Randy Mackay
4ebde25a26
AP_Relay: add -1:Disabled to list of param values
2014-05-15 17:13:37 +09:00
Randy Mackay
f7a9ee24ef
Copter: minor comment update
2014-05-15 16:21:35 +09:00
Randy Mackay
715e9c0474
Copter: reset mission when disarming
2014-05-15 16:21:32 +09:00
Randy Mackay
7d4c74c28e
Copter: when leaving AUTO only stop mission if running
...
This resolves an issue in which the mission would not automatically
start from the beginning if it had previously been run to completion
2014-05-15 16:21:30 +09:00
Randy Mackay
5d20594fa4
AC_WPNav: bug fix for loiter and waypoint update rate
...
Thanks to EmileC for spotting this
2014-05-12 20:13:46 +09:00
Andrew Tridgell
48919b6253
Rover: use EKF velocity for high rate ground_speed updates
...
this may give smoother throttle response when the EKF is enabled
2014-05-11 21:39:06 +10:00
Andrew Tridgell
85ebe81ed3
AP_NavEKF: fixed logic for divergence test
...
Pair-Programmed-With: Paul Riseborough <p_riseborough@live.com.au>
2014-05-11 18:00:38 +10:00
priseborough
40dc0e56fe
AP_NavEKF: Add protection for badly conditioned innovation variances
2014-05-11 18:00:38 +10:00
priseborough
925c5751bd
AP_NavEKF: Add ability to inhibit in-flight mag cal and clean up moding
...
This will enable in-flight magnetometer calibration to be inhibited unconditionally,
This is required for long balloon carriage flights where ground speed can be high
enough to put it into in-air state, but with very poor observability of magnetic field
states causing bad state estimates and heading offsets to develop over time.
The covariance matrix no longer has rows and columns artificially zeroed when in static
mode. Instead booleans indicating whether wind or magentic field state estimation is
active are used to:
a) Set the process noise on these states to zero to stop their variances from increasing
unchecked when not being updated, and
b) Turn off updates for these states when measurement fusion is being performed.
This reduces the likelihood of a badly conditioned covariance matrix forming
during static mode operation.
A filter divergence check has also been added that will declare the filter unhealthy if
position, velocity and magnetic field observations are all failing their innovation
consistency checks. This unhealthy status will persist for 10 seconds after the
condition clears.
AP_NavEKF: Remove unnecessary zeroing of wind covariances
2014-05-11 18:00:38 +10:00
priseborough
3026ccee13
AP_NavEKF: Use baro data during launch transients whilst in static mode
...
Baro data can be used as it will still be valid during the launch and
is not a synthesised measurement.
2014-05-11 18:00:38 +10:00
Randy Mackay
a38e00c048
Copter: remove unused HIGH, LOW definitions
...
Minor commit to kick off the auto build so AC3.2-rc1 will go out
2014-05-09 16:35:21 +09:00
Randy Mackay
3f329d0857
Copter: version to AC3.2-rc1
2014-05-09 13:48:47 +09:00
Randy Mackay
e75d6a2da6
Copter: remove meaningless check from motor_test
2014-05-09 13:48:44 +09:00
Randy Mackay
0c7a3f1ec5
Copter: remove unused Log_Write_GPS function
2014-05-09 13:48:41 +09:00
Randy Mackay
b4dcad725c
Copter: remove unused servo_write function
2014-05-09 13:48:38 +09:00
Randy Mackay
1e8b99ad17
Copter: update release notes for AC3.2-rc1
2014-05-09 13:48:35 +09:00
Randy Mackay
05f5164dfa
Mission: rename AUTORESET to RESTART
2014-05-09 11:31:37 +09:00
Andrew Tridgell
cc1b75ad29
autotest: restore timeout in log download
...
this removes the debug code now that the issue has been found (it was
an old version of pymavlink causing the problem)
2014-05-09 09:50:22 +10:00
Andrew Chapman
3f0a52cb53
Copter: ch7/8 switch for auto pause/continue
...
- added new mode for CH7/CH8 (#24 , auto mission reset)
- changed mission.start() to mission.start_or_resume() in auto_init()
2014-05-08 23:09:42 +09:00
Andrew Chapman
8640e11728
Copter: bug fix rally point landing target
...
was drifting toward home by some distance as (0,0,0) was hard-coded in
control_rtl.pde. Fixed, tested in SITL
2014-05-08 23:09:40 +09:00
Hug0
6b0d5f9770
AP_InertialNav: fix pos error degradation rate
...
degrate position_error to 10% over 2 seconds (assumes 5hz update rate)
must be *0.7943 instead of 0.7934
2014-05-08 23:09:39 +09:00
Andrew Tridgell
73dc32108f
autotest: try to debug log download timeouts
2014-05-08 17:38:49 +10:00
Randy Mackay
badc127c34
AC_WPNav: fix example sketch
2014-05-08 16:25:13 +09:00
Randy Mackay
9b6a4e0fc7
AC_Sprayer: fix example sketch
2014-05-08 16:25:11 +09:00
lthall
9ab9eaec25
AC_WPNav: Loiter jerk default to 10m/s/s/s
...
Pair programmed with Randy
2014-05-08 16:16:05 +09:00
Randy Mackay
197d83e32a
Copter: bug fix to sport roll pitch control
2014-05-08 16:16:02 +09:00
Randy Mackay
0af9d502d9
Copter: set pos controller speeds before circle init
...
This ensures stopping point is calculated correctly
2014-05-08 16:15:59 +09:00
Randy Mackay
1cb297580f
Copter: reduce Circle init twitch by using stopping point
2014-05-08 16:15:57 +09:00
Randy Mackay
3cc5b9446f
Copter: AUTO and Guided call wp_and_spline_init
2014-05-08 16:15:55 +09:00
Randy Mackay
11918869a5
Copter: RTL calls wp_and_spline_init
2014-05-08 16:15:52 +09:00
Randy Mackay
091ff91a70
WPNav: add wp_and_spline_init to set speeds an init pos controller
2014-05-08 16:15:50 +09:00
Randy Mackay
c13db680b7
AC_PosControl: remove reset_I_xy
...
lean_angles_to_accel is now used to load the position rate I terms based
on vehicle's initial roll and pitch angle
2014-05-08 16:15:48 +09:00
Randy Mackay
cd8b1f278c
AC_PosControl: remove unused _cos_yaw variable
...
Also removed _sin_yaw, _cos_pitch, _step saving a total of 17bytes of
RAM
Also made get_speed_up, get_speed_down, lean_angles_to_accel functions
const
2014-05-08 16:15:46 +09:00
Randy Mackay
48ec0caf75
AC_WPNav: run navigation at 10hz in SITL
2014-05-08 16:15:44 +09:00
Randy Mackay
0819e05896
AC_PosControl: lean_angles_to_accel added for smooth initialisation
...
init_xy_controller also added to capture initialisation all in one place
2014-05-08 16:15:41 +09:00
lthall
b38c484874
AC_WPNav: add LOIT_JERK parameter
...
Limit accel output from loiter controller.
Call new pos_control.init_xy_controller when loiter starts
Remove sudden stop when pilot requested acceleration is zero
Pair programmed with Randy
2014-05-08 16:15:38 +09:00
Randy Mackay
71fae1e6f2
AC_AttControl: lean_angle_max accessor fn const
2014-05-08 16:15:36 +09:00
Randy Mackay
ff1a58e078
Copter: increase LOITER_RATE_IMAX to 1000
...
This allows us to load up the I term with the vehicle's current
acceleration during mode transitions
pair programmed with Randy
2014-05-08 16:15:34 +09:00
Randy Mackay
fb2be07b44
Copter: update AC_WPNav instantiation
2014-05-08 16:15:29 +09:00
Randy Mackay
fd9f8f571f
AC_WPNav: replace inav, ahrs pointers with references
2014-05-08 16:15:26 +09:00
lthall
21c93e48ab
AC_PosControl: include vel error when get_stopping_point_z
...
Pair programmed with Randy
2014-05-08 16:15:24 +09:00
Randy Mackay
a1f1dd8059
AC_PosControl: add is_active_z method
...
Consolidated z-axis timeout checks to save 4bytes of RAM
Added POS_CONTROL_ACTIVE_TIMEOUT_MS to make timeout consistent
2014-05-08 16:15:22 +09:00
Andrew Tridgell
3909a9574b
AVR: fixed some build warnings with gcc 4.8.2
2014-05-08 15:15:55 +10:00
Andrew Tridgell
b6774b8bc7
autotest: raise the time for log download
2014-05-08 15:15:55 +10:00
Randy Mackay
10d7ab5840
Copter: update release notes for AC3.1.4
2014-05-08 11:58:37 +09:00
Andrew Tridgell
603e84a688
SITL: disable missing initializer warnings
...
not specifying all initializers is normal
2014-05-08 11:11:35 +10:00
Andrew Tridgell
74227cd7f0
AP_HAL: prevent some FastDelegate warnings
2014-05-08 11:11:03 +10:00
Andrew Tridgell
0991af86f3
Plane: removed some usused code
...
setting up flight modes by CLI is not used any more
2014-05-08 11:10:50 +10:00
Andrew Tridgell
a295760e56
AP_Rally: fixed indentation
...
previous indentation confused emacs24
2014-05-08 11:01:52 +10:00
Andrew Tridgell
3dc0404e2b
SITL: prevent unused parameter warnings
2014-05-08 11:01:32 +10:00