Andrew Tridgell
547b4ed55b
AHRS: adapt ArduCopter for new AHRS framework
2012-03-19 17:29:02 +11:00
Jason Short
c5344a2a85
ACM: Arducopter.pde - Added a constraint to the NO_NAV mode to be similar to the Loiter and rate nav modes.
2012-03-18 22:31:22 -07:00
rmackay9
9841cb0335
ArduCopter - small change to ensure both roll and pitch commands are zero before switching out of loiter_override (loiter override becomes true when roll+pitch command is greater than 5 degrees and switches back to false when both become zero)
...
- remove incorrect comments about when loiter target position is reset.
2012-03-18 15:16:04 +09:00
Jason Short
48a0c9a818
ACM: Small fix to nav_throttle to prevent too fast of a landing.
2012-03-16 14:10:19 -07:00
Jason Short
1c0b28c956
Fixed Scaling bug in Sonar mixing
2012-03-16 14:10:19 -07:00
analoguedevices
86eff20d5d
Rev'ed version number to 2.5. Added more credits
2012-03-15 02:38:54 +00:00
Jason Short
6f8b97bf6a
ACM: Added constraints for invalid climb rates. Robert Lefebvre had a bad sonar and very invalid rates crept into the system.
2012-03-13 21:31:16 -07:00
Jason Short
4315c06f34
Lowering the D filter for less latency and less oscillation.
2012-03-13 12:58:46 -07:00
Jason Short
7953808d14
ACM: Larger filter for Loiter D
2012-03-13 10:23:30 -07:00
Jason Short
0ab6b6e592
ACM: Rate_d filter for PID loop of Loiter.
2012-03-11 23:21:49 -07:00
Jason Short
77fe7de55d
ACM: The I term in update_nav_wp with the no_nav condition was pulling from the wrong PID loop and was essentially 0 all the time.
2012-03-11 23:21:49 -07:00
Andrew Tridgell
2a03a0584f
AP_Declination: disable library when AUTOMATIC_DECLINATION is not ENABLED
...
unfortunately this library was causing avrdude to fail to load the hex
to my APM2. Until we work out why, it's disabled.
2012-03-11 21:46:41 +11:00
Adam M Rivera
d3667faef4
AP_Declination: Added call to compass.set_initial_location if the compass is enabled when the 3D fix is obtained.
...
Signed-off-by: Andrew Tridgell <tridge@samba.org>
2012-03-11 20:59:47 +11:00
Jason Short
62c2aa4924
ACM: Added Loiter D tuning
2012-03-10 14:17:57 -08:00
Jason Short
0671bb9168
ACM: Firmware rev
2012-03-10 12:45:03 -08:00
Jason Short
29d6085bab
added Force_new_altitude call for alt hold
2012-03-10 12:37:54 -08:00
Jason Short
4ba600c0c5
upped throttle manual boost to 225
2012-03-10 12:37:28 -08:00
Andrew Tridgell
ef771fecdc
ACM: removed a lot of the special case code for quaternions
2012-03-10 10:34:31 +11:00
Andrew Tridgell
69c29d35ce
ACM: change DCM loop to 100Hz
...
On my APM2 quad this seems to give better results
2012-03-10 10:34:31 +11:00
Andrew Tridgell
7e4c8592ff
ACM: make it possible to build ArduCopter with quaternions
2012-03-10 10:34:29 +11:00
Andrew Tridgell
9bff4e2c4c
ACM: only call the fast loop if the imu has new data
...
this prevents us spinning waiting for the sensors to gather some data
2012-03-10 10:34:29 +11:00
Jason Short
486c56ce41
Consolidated Barometer pressure sensing to a single filter based on Randy's new filter class.
2012-03-08 23:13:04 -08:00
Jason Short
730476fdfd
ACM -
...
Implemented automatic ranging of Alt Hold gains. Works well in simulator and testing.
- alt hold estimation moved to 50 hz
- simple fixed observer calc for smooth and accurate climb rates useful for derivative calcs
- auto-reset of the I term by moving I value into throttle value. This recalcs the gain every 20seconds for battery drainage compensation in long flights.
- remove filtering for Nav_throttle
- added a way to lower the gain on nav_throttle for descents by / climb_rate error by 2 - seems to work OK and keeps copter from dropping like a rock when the Baro drifts quickly lower.
- removed old throttle hold set point code
- made throttle override for alt hold +- 200 vs 250
2012-03-06 22:22:14 -08:00
Jason Short
46d7da4d14
Added define for throttle range for altitude changes, updated it to 250
2012-03-05 22:12:53 -08:00
Jason Short
ceef8070ac
added stab_d gain scheduling
2012-02-28 20:16:40 -08:00
Robert Lefebvre
76c3cd88f0
Added heli_collectiveFactor array
...
Signed-off-by: Robert Lefebvre <robert.lefebvre@gmail.com>
2012-02-28 10:49:28 -05:00
rmackay9
744e5b8c60
ArduCopter - made rate controller filters globals to fix compiler error on Arduino 022 (Arduino 1.0 was fine)
2012-02-28 22:56:26 +09:00
rmackay9
17d94b61ed
ArduCopter - modified to work with new Filter library
2012-02-28 21:02:44 +09:00
Jason Short
517172ba20
Added Loiter Rate Tuning
2012-02-26 11:33:37 -08:00
rmackay9
8193c786ef
ArduCopter - added #include <Filter.h> to unbreak the build!
2012-02-26 17:05:41 +09:00
rmackay9
69132e0fe7
ArduCopter - change sonar to use new mode filter from Filter library
2012-02-26 15:35:14 +09:00
Jason Short
a924c3685e
Based on Jani's latest logs I've made two tweaks to alt hold.
...
The first is to remove the filter on the throttle output for alt_hold.
The second was to open up the constraint on climb rate. This is to deal with larger than expected disturbances causing altitude changes.
2012-02-25 13:31:21 -08:00
Andrew Tridgell
e2bbc795ad
ACM: use a NULL gps pointer in DCM init
...
current DCM API does need a GPS reference passed in, but it can be
NULL
2012-02-25 15:08:49 +11:00
Andrew Tridgell
698749dd92
ACM: don't pass a gps pointer to DCM
...
after discussion with Randy, we don't want ArduCopter to fall back to
GPS for yaw when the compass becomes unhealthy. So we shouldn't pass
the gps object to the DCM code at all.
2012-02-25 14:51:08 +11:00
Andrew Tridgell
1cd3172954
ACM: ensure update_trig() doesn't cause NAN values for cos_roll/cos_pitch
...
the DCM matrix could have a value over 1.0 for c.x due to rounding
errors
2012-02-24 11:52:55 +11:00
Jason Short
242f54793c
revved a version
2012-02-22 09:00:42 -08:00
Jason Short
729c824809
made timer unsigned
2012-02-21 21:49:03 -08:00
Jason Short
30efbae0e9
removed old comments
2012-02-19 14:21:27 -08:00
Jason Short
cae49b3543
Added "slow WP" option for RTL.
2012-02-19 13:11:59 -08:00
Jason Short
b54d08f410
Updated manual throttle control during throttle hold
2012-02-19 12:40:51 -08:00
Randy Mackay
e146f225b1
ArduCopter - remove unnecessary block for next GPS value before saving home location
2012-02-19 15:38:40 +09:00
Jason Short
028de5d2c5
Axis lock beta (off by default)
2012-02-18 21:16:19 -08:00
Randy Mackay
b64c0da003
ArduCopter - updated version to 2.4
2012-02-18 18:44:29 +09:00
Jason Short
b532cb91b1
added Rate_D tuning value
2012-02-17 15:23:59 -08:00
Jason Short
0075901f77
upped rate loop to 250hz
2012-02-17 15:23:59 -08:00
Jason Short
36a120d8df
removed some unused vars,
...
formatting, made loop speed same as PIDT1 to eliminate variable.
2012-02-16 22:09:21 -08:00
Jason Short
e8b6f5ecee
allow auto-land if failsafe is triggered
2012-02-15 10:53:54 -08:00
Jason Short
e249c8466d
AP slew rate
2012-02-15 09:10:15 -08:00
Jason Short
05abe44f32
Added range setting via a parameter for CH6 tuning
2012-02-15 09:10:14 -08:00
Jason Short
c9b432955d
removed unused Vars
2012-02-13 15:25:23 -08:00
