Randy Mackay
d992483bf5
Copter: add EKF params to full param list
2014-02-21 13:51:22 +09:00
Randy Mackay
00913ffe1b
Copter: throttle rate to simple P controller
...
Saves at least 15bytes of RAM
2014-02-16 13:35:40 +11:00
Randy Mackay
aab9b30bf6
Copter: replace APM_PI with AC_P
...
Saves about 90bytes of RAM
2014-02-15 06:09:08 +11:00
Randy Mackay
3e399fd830
Copter: remove unused parameters
2014-02-15 05:27:46 +11:00
Randy Mackay
3b9ae02966
Copter: add Circle parameter
2014-02-15 05:27:40 +11:00
Randy Mackay
784f7385b5
Copter: add attitude and pos control params
2014-02-15 05:27:35 +11:00
Randy Mackay
7b9a48107e
Copter: move angle_max parameter to AP_Vehicle
2014-02-15 05:27:32 +11:00
Randy Mackay
2219f21744
Copter: add RC_FEEL_RP parameter
...
Values from 0 ~ 100 control amount of filtering on roll and pitch input.
100 = no filter so crisp feel, 0 = a lot of filtering so very sluggish
response
2014-02-12 16:28:41 +09:00
Randy Mackay
5d929351ca
Copter: removed unused servo3, servo4 from coax
2014-02-07 12:36:17 +09:00
Dneault
f48e106271
Copter: add coax heli support
...
Motors should be attached to RCOutputs 1 and 2, Flaps should be connected
to RC outputs 3 and 4
2014-02-07 12:36:04 +09:00
Andrew Tridgell
50a90a1043
Copter: enable AP_BoardConfig
2014-01-20 17:06:28 +11:00
Lukasz
cb17a5bdb6
Copter: Add RSSI_RANGE parameter
...
Added ability to rescale rssi input voltage. Useful for receivers like
FrSky which have 3.3V output.
2013-12-17 22:38:39 +09:00
ctech4285
2b5d8aa5b7
Copter: integrate EPM library
2013-12-17 15:36:42 +09:00
Andrew Tridgell
28d98414e7
Copter: fixed some build warnings
2013-12-11 10:21:20 +11:00
Randy Mackay
59cea4b88c
Copter: remove CopterLED from main code
2013-11-30 18:20:55 +09:00
Andrew Tridgell
9c812d5028
Copter: added SERIAL2_BAUD and rename SERIAL3_BAUD to SERIAL1_BAUD
2013-11-26 13:05:32 +11:00
Andrew Tridgell
a49710f20e
Copter: added uartD support
...
this also brings GCS_Mavlink.pde closer to the plane implementation
2013-11-26 13:05:32 +11:00
Randy Mackay
ed9f369492
Copter: shorten g.arming_check_enabled variable
...
g.arming_check_enabled shortened to g.arming_check
2013-11-25 17:23:39 +09:00
Randy Mackay
c9c803ffd4
TradHeli: move STAB_COL_MIN to main parameter list
2013-11-15 22:58:32 +09:00
Randy Mackay
159d6320bf
Copter: move SINGLE parameters to start at 75
2013-11-12 23:40:38 +09:00
ssq870424
07d3f2a3c5
Copter: add support for singlecopter airframe
...
this is the newest singlecopter airframe programme.
This kind of aerial vehicles include Honeywell T-hawk and Goldeneye.
2013-11-12 23:40:27 +09:00
Jason Short
c3aa56459a
Copter: remove unused Toy param
2013-11-02 21:34:50 +09:00
Randy Mackay
97770ae352
Copter: rc10, rc11 available even without MOUNT
2013-10-31 22:55:02 +09:00
Randy Mackay
8386b658e9
Copter: add ANGLE_RATE_MAX param
...
Limits the maximum rotation rate requested by the angle controller which
is used in stabilize, loiter, rtl and auto flight modes
2013-10-29 11:27:05 +09:00
Randy Mackay
8de6c34252
Copter: comments update for GPS_HDOP_GOOD parameter
2013-10-13 13:53:26 +09:00
Randy Mackay
dab4f032f9
Copter: integrate BattMonitor
2013-10-03 11:16:28 +09:00
Randy Mackay
6c5294f89e
Copter: integrate GPS_Glitch parameters
2013-09-24 21:41:45 +09:00
Randy Mackay
d8eb7fb82f
Copter: remove x100 from IMAX definitions
2013-08-19 22:38:34 +09:00
Randy Mackay
d000967a76
Copter: pre-arm check for gps hdop < 2
2013-08-15 13:06:36 +09:00
Randy Mackay
6969ab573d
Copter: configurable max lean angle
...
ANGLE_MAX parameter allows limiting the roll and pitch angles during
manual and auto flight modes to anywhere from 10 to 80 degrees
2013-08-11 12:53:22 +09:00
Randy Mackay
74fb500efe
Copter: integrate AC_Sprayer
2013-08-05 21:12:23 +09:00
Randy Mackay
49dbdce89c
Copter: split ACRO_P into ACRO_RP_P and ACRO_YAW_P
2013-08-05 21:05:00 +09:00
Randy Mackay
82082e044c
Copter: remove ACRO's axis enabled parameter
...
Acro is now body frame (with earth frame leveling) while Sport is earth
frame acro
2013-08-05 21:04:57 +09:00
Randy Mackay
21e523b9ac
Copter: Acro trainer separated into limited and leveled
2013-08-05 21:04:53 +09:00
Randy Mackay
aefb38e486
Copter: remove param to disable accel based throttle controller
2013-07-12 22:57:30 +09:00
Randy Mackay
404cd5f3da
Copter: rename g.pid_throttle to g.pid_throttle_rate
...
Small code clean-up to make throttle rate controller's pid more obvious
2013-06-30 00:04:21 -10:00
Andrew Tridgell
23eade8f74
Copter: enable RELAY_* parameters
2013-06-25 12:46:53 +10:00
Randy Mackay
213eaa8db6
Copter: integrate draft RCMapper
2013-06-03 16:23:47 +10:00
Randy Mackay
5ee68db6f0
TradHeli: add parameter descriptions
...
small formatting changes too
2013-05-21 15:33:41 +09:00
Randy Mackay
bd44c2f73d
Copter: all pre-arm checks to be disabled
...
set ARMING_CHECK parameter to zero to disable
2013-05-20 14:48:04 +09:00
Randy Mackay
9fdab5e8fe
Copter: remove unused AUTO_SLEW_RATE parameter
2013-05-17 16:09:17 +09:00
Randy Mackay
38239c652a
Copter: ch8 aux switch
...
Ch8 can be used as an aux switch like ch7. Has all the same options as
ch7 and there is a safety check to ensure both switches aren't set to
the same function so as to avoid interfering with each other
2013-05-17 14:42:28 +09:00
Randy Mackay
bab9fa25e5
Copter: add GCS failsafe
2013-04-29 21:30:22 +09:00
Randy Mackay
c232d7af4b
Copter: correct fence parameter
2013-04-27 11:14:11 +09:00
Randy Mackay
58d1da2d80
Copter: integrate AC_Fence in place of limits
...
Lesser functionality than limits but saves more than 150 bytes and it
works
2013-04-27 11:14:07 +09:00
Andrew Tridgell
300a8d2bbc
Copter: support all 12 channels on PX4
...
last 4 channels are on the FMU pins
2013-04-25 20:10:53 +10:00
Randy Mackay
745df9b13c
Copter: add SONAR_GAIN to tune reaction to sonar
...
Some users report the response to sonar is too violent, this allows that
reaction to be reduced
2013-04-20 15:58:36 +09:00
Randy Mackay
37abfdc65a
Copter: make CIRCLE_RATE a tunable parameter
...
Also bug fix to check of how many time it has rotated during a loiter
turns mission command
2013-04-20 12:03:55 +09:00
Randy Mackay
0fc9c8739e
Copter: add WP_YAW_BEHAVE parameter
...
Allows user to control whether nose points towards next waypoint and/or
home when RTLing.
Replaces YAW_OVR_BEHAVE which had a very similar purpose. Almost nobody
ever knew about or used this parameter.
2013-04-18 15:30:18 +09:00
Randy Mackay
f5955d8915
Copter: auto climb and descent params removed
...
These params now reside in the AC_WPNav library
2013-04-18 14:52:21 +09:00