Julian Oes 19b681ca1f Remove SYS_USE_IO param ... The param is not really required anymore with the actuator configuration. Also, when it is set to 0, RC doesn't work for some boards which would be nice to avoid. Signed-off-by: Julian Oes <julian@oes.ch>		2023-11-10 12:17:23 +13:00
..
extras	NuttX 10.3+ upgrade (#20190)	2022-11-20 20:28:07 -05:00
init	Remove SYS_USE_IO param	2023-11-10 12:17:23 +13:00
nuttx-config	boards: increase init stack size by 100B	2023-10-02 09:37:06 +02:00
src	fmu-v2/v3: fix HW detection on CubeBlack	2023-04-01 10:34:24 -07:00
default.px4board	driver: cleanup imu folder	2023-11-03 10:50:27 -04:00
firmware.prototype	boards organization	2018-11-26 14:40:14 -08:00
fixedwing.px4board	fw pos control: revert name until we delineate this module a bit more (#21442)	2023-04-13 17:00:04 +02:00
lto.px4board	Added LTO targets for CI	2022-05-02 10:07:54 -04:00
multicopter.px4board	px4/fmu-v2/multicopter.px4board: disable module to reduce flash	2022-05-10 08:57:39 +02:00
rover.px4board	update all px4board kconfig	2023-03-24 10:01:58 -04:00