Commit Graph

76 Commits

Author SHA1 Message Date
Andrew Tridgell ebe1fe0b17 Plane: raise version to 3.5.0beta1 2016-01-09 13:33:27 +11:00
Andrew Tridgell 70018ee0cb Plane: fixed final descent for VTOL auto landing 2016-01-09 07:38:54 +11:00
Andrew Tridgell f068a8c913 Plane: added support for VTOL_TAKEOFF and VTOL_LAND commands 2016-01-09 07:38:53 +11:00
Andrew Tridgell 0d6b353bcb Plane: added quad assistance and auto support for quadplane 2016-01-09 07:38:52 +11:00
Andrew Tridgell 6468fc6d93 Plane: Initial implementation of quadplane
adds "HOVER" mode
2016-01-09 07:38:52 +11:00
Tom Pittenger 7cde90553d Plane: new param CRASH_ACC_THRESH
@Description: X-Axis deceleration threshold to notify the crash detector that there was a possible impact which helps disarm the motor quickly after a crash. This value should be much higher than normal negative x-axis forces during normal flight, check flight log files to determine the average IMU.x values for your aircraft and motor type. Higher value means less sensative (triggers on higher impact). For electric planes that don't vibrate much during fight a value of 25 is good (that's about 2.5G). For petrol/nitro planes you'll want a higher value. Set to 0 to disable the collision detector.
2016-01-02 09:58:32 +11:00
Tom Pittenger 21205f8b41 Plane: improved crash detection logic and agility
- inhibit crash detection warnings when disabled by param so now it can be completely disabled
- reset is_crashed when disabled by param
- fixed pre-takeoff detection bug by adding in_preLaunch_flight_stage() where we are actually in FLIGHT_NORMAL instead of FLIGHT_TAKEOFF during setup of bungee launches. This now detects if we're in that state
- simplified the use of been_auto_flying to check across all flight stages. before it was excluded to handle hand-launches which can now be detected with in_preLaunch_flight_stage()
- added impact detector timer to clamp is_flying a few seconds after an impact
- logging new impact detector as "STAT.Hit"
2016-01-02 09:58:31 +11:00
Tom Pittenger 3b06260358 Plane: refactored interface
- added guided mode handling
- now handles gracefully a manual mode changes during evasion
2015-12-31 15:36:49 +11:00
Siddharth Bharat Purohit 78566bda36 Plane: wire up accel calibrator for plane 2015-12-29 10:46:35 -08:00
Andrew Tridgell 513d5c17b9 Plane: allow for settable main loop rate 2015-12-27 14:57:19 +09:00
Julien BERAUD 8e66ce6f27 Plane: Update optical flow declaration
Pass ahrs as param
2015-12-18 17:56:06 +11:00
Lucas De Marchi 1308dd888f ArduPlane: remove unused AP_ADC_AnalogSource 2015-12-03 13:32:45 +11:00
Peter Barker 574f95bd76 Plane: support multiple simultaneous backends 2015-12-03 13:21:51 +11:00
Tom Pittenger eaad72c192 Plane: Add support for handing ADS-B traffic
- parse MAVLINK_MSG_ADSB_VEHICLE msg
- new 1Hz adsb_update task to compare list against for threat detection
- perform object avoidance via loiter or loiter_and_descend. More methods are welcome!
2015-11-23 19:45:40 +11:00
Caio Marcelo de Oliveira Filho c8888329e1 Plane: use millis/micros/panic functions 2015-11-20 12:26:40 +09:00
lvale e18181e5c2 Plane: Uniformization of severities
Plane uniformization of severities
2015-11-09 09:38:25 +11:00
Lucas De Marchi 5244559010 Minimize AP_Progmem.h includes
Most of AP_Progmem is already gone so we can stop including it in most
of the places. The only places that need it are the ones using
pgm_read_*() APIs.

In some cases the header needed to be added in the .cpp since it was
removed from the .h to reduce scope. In those cases the headers were
also reordered.
2015-10-30 14:35:32 +09:00
Lucas De Marchi 1b07dabeb7 Replace prog_char and prog_char_t with char
prog_char and prog_char_t are now the same as char on supported
platforms. So, just change all places that use them and prefer char
instead.

AVR-specific places were not changed.
2015-10-30 14:35:30 +09:00
Lucas De Marchi 84da1f5039 Rename gcs_send_text_P to gcs_send_text 2015-10-30 14:35:07 +09:00
Andrew Tridgell 3c3392aae5 Plane: improve error messages on failed parachute release 2015-10-27 16:06:34 +11:00
Andrew Tridgell 9affddcaa3 Plane: initial support for AP_Parachute library 2015-10-27 16:06:34 +11:00
Caio Marcelo de Oliveira Filho 62d4c05a8e ArduPlane: include SITL only for SITL board
Include board-specific files only when the board is used. Since these
should be exceptional cases, let the includer handle the ifdef instead
of putting ifdefs in every platform-specific header.

In the future we should evaluate whether the HAL for the board should
instantiate this.
2015-10-22 13:36:14 -02:00
Caio Marcelo de Oliveira Filho 49a42dc985 SITL: use a SITL namespace 2015-10-22 11:04:42 -02:00
Caio Marcelo de Oliveira Filho db3e501aec ArduPlane: implement HAL::Callbacks
Also removes includes for each board since they are not necessary
anymore.
2015-10-21 09:16:09 +11:00
Randy Mackay 073828a764 Plane: add ahrs health pre-arm check 2015-10-16 13:50:59 +09:00
Andrew Tridgell 458e967d06 Plane: added RPM logging
useful for seeing if a petrol motor is still running
2015-09-24 20:58:18 +10:00
Andrew Tridgell c14dbcfc44 Plane: set version to 3.4.1dev 2015-09-24 11:12:41 +10:00
Andrew Tridgell 38d51ddb32 Plane: prepare for 3.4.0 release 2015-09-24 10:08:27 +10:00
Andrew Tridgell 91f990af06 Plane: added EKF2 to parameters as EK2_* 2015-09-23 11:56:37 +10:00
Andrew Tridgell b735999848 Plane: prepare for beta3 2015-09-22 09:43:39 +10:00
Andrew Tridgell d019f83bee Plane: allow for higher roll limits on takeoff
only restrict to LEVEL_ROLL_LIMIT below 5m. Above that start to allow
larger roll limits, reaching the full roll limit at 15m
2015-09-17 15:35:37 +10:00
Andrew Tridgell 86e8c7ed2f Plane: add some safety to detect bad lidar readings
we only accept a lidar if it changes by 5% of its full range, and we
reject a lidar again if the correction between barometric and lidar
range changes by more than 30m

This allows us to cope with faulty lidars which may give a constant
reading
2015-09-16 14:24:44 +10:00
Andrew Tridgell d43d070e75 Plane: ensure throttle reverse is obeyed in all states
need to use radio_max for failsafe if reversed
2015-09-14 09:42:20 +10:00
Tom Pittenger 4f46c5331a Plane: added time for flying in any mode
- previously we only kept track of starting flying while in auto which gets reset when switching in and out of auto and on takeoff/land. Now we keep track of a "global" one that will track the is_flying flag regardless of the flight mode.
2015-09-09 09:14:59 +10:00
Tom Pittenger 25da4ec0ea Plane: added flight stage FLIGHT_LAND_ABORT and abort mechanism
- enabled via new param LAND_ABORT_THR default is 0 (disabled)
- Triggered via 95% throttle during landing, a landing abort will take place.
- This copies all takeoff params for right now, we can make this better later if needed
- added mission item command to NAV_LAND which is the abort takeoff altitude. If 0 then use last takeoff if available, else use 30m
- hold heading, just like takeoff, until altitude is reached
- pitch is constrained to takeoff pitch, or else 10deg if not available
- After abort altitude is reached, the normal landing restart happens (DO_LAND_START or decrement mission)
- restart landing by jumping to DO_LAND_START or decrement mission on mode change
2015-09-09 09:04:24 +10:00
Andrew Tridgell 0a66fcce20 Plane: fix for changed AP_RangeFinder API 2015-09-08 16:46:52 +10:00
Andrew Tridgell f92f46ee99 Plane: update for changed AP_Arming API 2015-09-08 13:54:45 +10:00
Grant Morphett 3cb0c1bba8 Plane: Move the plane centric arming code into arming_checks.cpp
Needed to move the plane centric arming code out of the AP_Arming
library and into the plane vehcile code.
2015-09-07 11:54:21 +10:00
Andrew Tridgell e12c20bd22 Plane: prepare for 3.4.0-beta2 release 2015-09-07 09:30:34 +10:00
Siddharth Bharat Purohit aea1db7348 ArduPlane: implement on-board compass cal for arduplane 2015-09-03 16:59:14 +10:00
Peter Barker c2d61391ef Plane: DFMessageWriter; ability to trickle messages out to DF 2015-09-03 15:20:20 +10:00
Tom Pittenger 81f8358705 Plane: restart landing by jumping to DO_LAND_START or decrement mission
only takes effect on mode change
2015-08-29 21:17:35 +10:00
Stewart Loving-Gibbard 722dd29370 Plane: Moving to RSSI library for reading various kinds of RSSI, with the possibility of adding more.
* Retains ability to read from Analog Pin
* Adds ability to read RSSI from PWM channel value as is done in OpenLRSng, EazyUHF, and various other LRS.
* Handles any type of RSSI that provides RSSI values inverted - i.e. when the low value is the best signal and the high value is the worst signal.
* Has different key names from all existing RSSI parameters to provide for a clean break and easier distinguishing.
* Existing parameters are marked as obsolete
2015-08-29 08:05:59 +10:00
squilter 583c087eca Plane: update severities 2015-08-28 10:04:35 +10:00
Grant Morphett dda229aecd Plane: Added include guards for Plane.h 2015-08-25 13:54:16 +09:00
Tom Pittenger 204ff7b158 Plane: move statics into new struct
removed default case statements
2015-08-23 10:34:18 +10:00
Tom Pittenger da8f4f9e95 Plane: reworked is_flying
add crash detection, allow disengage via param CRASH_DETECT
improved is_flying behavior
take off, landing and hard-landing improvements
add stillness check to is_flying and log it
minimum airspeed is determined ARSPD_FBW_MIN*0.75
2015-08-23 10:34:18 +10:00
squilter d421644f3a Plane: define and send FIRMWARE_VERSION 2015-08-23 09:21:57 +09:00
Andrew Tridgell b1f810fbb9 Plane: prepare plane 3.4.0beta1 release 2015-08-20 10:53:48 +10:00
Tom Pittenger 86e3116fb6 Plane: implement try send mission_item_reached
clean up unreachable code
2015-08-19 15:42:07 +10:00