Andrew Tridgell
af4f0c29ba
Copter: enable TMODE (ToyMode) support
...
this is for the skyviper button based transmitter control
2018-02-08 17:36:33 +11:00
Andrew Tridgell
15166eff2e
Copter: enable temperature calibration library
2018-02-08 17:36:33 +11:00
Andrew Tridgell
89674482a7
Copter: added FLTMODE_CH parameter
...
this allows for the flight mode to be on any RC channel, or no channel
at all to disable RC flight modes
2018-01-27 12:01:35 +09:00
Pierre Kancir
cfc69214e6
Copter: add LAND_ALT_LOW parameter
2018-01-24 21:14:35 +09:00
Randy Mackay
8d6f8e4d9c
Copter: move pos-control pids to pos-control library
2018-01-23 12:00:43 +09:00
Randy Mackay
6546ccbb3f
Copter: velocity pi moved to position control library
2018-01-23 12:00:43 +09:00
Peter Barker
996115c0d3
Copter: eliminate MAIN_LOOP_SECONDS macro
2018-01-20 15:35:58 +11:00
ChrisBird
caaeae3d0a
Copter: Separate max ascent and descent speeds
...
Added equivalent parameters to WPNAV_SPEED_UP and WPNAV_SPEED_DN
New parameters named:
PILOT_SPEED_UP (technically renamed PILOT_VELZ_MAX)
PILOT_SPEED_DN
Removed parameter PILOT_VELZ_MAX (technically renamed to PILOT_SPEED_UP).
Flight Modes impacted:
ALTHOLD
AUTOTUNE
CIRCLE
LOITER
POSHOLD
SPORT
TAKEOFF
Update a section in GUIDED mode but I don't think it is ever used but update just in case.
It will use the PILOT_SPEED_UP for ascending max velocity. For down it will check if
it is 0, if so then it will PILOT_SPEED_UP instead, if non zero it will use PILOT_SPEED_DN.
This retains current behavior and gives the flexibility to change it if desired.
2017-11-09 09:03:54 +09:00
Randy Mackay
787954fa37
Copter: integrate winch library
...
fixes after peer review:
rename winch-disable to winch-relaxed
add DO_WINCH to do-verify
winch release-length accepts rate
2017-10-27 09:20:38 +09:00
squilter
4b57a4a231
Copter: rename SafeRTL to SmartRTL
2017-09-09 14:05:41 +09:00
squilter
ba0e08552f
Copter: add SafeRTL flight mode
2017-09-09 14:05:41 +09:00
Peter Barker
c6b9c84d1f
Copter: remove CLI
2017-08-14 10:23:50 +09:00
Eugene Shamaev
24c390ade0
ArduCopter: move of CAN parameters into separate group
2017-07-03 11:44:32 +01:00
Randy Mackay
713c08672f
Copter: integrate AP_VisualOdom
2017-04-19 11:04:40 +09:00
Peter Barker
bd6ffc025e
Copter: start conversion to AP_Arming_Copter
2017-01-17 11:45:08 +09:00
Andrew Tridgell
5a87ae3f01
Copter: use new SRV_Channels API
2017-01-12 17:39:37 +11:00
Randy Mackay
e32ddaa7fa
Copter: reorder beacon and proximity declaration
...
resolves compiler warning
2017-01-04 19:58:53 +09:00
Randy Mackay
12d024e0c6
Copter: rename FRAME to FRAME_TYPE
...
This unifies the plane and copter parameter names
2016-12-31 10:55:23 +09:00
Randy Mackay
0ac00dbfd6
Copter: add FRAME_CLASS parameter
2016-12-31 10:55:23 +09:00
Andrew Tridgell
c3b9dbf5c8
ArduCopter: Add EKF3 and remove EKF1
2016-12-19 08:07:09 +11:00
Randy Mackay
21c7ea1df7
Copter: integrate AP_Beacon
2016-11-30 17:56:55 +09:00
Peter Barker
236b8ab6b7
Copter: make EPM a subclass of AP_Gripper_Backend
2016-11-05 10:20:39 +09:00
Peter Barker
920868145c
Copter: support for AP_Gripper
2016-11-05 10:20:33 +09:00
Peter Barker
df07cb525a
Copter: use AP_Stats to store statistics about vehicle
2016-10-29 14:53:25 +09:00
Mathieu OTHACEHE
152edf7189
Global: remove mode line from headers
...
Using a global .dir-locals.el file is a better alternative than
reincluding the same emacs header in every file of the project.
2016-10-24 09:42:01 -02:00
Andrew Tridgell
5a9276a5c4
Copter: added SYSID_ENFORCE parameter
...
allows enforcement of SYSID_MYGCS
2016-10-15 17:14:19 +11:00
Leonard Hall
5c47f3f9e5
Copter: add acro throttle and yaw expo and smoother manual pilot throttle
2016-10-15 11:27:53 +09:00
Randy Mackay
0aab175051
Copter: move proximity to g2
2016-10-14 14:02:29 +09:00
Randy Mackay
fcc2a1b378
Copter: integrate AP_Proximity into main vehicle
2016-10-13 20:21:07 +09:00
Andrew Tridgell
d0dd10aeea
Copter: added DEV_OPTIONS parameter
...
this is for little used options to allow standard firmware builds to
enable those options for development purposes
First option is for MAVLink based ADSB avoidance
2016-09-12 16:24:34 +10:00
Andrew Tridgell
f18e0dadc9
Copter: added optional AdvancedFailsafe for copter and heli
2016-08-25 14:14:18 +10:00
Andrew Tridgell
89c10a2db9
Copter: rename WP_TKOFF_NAV_ALT to WP_NAVALT_MIN
...
this is in preparation for using the same parameter for landing as
well
2016-08-16 11:26:56 +10:00
Randy Mackay
9842840346
Copter: GND_EFFECT_COMP parameter to enable ground effect compensation
2016-08-09 13:31:36 +09:00
chambana
25940c8e0f
Copter: add THROW_TYPE and allow dropping vehicle to trigger motors
2016-08-02 20:25:52 +09:00
Randy Mackay
f0f87a2f0c
Copter: add throw_nextmode
...
vehicle switches to mode specified in THROW_NEXTMODE parameter after the
throw is completed.
2016-08-02 20:25:52 +09:00
Randy Mackay
d50987f976
Copter: avoidance_adsb implements copter avoidance using ADSB
2016-07-25 20:24:37 +09:00
Andrew Tridgell
cb5ca713a9
Copter: added AP_Button support
2016-07-22 15:01:20 +10:00
Andrew Tridgell
3a8ed06267
Copter: added TKOFF_NAV_ALT parameter
...
this adds TKOFF_NAV_ALT which controls the altitude above takeoff that
navigation can begin. It is meant for unstable vehicles such as helis
to prevent blade strike during initial takeoff.
This also adds a new parameter class ParametersG2 which can hold 64
parameters. This is to avoid running out of parameters in the first
256 block
2016-07-07 14:21:47 +09:00
Daniel Ricketts
87be8daf0e
Copter: integrate AC_Avoidance library
2016-06-22 11:38:15 +09:00
Leonard Hall
48eb4cf674
Copter: remove THR_MID
2016-06-18 11:55:49 +09:00
Leonard Hall
dec9323127
Copter: remove THR_MIN
...
Equivalent is AP_Motors SPIN_MIN
2016-06-18 11:55:49 +09:00
Andrew Tridgell
045e3c179a
Copter: moved EKF2 to a new parameter index
...
the meanings of many of the parameters have changed. Best to use a new
index to prevent old parameters from causing crashes
2016-05-25 19:35:17 +10:00
Randy Mackay
7689315ba2
Copter: rename sonar to rangefinder
2016-05-21 10:36:53 +09:00
Randy Mackay
74e02d2c82
Copter: rename TERRAIN_USE to TERRAIN_FOLLOW
...
This matches plane's parameter name
2016-04-30 10:33:01 +09:00
Randy Mackay
91f6c7b503
Copter: add TERRAIN_USE parameter
...
Also add terrain.cpp to hold terrain_update and terrain_logging functions
2016-04-30 10:33:01 +09:00
Randy Mackay
bde498375c
Copter: remove attitude PIDs
...
These are now part of AC_AttitudeControl
2016-04-01 11:59:30 +09:00
Randy Mackay
1f37f5a0e7
Copter: remove tradheli swash, yaw and rsc servos
...
These are all created within the AP_MotorsSingle class now except for servo_rsc which was unused
2016-04-01 11:59:30 +09:00
Leonard Hall
6c40d6f774
Copter: remove single frame's servo objects
2016-04-01 11:59:30 +09:00
Leonard Hall
44180e44df
Copter: remove coax servo objects
...
servos moved to AP_MotorsCoax class
2016-04-01 11:59:30 +09:00
Leonard Hall
a00a9601a4
Copter: AP_MotorsCoax now uses 4 servos
2016-04-01 11:59:30 +09:00