- gz in PX4/Firmware (c9ad60e3cc): c78f7f0141
- gz current upstream: f1c461fffb
- Changes: c78f7f0141...f1c461fffb
f1c461f 2024-02-08 frederik - increase monocam clipping distance
6d5db73 2024-02-07 Sergei Grichine - Added Zero Turn Lawnmower model (#27)
5332071 2024-02-06 Frederik Markus - add navsat plugin to worlds and navsat sensor to models (#26)
* publish the global groundtruth from the navsat callback and rearrange the local groundtruth as the altitude reference now has a dependency on the global groundtruth being initialized
---------
Signed-off-by: frederik <frederik.anilmarkus@gmail.com>
-remove RTL_HDG_MD
-only set heading setpoint in Navigator::RTL once above landing point,
or when RTL is triggered close to it
-never set a heading during RTL if weather vane is enabled
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
After smoothing the linera velocity setpoint, the EKF has trouble initializing, becuase the acceleration is too smooth, to combat this issue, there is a 1 second delay when initializing the mission mode
Instead of directly setting the attitude setpoint for usage inside the same module
only publish it to the uorb topic, which is subscribed to in the same module.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* battery: make time remaining estimation dependent on level flight characteristis for FW
* battery: fix that FW flight is also correctly detected when vehicle_status is not updated
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* FixedwingPositionControl: Move constant to header file
* flight phase estimation: use tecs height rate reference to check for level flight
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
When flow control is used together with DMA, we need to add a pulldown
to CTS. Without it, it assumes flow control and gets stuck when
CTS is not connected.
Signed-off-by: Julian Oes <julian@oes.ch>
When the CPU load monitor is started while already running, then the
idle thread last_times[0] is reset to the last 1 second, rather than
since when the CPU load monitor was last started. The remaining threads
are not impacted, since their last_times[i] is reset to zero here.
This results in the idle thread having a lower than real CPU load, with
the remaining CPU time being wrongly attributed as scheduler load.
The ADC peripheral can only support up to
50MHz on rev V silicon and 36MHz on Y silicon.
The existing driver always used no prescaler
and kept boost setting at 0.
Daniel Agar
PX4 BuildBot
Frederik Markus
Silvan Fuhrer
Matthias Grob
PerFrivik
muramura
Alex Klimaj
fury1895
KonradRudin
Andrew Brahim
Alessandro Simovic
bresch
Peter van der Perk
Beat Küng
cuav-liu1
Vincent Poon
David Sidrane
Julian Oes
Niklas Hauser