Dario Lindo Andres
7f5243026d
Plane: Cleanup code to remove 1280 ifdefs
...
Due to the imposibility to fit actual code on Legacies 1280 chips, some
cleanup is needed.
2015-01-22 16:12:26 +11:00
Dario Lindo Andres
0ea7a7a0cc
Plane: Corrected LOGGING_ENABLED
...
When we configure LOGGING_ENABLED to DISABLED code does not
compile. Now it works!
2015-01-17 10:42:11 +13:00
Andrew Tridgell
ca431a47a6
Plane: use all_healthy() for SYS_STATUS health
2015-01-09 11:51:51 +11:00
Andrew Tridgell
a2242305c7
Plane: use common send_opticalflow()
2015-01-03 15:53:35 +11:00
Andrew Tridgell
28f58df310
Plane: send HAGL in OPTICAL_FLOW
2015-01-03 15:44:50 +11:00
Andrew Tridgell
80d1bd230e
Plane: report bad AHRS health if uncalibrated accels with EKF
...
fixes issue #1720
2015-01-03 14:06:46 +11:00
Andrew Tridgell
ae96a48efc
Plane: use location_path_proportion()
...
this should produce better glide slopes when the aircraft is off
course
2015-01-01 15:17:45 +11:00
Randy Mackay
5cdb8a4c2a
Plane: use battery.has_current
2014-12-31 15:22:54 +09:00
Andrew Tridgell
12f0c49915
Plane: remove fwd of unknown msg types
2014-12-11 12:32:52 +09:00
Andrew Tridgell
507117bd8f
Plane: removed use of mavlink_check_target()
2014-12-11 12:31:15 +09:00
Randy Mackay
f4fc910fea
Plane: send OPTICAL_FLOW msg to GCS
2014-12-08 14:58:32 +09:00
Randy Mackay
2b9bf69c9e
Plane: send optflow health in extended status
2014-12-08 14:58:29 +09:00
Andrew Tridgell
c05a0bc67f
Plane: prevent a change altitude command from causing a sudden descent
...
when a change altitude command comes in while a large glide slope
altitude change is present we could end up using the old glide slope
with the new altitude. This resets the altitude offset, causing a
direct altitude change
2014-12-03 18:31:23 +11:00
Andrew Tridgell
b4e01b7936
Plane: if SKIP_GYRO_CAL is set the do a gyro cal on 3D accel cal
...
otherwise the user has no opportunity to do a gyro calibration
2014-11-21 19:09:19 +11:00
Andrew Tridgell
c33f54378f
Plane: changed preflight calibration to prevent accel cal from MP
...
MissionPlanner sends param1=1 and param3=1 for preflight
calibration. This was having the effect of redoing the accel
calibration as 1D cal on every flight!
2014-11-21 14:46:42 +11:00
Randy Mackay
c74aff56c1
Plane: move MOUNT_STATUS lower in GCS_MAVLink
2014-11-17 15:59:44 -08:00
Arthur Benemann
9ae443f2a2
Plane: append MOUNT_STATUS message to STREAM_EXTRA3 messages
2014-11-17 15:59:31 -08:00
Andrew Tridgell
8bcbce16ed
GCS_MAVLink: show rangefinder status in SYS_STATUS
2014-11-14 15:34:36 +11:00
Andrew Tridgell
7f5cc97769
Plane: changed for new AP_Airspeed API
2014-11-13 21:12:59 +11:00
Arthur Benemann
5e2d7b1eaa
Plane: Implement MSG_CAMERA_FEEDBACK on planes
2014-11-11 10:31:58 -08:00
Arthur Benemann
92ead67d99
Copter: remove call to camera.configure and control
...
The do_take_picture() function must be called for logging to occur.
configure_msg is empty at the moment so the call to this is remove
2014-11-11 10:31:52 -08:00
Andrew Tridgell
e4f7a7f6d2
Plane: removed incomplete DF log of go-around
...
the right commands should already be logged. This code would have
logged a lot of uninitialised bytes
2014-10-24 22:09:41 +11:00
Michael Day
01f611daa9
Plane: "Go around" operation. Assumes go around behavior follows land wp.
2014-10-24 21:51:46 +11:00
Michael Day
c1b949a74f
Plane: Bugfix. Changing to landing sequence now works at mission end.
2014-10-24 21:42:06 +11:00
Andrew Tridgell
9f32bf93d1
Plane: switch to AUTO on a DO_LAND_START MAVLink command
2014-10-20 08:36:20 +11:00
Michael Day
fe43ae538f
Plane: Added support for MAV_CMD_DO_LAND_START
2014-10-20 08:36:19 +11:00
Randy Mackay
6d8e760582
Plane: report gyro unhealthy if failed calibration
2014-10-09 10:00:17 +09:00
Randy Mackay
b17c6d3368
Plane: only report ahrs unhealthy after initialisation
2014-10-02 14:41:28 +09:00
Andrew Tridgell
c4b17b74e2
Plane: use handle_set_mode()
2014-10-01 14:19:20 +10:00
Randy Mackay
82225de6fa
Plane: allow GCS to turn safety switch on/off
2014-10-01 13:11:50 +10:00
Randy Mackay
7a6b55368e
Plane: set sys_status motor outputs bit from safety switch
2014-10-01 13:09:58 +10:00
Randy Mackay
6d3acba04c
Plane: check target of set-mode request from GCS
...
Issue discovered and fix contributed by Deadolous
2014-09-30 15:19:25 +10:00
Andrew Tridgell
4b01cee330
Plane: send heartbeat to AFS when calibrating sensors
2014-09-24 12:02:39 +10:00
Randy Mackay
c2cdc0468b
Plane: individual accel and gyro status to GCS
2014-09-03 11:22:53 +09:00
Andrew Tridgell
b6319a9d19
Plane: keep an estimate of the rangefinder altitude
...
only accept data when we have had 10 samples in a row in range at 50Hz
2014-08-27 17:14:19 +10:00
Randy Mackay
c107f1da69
Revert "Plane: use rcmap when sending radio_in to GCS"
...
This reverts commit 441f23eed4
2014-08-16 20:31:21 +09:00
Randy Mackay
441f23eed4
Plane: use rcmap when sending radio_in to GCS
2014-08-16 15:27:35 +09:00
Randy Mackay
7d7272520e
Plane: use baro healthy()
...
Use baro last update time in place of healthy to determine whether HIL
sensor updates have started
2014-08-14 16:03:28 +09:00
Randy Mackay
b619c3956c
Plane: report baro health to GCS
2014-08-14 16:02:52 +09:00
Andrew Tridgell
ce9b14f0c8
Plane: convert to using StorageManager
2014-08-13 18:46:44 +10:00
Andrew Tridgell
817164914e
Plane: added airspeed simulation in HIL
2014-08-10 18:17:12 +10:00
Andrew Tridgell
0d7d6e1d2a
Plane: zero loc structure in HIL_STATE handling
...
this avoids av AVR bug in HIL
2014-08-09 22:50:15 +10:00
Andrew Tridgell
74fc7fbea5
Plane: added 2nd battery monitoring support
2014-08-09 22:50:14 +10:00
Przemek Lekston
75f9b8853d
GCS_Mavlink.pde: Fix for a possible segfault after passing ARSPD_FBW_MIN
2014-08-07 12:35:31 +10:00
Andrew Tridgell
d54bb68270
Plane: prevent cross-track on some WP types
...
when finishing a takeoff or when a user forces a WP change don't do
any cross-tracking. This avoids a problem where the plane tries to
line up with a track completely unrelated to the track currently being
flown
2014-08-04 21:02:13 +10:00
Andrew Tridgell
b64ab07ca4
Plane: added STAB_PITCH_DN_CD parameter
...
this adds some down trim when at throttle levels below the trim
throttle in FBWA mode.
defaults to 200 centi-degrees. I may adjust based on flight tests
2014-08-03 17:17:20 +10:00
Andrew Tridgell
fe3c51d516
Plane: prevent integer underflow with comm_get_txspace()
2014-07-27 22:12:08 +10:00
Andrew Tridgell
077177384d
Plane: fixed guided alt without terrain bit
2014-07-25 10:31:45 +10:00
Andrew Tridgell
b158b7e5a9
Plane: replace HAVE_AP_TERRAIN with AP_TERRAIN_AVAILABLE
2014-07-25 07:59:54 +10:00
Andrew Tridgell
07583a0604
Plane: added terrain status reporting
2014-07-24 21:50:19 +10:00
