mirror of https://github.com/ArduPilot/ardupilot
66 lines
1.9 KiB
Markdown
66 lines
1.9 KiB
Markdown
# EFI HFE Driver
|
|
|
|
This driver implements support for the HFE International range of EFI
|
|
CAN engine control units. It supports monitoring and control of HFE
|
|
engines on fixed wing aircraft. This driver assumes you are using the
|
|
ICE subsystem in fixed wing aircraft for engine control.
|
|
|
|
# Parameters
|
|
|
|
The script used the following parameters:
|
|
|
|
## EFI_HFE_ENABLE
|
|
|
|
this must be set to 1 to enable the driver
|
|
|
|
## EFI_HFE_CANDRV
|
|
|
|
This sets the CAN scripting driver number to attach to. This is
|
|
normally set to 1 to use a CAN driver with CAN_Dx_PROTOCOL=10. To use
|
|
the 2nd scripting CAN driver set this to 2 and set CAN_Dx_PROTOCOL=12.
|
|
|
|
## EFI_HFE_ECU_IDX
|
|
|
|
This sets the ECU number on the CAN bus. A value of zero means that
|
|
the ECU number is auto-detected based on the first ECU seen on the
|
|
bus.
|
|
|
|
## EFI_HFE_RATE_HZ
|
|
|
|
This sets the update rate of the driver. A value of 200 is reasonable
|
|
|
|
## EFI_HFE_FUEL_DTY
|
|
|
|
This sets the fuel density in grams per litre, for fuel consumption
|
|
calculations
|
|
|
|
## EFI_HFE_REL_IDX
|
|
|
|
This sets a relay number to use for the ECU enable function. if the
|
|
ECU requires a high voltage GPIO to enable then you should set a
|
|
RELAY_PIN that the ECU enable is attached to and set the relay number
|
|
here.
|
|
|
|
# Operation
|
|
|
|
This driver should be loaded by placing the lua script in the
|
|
APM/SCRIPTS directory on the microSD card, which can be done either
|
|
directly or via MAVFTP. The following key parameters should be set:
|
|
|
|
- SCR_ENABLE should be set to 1
|
|
- EFI_TYPE should be set to 7
|
|
- ICE_ENABLE should be set to 1
|
|
|
|
then the flight controller should rebooted and parameters should be
|
|
refreshed.
|
|
|
|
Once loaded the EFI_HFE parameters will appear and should be set
|
|
according to the parameter list above.
|
|
|
|
The ICE start channel will be monitored for starter control.
|
|
|
|
The GCS will receive EFI_STATUS MAVLink messages which includes RPM,
|
|
cylinder head temperature, injection timing, engine load, fuel
|
|
consumption rate, throttle position atmospheric pressure and ECU
|
|
voltage.
|