Commit Graph

156 Commits

Author SHA1 Message Date
Andrew Tridgell 2331c84423 Plane: use voltage_average() to not depend on INPUT_VOLTS 2013-03-03 16:16:01 +11:00
Jochen Tuchbreiter c5f19f5df8 Plane: Implement issue 80: counterclockwise loiter
- libraries/AP_Common/AP_Common.h: Use bit 2 of Location.options to store
  loiter direction
- ArduPlane/defines.h: New bitmask MASK_OPTIONS_LOITER_DIRECTION for struct
  Location bit 2
- ArduPlane/ArduPlane.pde: New variable loiter_direction
- ArduPlane/GCS_Mavlink.pde: For mavlink loiter-commands use sign of param3 to
  detemine direction. Set Location.option flag accordingly
- ArduPlane/commands.pde: Make sure loiter-directions get saved into EEPROM
  correctly
- ArduPlane/commands_logic.pde: Set loiter_direction on all loiter-actions
  as well as RTL/instant loiter
- ArduPlane/navigation.pde: Yield loiter_direction in update_loiter
2013-02-05 10:29:31 +11:00
Randy Mackay 7297a1ff83 Plane: renamed RAW dataflash message to IMU 2013-01-26 17:29:29 +09:00
Randy Mackay e674626fd6 Plane: rename CUR and CURR to CURRENT for logging
Based on user complaint that log was enabled/disabled using CUR while
message that appeared in log was CURR.
2013-01-26 17:19:42 +09:00
Randy Mackay 6f46f4a7d0 Plane: logging changes to use new faster packet method
also RAW message renamed to IMU
2013-01-26 17:07:21 +09:00
Andrew Tridgell 4d9a74d742 Plane: cleanup driver declaration
remove a lot of the #if nesting
2013-01-21 16:08:55 +11:00
Andrew Tridgell bfaf91affe Plane: use an enum for flash log message types 2013-01-13 17:31:42 +11:00
Andrew Tridgell 38f56be2c4 Plane: enable hardware sensors on PX4 2013-01-04 21:07:56 +11:00
Andrew Tridgell b6295c12e1 Plane: fixes for new AP_Relay interface 2013-01-02 10:18:45 +11:00
Craig@3DR 0ed25cf719 Global change all references from
GPS_PROTOCOL_MTK16
to
GPS_PROTOCOL_MTK19
2013-01-02 09:24:31 +11:00
Andrew Tridgell feca411943 Plane: added new TRAINING mode
this mode gives manual control when the roll or pitch is within the
set limits (the same limits as FBW mode), and prevents the pilot from
flying beyond those limits, essentially a "attitude limited manual"
mode
2012-12-20 22:41:58 +11:00
Andrew Tridgell 3c0440b0b4 Math: use common degrees() and radians() functions 2012-12-20 14:53:22 +11:00
Andrew Tridgell a3e20324ac Plane: added CONFIG_INS_STUB 2012-12-20 14:52:32 +11:00
Pat Hickey f8dec9ae4a ArduPlane: fixes to use CONFIG_HAL_BOARD instead of CONFIG_APM_HARDWARE 2012-12-20 14:51:37 +11:00
Andrew Tridgell f5abc2c25e Plane: switch to an enum for flight modes 2012-12-01 08:08:54 +11:00
Andrew Tridgell 8f108e2eb3 APM: added AMP_OFFSET option
thanks to Alexey Kozin!
2012-11-21 13:34:27 +11:00
Andrew Tridgell a600ccece5 APM: support 16 character parameter names 2012-11-20 21:36:13 +11:00
rmackay9 ef727bbb3c ArduPlane: move to use new INS library instead of IMU library 2012-11-07 19:21:03 +09:00
Andrew Tridgell 63940d3ab6 APM: don't send GPS_STATUS MAVLink message
it now provides no useful information as satellites_visible is in
GPS_RAW_INT in MAVLink 1.0
2012-09-22 20:12:43 +10:00
Andrew Tridgell cebb67e1df APM: removed the unused sonar code
when we start supporting a sonar we'll add a AP_Sonar library, like
AP_Airspeed
2012-09-19 19:35:22 +10:00
Andrew Tridgell fce01464b1 APM: added ALT_CTRL_ALG parameter
this allows you to select different altitude control algorithms. The
current choices are for the default (automatic based on if airspeed is
available), or to force a non-airspeed algorithm

The idea is to make it possible to use airspeed for some things (like
wind speed, speed scaling) but not for alt control
2012-08-28 20:18:24 +10:00
uncrustify b960619195 uncrustify ArduPlane/defines.h 2012-08-21 18:59:05 -07:00
Andrew Tridgell c31eef59ae Mavlink: log wind estimation result 2012-08-11 22:06:03 +10:00
Andrew Tridgell b6a475f6a5 MAVLink: make APM build with MAVLink 1.0 possible with arduino GUI 2012-04-24 22:24:58 +10:00
Andrew Tridgell 8afd196907 APM: adapt ArduPlane for AHRS framework 2012-03-19 17:29:02 +11:00
Andrew Tridgell b455443e2c APM: added logging of DCM, HWSTATUS and SIMSTATE 2012-03-10 10:34:27 +11:00
Andrew Tridgell 16009777d9 APM: expanded parameter area to match ACM
this ensures waypoints and basic eeprom layout remain in sync
2012-02-18 10:51:57 +11:00
Andrew Tridgell 617082769a go back to 1024 bytes for variables in EEPROM 2012-02-13 16:22:52 +11:00
Andrew Tridgell e85da68fe6 expand parameter area for ArduPlane
this ensures all parameters can be saved without overflow
2012-02-13 16:22:52 +11:00
Doug Weibel 69c7598db2 Update battery monitoring code for ArduPlane
Fixes compatibility for APM2.  Also a significant update to the battery monitoring code:  We previously had monitoring modes for individual cell voltages for 3 and 4 cell lipos.  These have been removed as they were never really supported (the cell voltages were computed but were not reported or recorded anywhere).  Also, some clean-up/prep work was done for supporting monitoring 2 separate battery packs.  The CLI battery and current monitoring tests were consolidated into 1 test.
2012-01-15 16:10:28 -07:00
Andrew Tridgell 42522baf9f geofence: store fence points as int32_t
this keeps maximum precision in fence boundaries
2011-12-16 20:11:51 +11:00
Andrew Tridgell fc495ce6a7 geofence: added fence status reporting and faster altitude check 2011-12-16 20:11:51 +11:00
Andrew Tridgell 82b615df50 geofence: added geo-fencing control parameters 2011-12-16 20:11:51 +11:00
Pat Hickey 1b2ebdff44 ArduPlane: added config.h and defines.h to support CONFIG_BARO 2011-12-11 15:21:09 -08:00
Andrew Tridgell 86927ac0a5 ArduPlane: rename purple to APM2 2011-11-25 20:00:19 -08:00
Andrew Tridgell 40459653b5 purple: fixed LED and IO pin defintitions 2011-11-25 20:00:18 -08:00
Pat Hickey 3300032a89 purple: added hardware defines for ArduPlane 2011-11-25 20:00:17 -08:00
Doug Weibel 88f5669104 Remaining changes to the logging file system.
With these changes the logging system will allow overwriting of logs with no loss of functionality.  I have tested (successfully) logging with the Dataflash being filled and overwriting previous files.  I have also tested with a single long file that partially overwrites itself.
2011-11-17 21:25:51 -07:00
Doug Weibel cbf59e96bd Bug fixes for command logic re-write 2011-10-27 13:45:57 -06:00
Doug Weibel 645b9c1d48 Initial rewrite of command logic.
Changes mission structure so that conditional and immediate commands are located between associated waypoints instead of after the second waypoint.
2011-10-27 13:45:52 -06:00
Andrew Tridgell e2ed1f1c56 removed some more unused defines
mavlink is now the only choice for HIL and GCS
2011-09-19 11:04:02 +10:00
Andrew Tridgell 0f09bf6654 GCS: added new gcs_send_text_fmt() method
this allows low priorty formatted messages to be sent to the ground
station, without causing a CPU stall on the serial send buffer
2011-09-19 11:04:02 +10:00
Andrew Tridgell 55cd7bcf1d added gcs_severity enum
this makes it harder to mixup defines
2011-09-19 11:04:02 +10:00
Andrew Tridgell 73223ee458 remove Mavlink_Common.h and used deferred logic for params/waypoints
this moves the mavlink send logic into GCS_Mavlink.pde, and also
ensures we only ever send parameters and waypoints when there is
sufficient space in the serial send buffer
2011-09-19 11:04:02 +10:00
Andrew Tridgell 220b941e31 removed some more dead messages, and convert MSG_* to an enum
this make it safer to add a new message while keeping deferred queue
the right size
2011-09-19 11:04:02 +10:00
Andrew Tridgell 3f37cce6c7 remove unused MESSAGE_COMMAND_LIST 2011-09-19 11:04:02 +10:00
Andrew Tridgell 87ddd50c2a remove unsued MSG_LOCAL_LOCATION
this saves us a bit of code
2011-09-18 11:07:24 +10:00
Janne M b5cfbd10ae Added voltage divider, input voltage and amps per volt to parameters. 2011-09-17 22:32:19 +03:00
Amilcar Lucas f08cea8044 These changes were meant to be inside commit a14c06adc06b. I'm sorry but reverting stuff is not that easy 2011-09-13 01:54:47 +02:00
Amilcar Lucas 5406991831 Added support for routing any function to any of the aux. servos.
This is a manual merge from the APM_Camera branch.
It reverts the stuff that Oliver did not menat to do with his commit 6dcbc7f44bc0
2011-09-13 01:24:06 +02:00
Amilcar Lucas ce010b4e38 Moved update_aux_servo_function() to the RC_Channel_aux.* files.
This simplifies code sharing between ArduCopter and Arduplane at the expense of 48bytes.
Moved CH_x defines out of the defines.h file and into the library where they belong
2011-09-11 23:07:30 +02:00
Andrew Tridgell 0a793a1327 Revert "added support for AP_ADC MAVLink packet"
This reverts commit a65a2dda2c1bfa95437880227a3abddc95b329f5.

I am reverting this not for any sane reason, but because my 3 APM
boards now lock up on any I2C operation, and I don't know why. I can't
see how this change could have caused it, but I don't want to take the
chance.
2011-09-10 22:00:29 +02:00
Andrew Tridgell c65d038ccf added support for AP_ADC MAVLink packet
this adds AP_ADC, which sends raw ADC 16 bit values for all 6 ADC
channels at the Extra3 MAVLink stream rate. Extra3 was previously
unused
2011-09-10 14:18:15 +02:00
Amilcar Lucas b7a0d8836a This is the real HEAD of the APM_Camera branch. Seams that lots of changes got lost in the SVN to GIT port 2011-09-09 16:18:38 +02:00
Andrew Tridgell 609ae8359d import APM_Camera branch from SVN 2011-09-09 11:45:13 +10:00
Andrew Tridgell e0dc1271d6 imported ArduPlane from ArduPilotMega svn 2011-09-09 11:29:39 +10:00