- reduces amount of board configuration required
- removes the cyclic dependency between io_timers_t and timer_io_channels_t
Fixes a bug in the fmuk66-v3 config: the 2. timer has 3 channels associated
not 2.
Fixes a bug in the modelai config: the 2. timer has 4 channels associated.
Channels belonging to a certain timer were not all grouped together.
This is required by the .first_channel_index and .last_channel_index data
members.
We introduce a new mixer geometry to solve the problem.
- nuttx in PX4/Firmware (4b356c91f2be41dfdadb38270fab01ddb337d3c7): 7b36108b54
- nuttx current upstream: fdf1837077
- Changes: 7b36108b54...fdf1837077
fdf1837077 2020-02-07 Peter van der Perk - [BACKPORT] S32K add support for Nxp drone boards (#224)
f479b26c98 2020-02-07 Peter van der Perk - [BACKPORT] imxrt added missing i2c prescale mask
26dd187034 2020-02-07 Peter van der Perk - [BACKPORT] Kinetis renamed TJA1100 to TJA110X registers
I don't think we're quite ready for codecov reporting on every PR. The initial report seems to work fine, but there are various issues that result in bogus reporting when additional commits are added or after a rebase.
Use yawrate setpoint from weather vane only if velocity setpoint is small
(smaller than half the cruise velocity)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- remove gloabl variable and instead give back forward_thrust from function
- give back increased vertical thrust from fct thrust_compensation_for_tilt()
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
-move pusher assist functionality into vtol_type class and adapt it to also
work for tiltrotor VTOLs (pitch rotors down to accelerate forward)
-for tiltrotor: compensate for lost lift due to tilt by increasing the throttle
-enable pusher / tiltassist also in altitude mode
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This is done to test the recovery function of the estimator in case
of divergence or sudden extreme hover thrust change.
Also specify seed of random generator
with measurement noise auto-tuning
The purpose of this estimator is to improve land detection and vertical
velocity feedforward
Recovery strategy:
This is required when the setpoint suddenly changes in air or that the
EKF is diverging. A lowpassed test ratio is used as a trigger for the recovery logic
Also, a lowpassed residual is used to estimate the steady-state value
and remove it when estimating the accel noise to avoid increasing the
accel noise when the redisual is caused by an offset.
Beat Küng
bresch
David Sidrane
Daniel Agar
stmoon
PX4 BuildBot
Silvan Fuhrer
CarlOlsson