* uORB orb_stat() and update(uint64_t *time, void *dst) are now obsolete and have been deleted
* mavlink messages add more advertised checks in streams get_size() check to improve data rate calculation across different scenarios
Main UAVCAN protocol handling and ESC updates run on the same thread/wq as
before. There are 2 WorkItems for separate scheduling of the 2, so that
ESC updates run in sync with actuator_control updates. UAVCAN is scheduled
at a fixed rate of 3ms (previously the poll timeout) and on each UAVCAN
bus event.
This leads to roughly the same behavior as before. CPU & RAM usage are
pretty much the same (tested on Pixhawk 4).
Testing done: Motors still work (with feedback), param changes and a
UAVCAN optical flow sensor.
* VTOL trans: changed that now in transition for both MC and FW the corresponding (correct) attitude controller is running
* attitude setpoint for stabilized mode is generated by tailsitter.cpp
* reset yaw setpoint during transition to avoid big yaw errors after
transition back to hover
* VT_TYPE parameter: added "reboot required" metadata
* attitude and rate setpoint message: use 3D array for thrust demand
* FixedWingAttitudeControl: rework airspeed scaling
* move airspeed and scaling calculation into separate method
* if vtol in hover and airspeed disabled use minimum airspeed instead of trim airspeed
Daniel Agar
Julian Oes
Christian Clauss
LP
Beat Küng
Matthias Grob
Roman Bapst
Alexis Paques
Jake Dahl