not to be used. If this condition continues for 10 seconds, a
magnetometer timeout condition will be declared. When the timeout has
occurred, if it is not a fly forward vehicle, then individual channels
will be used again, but with a reduced weighting.
this will cope better with users with low roll/pitch gains, to ensure
they get enough control on takeoff
Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
Flight testing with windup turns has shown that the position gate threshold
can be tripped with good GPS data causing position jerks. This increases the
initial GPS glitch rejection threshold to effectively 5m when using the
default POSNE_NOISE value of 0.5m.
This patch also cleans up the logic associated with use of the synthetic
sideslip measurement so that it can never be used for a non fly-forward
vehicle type
This patch adds functionality that initialises the wind-speed vector to the
reciprocal of the ground speed vector, and scaled to 6 m/s. On average this gives
a better initial wind velocity estimate on launch by assuming:
a) launch will be into wind
b) wind speed is equal to global average
It also helps prevent a headwind causing initial underestimation of airspeed
causing high autopilot gains and limit cycles on climb-out, until first
turn when the EKF is able to estimate the wind.
When using GPS after previously rejecting it, the GPS position will
always be offset if outside the specified glitch radius. This was the
original intent of the design and makes handling of glitches smoother.
It has been tested on replay using glitchy flight data
Aliasing can causes the bias estimate to fluctuate very rapidly as it tries
to keep up, which degrades the benefit of switching between
accelerometers to avoid aliasing.
This patch give a much more stable bias estimate during aliasing, and
allows the bias to adapt at a maximum rate of 1.0 m/s2 in 50 seconds
This adds new functionality to the detection and compensation of GPS
glitches:
1) A maximum allowable innovation is calculated using the GPS noise
parameter multiplied by the gate, with an additional component allowing
for growth in position uncertainty due to acceleration error since
the last valid measurement
2) Includes per vehicle type values for the acceleration error limit
3) If the innovation length exceeds the maximum allowable, no fusion occurs
4) If no fusion has occurred for long enough such that the position uncertainty
exceeds the maximum set by a per vehicle parameter or a maximum time, an offset
is applied to the GPS data to so that it matches the value predicted by the filter
5) The offset is never allowed to be bigger than 100m
6) The offset is decayed to zero at a rate of 1.0 m/s to allow GPS jumps to
be accommodated gradually
7) The default velocity innovation gate has been tightened up for copter and rover
8) The variance data logging output has been updated to make it more useful
This patch reduces the maximum acceptable GPS jump from approximately 16 to 8 metres
This will provide copters with more protection for close in loiter situations
This path reduces duplicated code, eliminates unused variables and
causes the earth magnetic field states to be reset when exiting static mode
which will occur every time copter is armed. This enables copters to be
powered on and initialised inside vehicles or houses, without bad earth
field values affecting flight.
priseborough
Andrew Tridgell
Emile Castelnuovo