forked from Archive/PX4-Autopilot
40 lines
2.2 KiB
Plaintext
40 lines
2.2 KiB
Plaintext
# this file is only used in the position_setpoint triple as a dependency
|
|
|
|
uint8 SETPOINT_TYPE_POSITION=0 # position setpoint
|
|
uint8 SETPOINT_TYPE_VELOCITY=1 # velocity setpoint
|
|
uint8 SETPOINT_TYPE_LOITER=2 # loiter setpoint
|
|
uint8 SETPOINT_TYPE_TAKEOFF=3 # takeoff setpoint
|
|
uint8 SETPOINT_TYPE_LAND=4 # land setpoint, altitude must be ignored, descend until landing
|
|
uint8 SETPOINT_TYPE_IDLE=5 # do nothing, switch off motors or keep at idle speed (MC)
|
|
uint8 SETPOINT_TYPE_OFFBOARD=6 # setpoint in NED frame (x, y, z, vx, vy, vz) set by offboard
|
|
uint8 SETPOINT_TYPE_FOLLOW_TARGET=7 # setpoint in NED frame (x, y, z, vx, vy, vz) set by follow target
|
|
|
|
bool valid # true if setpoint is valid
|
|
uint8 type # setpoint type to adjust behavior of position controller
|
|
float32 x # local position setpoint in m in NED
|
|
float32 y # local position setpoint in m in NED
|
|
float32 z # local position setpoint in m in NED
|
|
bool position_valid # true if local position setpoint valid
|
|
float32 vx # local velocity setpoint in m/s in NED
|
|
float32 vy # local velocity setpoint in m/s in NED
|
|
float32 vz # local velocity setpoint in m/s in NED
|
|
bool velocity_valid # true if local velocity setpoint valid
|
|
float64 lat # latitude, in deg
|
|
float64 lon # longitude, in deg
|
|
float32 alt # altitude AMSL, in m
|
|
float32 yaw # yaw (only for multirotors), in rad [-PI..PI), NaN = hold current yaw
|
|
bool yaw_valid # true if yaw setpoint valid
|
|
bool disable_mc_yaw_control # control yaw for mc (used for vtol weather-vane mode)
|
|
float32 yawspeed # yawspeed (only for multirotors, in rad/s)
|
|
bool yawspeed_valid # true if yawspeed setpoint valid
|
|
float32 loiter_radius # loiter radius (only for fixed wing), in m
|
|
int8 loiter_direction # loiter direction: 1 = CW, -1 = CCW
|
|
float32 pitch_min # minimal pitch angle for fixed wing takeoff waypoints
|
|
float32 a_x # acceleration x setpoint
|
|
float32 a_y # acceleration y setpoint
|
|
float32 a_z # acceleration z setpoint
|
|
bool acceleration_valid # true if acceleration setpoint is valid/should be used
|
|
bool acceleration_is_force # interprete acceleration as force
|
|
float32 acceptance_radius # navigation acceptance_radius if we're doing waypoint navigation
|
|
float32 cruising_speed # the generally desired cruising speed (not a hard constraint)
|