| .. |
|
APM_Config.h
|
Plane: added HIL_MODE parameter
|
2015-03-13 22:52:56 +11:00 |
|
APM_Config.h.reference
|
Plane: cleanup HIL defines
|
2014-02-15 05:29:46 +11:00 |
|
ArduPlane.cpp
|
Plane: nonfunctional change, comment only. Units were in old in comment
|
2016-02-12 12:14:38 -08:00 |
|
Attitude.cpp
|
Plane: new param LAND_THEN_NEUTRL
|
2016-02-16 23:40:44 -08:00 |
|
GCS_Mavlink.cpp
|
Plane: add SYS_STATUS reverse_motor
|
2016-02-11 18:46:01 +11:00 |
|
Log.cpp
|
Plane: added PID tuning for quadplane modes
|
2016-02-20 20:20:27 +11:00 |
|
Makefile
|
Plane: cleanup cruft in Makefile
|
2013-10-13 21:41:01 +11:00 |
|
Makefile.waf
|
waf: use single entry point for make wrappers
|
2015-12-10 10:40:34 +09:00 |
|
Parameters.cpp
|
Plane: new param LAND_THEN_NEUTRL
|
2016-02-16 23:40:44 -08:00 |
|
Parameters.h
|
Plane: new param LAND_THEN_NEUTRL
|
2016-02-16 23:40:44 -08:00 |
|
Parameters.pde
|
Plane: added blank Parameters.pde for MissionPlanner
|
2015-05-30 15:21:33 +09:00 |
|
Plane.cpp
|
AP_HAL: make code not depend on concrete HAL implementations
|
2015-10-21 09:16:07 +11:00 |
|
Plane.h
|
Plane: Reverse Thrust
|
2016-02-09 14:18:02 +11:00 |
|
adsb.cpp
|
Plane: refactored interface
|
2015-12-31 15:36:49 +11:00 |
|
altitude.cpp
|
Plane: add flight stage LAND_PREFLARE
|
2016-02-09 14:18:02 +11:00 |
|
arming_checks.cpp
|
Plane: add missionLoaded arming check fail for mis.len <= 1
|
2016-02-22 16:19:40 +11:00 |
|
capabilities.cpp
|
Plane: init vehicle capabilities
|
2015-08-05 16:08:49 +09:00 |
|
commands.cpp
|
Plane: Text revisions
|
2015-11-26 07:56:52 +11:00 |
|
commands_logic.cpp
|
Plane: Reverse Thrust
|
2016-02-09 14:18:02 +11:00 |
|
commands_process.cpp
|
Plane: convert from .pde to .cpp files
|
2015-05-21 07:48:52 +10:00 |
|
config.h
|
ArduPlane: remove unused CMAKE define
|
2016-02-19 19:15:39 -02:00 |
|
control_modes.cpp
|
Plane: added OVERRIDE_SAFETY parameter
|
2016-01-29 12:20:14 +11:00 |
|
createTags
|
ArduPlane: don't use avr include dir for tags
|
2015-11-04 12:14:16 +11:00 |
|
defines.h
|
Plane: defines.h should not use defines from config.h
|
2016-02-19 12:34:23 -02:00 |
|
events.cpp
|
Plane: add flight stage LAND_PREFLARE
|
2016-02-09 14:18:02 +11:00 |
|
failsafe.cpp
|
Plane: require 5 channels to run failsafe passthrough
|
2015-09-07 09:16:14 +10:00 |
|
geofence.cpp
|
ArduPlane: avoid comparison between signed and unsigned
|
2015-12-01 16:28:18 -02:00 |
|
is_flying.cpp
|
Plane: run is_crashed at 5hz instead of 1hz
|
2016-02-08 21:13:04 -08:00 |
|
landing.cpp
|
Plane: Reverse Thrust
|
2016-02-09 14:18:02 +11:00 |
|
make.inc
|
Plane: added QLOITER mode
|
2016-01-09 07:38:52 +11:00 |
|
navigation.cpp
|
Plane: added parameter RTL_RADIUS
|
2016-01-19 15:04:30 +11:00 |
|
parachute.cpp
|
Plane: Text revisions
|
2015-11-26 07:56:52 +11:00 |
|
px4_mixer.cpp
|
Plane: Only resend the mixer configuration if its changed
|
2016-01-29 12:20:14 +11:00 |
|
quadplane.cpp
|
Plane: added PID tuning for quadplane modes
|
2016-02-20 20:20:27 +11:00 |
|
quadplane.h
|
Plane: added PID tuning for quadplane modes
|
2016-02-20 20:20:27 +11:00 |
|
radio.cpp
|
Plane: restrict rudder arming where reverse_thrust is enabled and commanding negative
|
2016-02-10 22:18:06 -08:00 |
|
release-notes.txt
|
Plane: prepare for 3.5.0 release
|
2016-01-30 13:04:51 +11:00 |
|
sensors.cpp
|
Plane: add flight stage LAND_PREFLARE
|
2016-02-09 14:18:02 +11:00 |
|
setup.cpp
|
Replace use of UARTDriver::printf_P() with UARTDriver::printf()
|
2015-10-30 14:35:25 +09:00 |
|
system.cpp
|
Plane: use set_dataflash()
|
2016-02-22 12:34:32 +11:00 |
|
takeoff.cpp
|
Plane: zero course error for straight bungee launch
|
2016-01-05 11:20:14 +11:00 |
|
test.cpp
|
Plane: allow for settable main loop rate
|
2015-12-27 14:57:19 +09:00 |
|
wscript
|
waf: ardupilotwaf: prefix build context methods with ap_
|
2016-01-22 20:10:29 -02:00 |
881dabf048