Randy Mackay
65adb78f31
Copter: increase default battery capacity to 3500mAh
2013-09-15 11:54:07 +09:00
Randy Mackay
0232b25f6e
Copter: update LED_MODE bitmask @values to always enable leds
2013-09-15 11:38:47 +09:00
Randy Mackay
b4b2128977
Copter: update @Range comments for THR_MIN
...
This should help reduce change of someone setting THR_MIN above 300 (30%
throttle)
2013-09-12 22:45:18 +09:00
Andrew Tridgell
adc923b989
Copter: update battery pin docs
2013-09-12 13:43:15 +10:00
Andrew Tridgell
4545445850
Copter: fixed SR0 and SR3 autodocs
2013-09-12 09:53:13 +10:00
Craig3DRobotics
630095adaa
Revert "Copter: Corrected SR0 & SR3 parameter descriptions"
...
This reverts commit 6568234018
2013-09-06 09:58:19 -07:00
Craig3DRobotics
f1a674ad26
Copter: Correction on SR0 & SR3 parameter description.
2013-09-05 22:28:34 -07:00
Andrew Tridgell
52f5b1e5a7
Copter: update to GPLv3 license headers
2013-08-30 13:01:39 +10:00
Craig3DRobotics
6568234018
Copter: Corrected SR0 & SR3 parameter descriptions
2013-08-29 12:19:04 -07:00
Randy Mackay
fd047cc968
Copter: AUTO ch7/ch8 option
2013-08-19 18:09:23 +09:00
Randy Mackay
3a5a15a15f
Copter: allow CH6 tuning of sonar gain
2013-08-18 15:44:54 +09:00
Randy Mackay
d000967a76
Copter: pre-arm check for gps hdop < 2
2013-08-15 13:06:36 +09:00
Randy Mackay
6969ab573d
Copter: configurable max lean angle
...
ANGLE_MAX parameter allows limiting the roll and pitch angles during
manual and auto flight modes to anywhere from 10 to 80 degrees
2013-08-11 12:53:22 +09:00
Randy Mackay
74fb500efe
Copter: integrate AC_Sprayer
2013-08-05 21:12:23 +09:00
Randy Mackay
49dbdce89c
Copter: split ACRO_P into ACRO_RP_P and ACRO_YAW_P
2013-08-05 21:05:00 +09:00
Randy Mackay
82082e044c
Copter: remove ACRO's axis enabled parameter
...
Acro is now body frame (with earth frame leveling) while Sport is earth
frame acro
2013-08-05 21:04:57 +09:00
Randy Mackay
786d6824ae
Copter: Acro Trainer added to Ch7/Ch8 switch
2013-08-05 21:04:55 +09:00
Randy Mackay
21e523b9ac
Copter: Acro trainer separated into limited and leveled
2013-08-05 21:04:53 +09:00
Randy Mackay
39ab4f62ef
Copter: add SPORT mode
2013-08-05 21:04:41 +09:00
Randy Mackay
2c48c20088
Copter: generalize 3 pos switch for all ch7/ch8 options
2013-07-29 16:28:04 +09:00
Olivier-ADLER
87d062905e
Copter: 3 positions switch support for CH7 and CH8 - new 3 positions SIMPLE / SUPERSIMPLE mode
...
3 positions modes must use mode number >= 100
pre-arm check correction for CH7 - CH8 check
2013-07-29 15:12:10 +09:00
Randy Mackay
11e7e9eaf1
Copter: WP_YAW_BEHAVIOUR param update for Look Ahead
2013-07-20 15:46:19 +09:00
Randy Mackay
c937fe45e1
Revert "Copter: Remove CH7 & CH8 Enable / Disable of GeoFence"
...
This reverts commit e25b8933f3
2013-07-20 15:00:08 +09:00
Craig3DR
e25b8933f3
Copter: Remove CH7 & CH8 Enable / Disable of GeoFence
2013-07-18 17:06:53 +09:00
Andrew Tridgell
0b27bb05d4
Copter: fixed FENCE and WPNAV parameter doc generation
2013-07-18 14:58:24 +10:00
Randy Mackay
aefb38e486
Copter: remove param to disable accel based throttle controller
2013-07-12 22:57:30 +09:00
Randy Mackay
2f4221391e
Copter: set_dead_zone renamed to set_default_dead_zone
...
Dead zones now set as part of rc initialisation instead of only after
eeprom is erased.
Change in use of parameter means value passed in should be 1/2 what it
was previously
2013-07-12 11:44:23 +09:00
Randy Mackay
404cd5f3da
Copter: rename g.pid_throttle to g.pid_throttle_rate
...
Small code clean-up to make throttle rate controller's pid more obvious
2013-06-30 00:04:21 -10:00
Randy Mackay
b3da8a462f
Copter: CH6 tuning definition clean-up
...
Renamed and reorganised the CH6 #defines and parameter definitions
2013-06-29 23:51:43 -10:00
Robert Gayle
917edcab11
Copter: added FS_THR_ENABLED_ALWAYS_LAND (=3) option: don't attempt RTL, just land
2013-06-27 10:19:38 -10:00
Andrew Tridgell
23eade8f74
Copter: enable RELAY_* parameters
2013-06-25 12:46:53 +10:00
Randy Mackay
a48a7f9775
Copter: minor param definition unit changes
2013-06-23 15:52:46 +09:00
Randy Mackay
acb4907313
Copter: update FS_THR_VALUE parameter description
...
One user was setting FS_THR_VALUE too low, below 900 which means
ArduCopter would not trigger when the ppmencoder pulled ch3 low after
updates from the ppmencoder stopped
2013-06-18 15:56:39 +09:00
Randy Mackay
c42ed1e5eb
Copter: add @Increment to PID parameters descriptions
2013-06-16 21:53:50 +09:00
Andrew Tridgell
3ec381094e
Copter: fix VOLT_DIVIDER docs
2013-06-07 08:40:37 +10:00
Andrew Tridgell
8703d39475
Copter: the INS object is needed for HIL_MODE_SENSORS
...
otherwise we can't level, so can't arm
2013-06-04 18:09:06 +10:00
Randy Mackay
213eaa8db6
Copter: integrate draft RCMapper
2013-06-03 16:23:47 +10:00
Andrew Tridgell
2488c4fdc3
Copter: update docs on volt/current pin
2013-05-31 07:57:15 +10:00
Andrew Tridgell
0e31a2f582
Copter: fixed indent-tabs-mode
2013-05-30 09:55:51 +10:00
Randy Mackay
967aa81e9b
Copter: add XL-EZ4 to SONAR_TYPE parameter description
2013-05-23 09:46:57 +09:00
Randy Mackay
c404c46e5a
Copter: add Fence to CH7/CH8 param description
2013-05-21 16:31:16 +09:00
Andrew Tridgell
4508e645f1
Copter: fixed parameters to pass new script
2013-05-21 17:02:13 +10:00
Randy Mackay
bb3073fab1
Copter: minor parameter description fixes
2013-05-21 15:56:09 +09:00
Randy Mackay
5ee68db6f0
TradHeli: add parameter descriptions
...
small formatting changes too
2013-05-21 15:33:41 +09:00
Randy Mackay
9139fb54ac
Copter: param update for AP_Baro and AP_Scheduler
2013-05-21 14:22:11 +09:00
Dr Gareth Owen
e9d640ced8
added ch7 option to reset yaw back to what it was when quad was armed
2013-05-21 10:40:30 +09:00
Randy Mackay
db552adf02
Copter: typo in LOG_BITMASK param description
2013-05-21 10:30:59 +09:00
Randy Mackay
669850e6d4
Copter: add parameter description for LOG_BITMASK
...
Should allow a dropdown in the GCS so it can be set more easily without
going into the cli
2013-05-21 10:29:40 +09:00
Randy Mackay
bd44c2f73d
Copter: all pre-arm checks to be disabled
...
set ARMING_CHECK parameter to zero to disable
2013-05-20 14:48:04 +09:00
Randy Mackay
9fdab5e8fe
Copter: remove unused AUTO_SLEW_RATE parameter
2013-05-17 16:09:17 +09:00
