ardupilot/libraries/AP_HAL_ChibiOS/hwdef/ACNS-CM4Pilot

CM4PILOT Integrated Flight Controller

The CM4PILOT is a low-cost and compact flight controller which integrated a Raspberry Pi CM4 in the cockpit.

Features

• Raspberry Pi CM4 + Ardupilot, Companion Computers in cockpit structure
• Small Footprint and Lightweight, 58mm X 50mm X 18mm，26g(without shell)
• Broadcom BCM2711, quad-core Cortex-A72 (ARM v8) 64-bit SoC @ 1.5GHz
• STM32F405 microcontroller
• IMU: BMI088
• Mag: LIS3MDLTR
• Baro: BMP280
• RTC: PCF85063
• 2 2-lane MIPI CSI camera ports
• 2 microSD card slot port
• 1 power ports(Analog)
• 6 UARTs and USB ports for FMU
• 2 UARTs and 4 USB2.0 and 1 OTG for CM4
• 1 I2C port
• 1 CAN port
• 1 SBUS input and 8 PWM output (all support DShot)
• External SPI port
• Buzzer on board
• RBG LED on board
• 128M flash on board for logging

UART Mapping

• SERIAL0 -> USB(OTG1)
• SERIAL1 -> USART1(Telem1)(DMA capable)
• SERIAL2 -> USART3 (CM4)(DMA capable)
• SERIAL3 -> UART4 (GPS)(DMA capable)
• SERIAL4 -> UART6 (GPS2)(DMA capable)
• SERIAL5 -> USART2 (SBUS)(RC input, no DMA capable)

RC Input

RC input is configured on the SBUS pin (UART2_RX). It supports all RC protocols except serial protocols

PWM Output

The CM4PILOT supports up to 8 PWM outputs. All outputs support DShot (No BDshot). The PWM is in 4 groups:

• PWM 1~4 in group1
• PWM 5,6 in group2
• PWM 7,8 in group3
• Buzzer on board in group4

GPIOs

All 8 PWM channels can be used for GPIO functions. The pin numbers for these PWM channels in ArduPilot are shown below:

PWM Channels	Pin	PWM Channels	Pin
PWM1	50	PWM8	57
PWM2	51
PWM3	52
PWM4	53
PWM5	54
PWM6	55
PWM7	56

Battery Monitoring

The correct battery setting parameters are set by default and are:

• BATT_MONITOR 4
• BATT_VOLT_PIN 11
• BATT_CURR_PIN 12
• BATT_VOLT_SCALE 10.1
• BATT_CURR_SCALE 17.0

Compass

The CM4PILOT has one built-in compass LIS3MDLTR, you can also attach an external compass using I2C on the SDA and SCL pads.

Loading Firmware

Firmware for these boards can be found at https://firmware.ardupilot.org in sub-folders labeled “ACNS-CM4PILOT”.

Initial firmware load can be done with DFU by plugging in USB with the boot button pressed. Then you should load the "xxx_bl.hex" firmware, using your favorite DFU loading tool.

Subsequently, you can update the firmware with Mission Planner.

Pinout and Size