Mirror
/
ardupilot
mirror of https://github.com/ArduPilot/ardupilot
5
0
Fork 0
Code Issues Packages Projects Releases Wiki Activity
5,961 Commits 71 Branches 509 Tags 789 MiB
Commit Graph

75 Commits

Author SHA1 Message Date
Andrew Tridgell 5827c710e2 Plane: fixed sensors and attitude HIL 
we now use the Stub version of the InertialSensor driver. In sensors
HIL we can now correctly drive the AHRS code.
 2012-12-03 23:26:39 +11:00
Andrew Tridgell 940b057765 Plane: make THR_SLEWRATE docs clearer 2012-11-28 11:41:39 +11:00
Andrew Tridgell 2446b986c5 Plane: added THR_PASS_STAB parameter 
this allows direct passthru of throttle in STABILIZE and FBWA, which
is useful for nitro planes wher you have a throttle cut switch that
drops the throttle below normal minimum.
 2012-11-26 23:33:05 +11:00
Andrew Tridgell 937c485f91 APM: make it possible to run the CLI on any serial port 2012-11-21 21:41:34 +11:00
Andrew Tridgell 68ae91a729 APM: added AMP_OFFSET option 
thanks to Alexey Kozin!
 2012-11-21 13:34:27 +11:00
rmackay9 9e3ae301b1 ArduPlane: move to use new INS library instead of IMU library 2012-11-07 19:21:03 +09:00
Andrew Tridgell efc2324666 APM: added RSSI_PIN option for receiver RSSI 
this allows you to configure the pin for receiver RSSI without
recompiling
 2012-11-06 22:04:41 +11:00
Andrew Tridgell 110a2b8af6 APM: fixed loiter radius docs to reflect new limit 2012-10-30 16:19:24 +11:00
rmackay9 e151d3735a ArduPlane: added BATT_VOLT_PIN and BATT_CURR_PIN parameters to allow support for new 3DR IV battery monitor 2012-10-13 20:51:41 +09:00
Andrew Tridgell 8c1766f5df APM: added THR_SUPP_MAN option 
this allows for manual throttle control during auto throttle
suppression. This is useful for keeping a petrol engine idling before
takeoff
 2012-09-22 20:17:06 +10:00
Andrew Tridgell 7d84666b9d APM: removed the unused sonar code 
when we start supporting a sonar we'll add a AP_Sonar library, like
AP_Airspeed
 2012-09-19 19:35:22 +10:00
Andrew Tridgell 1cdb3a8dba APM: added ALT_OFFSET parameter 
useful to adjust for barometric pressure changes during a long flight
 2012-09-19 16:23:25 +10:00
Andrew Tridgell a90182b9d8 APM: fixed throttle nudging 
The nudge value depended on RC3_TRIM, which is not a reliable
value. It tried to only take effect when the throttle stick was above
50%, but if RC3_TRIM was high for some reason (say 1500) then it would
actually depress the throttle by a large amount, which could cause the
plane to stall.

This also adds a boolean option THROTTLE_NUDGE to allow disabling of
throttle nudging
 2012-09-09 19:39:04 +10:00
Andrew Tridgell b2a74951d1 APM: added RUDDER_STEER option 
when enabled, this uses only the rudder to steer during takeoff and
landing, using aileron only for levelling
 2012-09-08 10:07:03 +10:00
Andrew Tridgell 12c5e00db9 APM: added XTRK_MIN_DIST option 
this allows you to disable crosstrack correction on short legs
 2012-09-08 10:06:44 +10:00
Andrew Tridgell ae74db15e1 APM: fixed docs for LIM_PITCH_MIN 2012-08-30 14:55:08 +10:00
Andrew Tridgell 332ad921cc APM: added new TELEM_DELAY parameter 
number of seconds to delay telemetry
 2012-08-30 08:59:39 +10:00
Andrew Tridgell 3f54b83238 APM: added ALT_CTRL_ALG parameter 
this allows you to select different altitude control algorithms. The
current choices are for the default (automatic based on if airspeed is
available), or to force a non-airspeed algorithm

The idea is to make it possible to use airspeed for some things (like
wind speed, speed scaling) but not for alt control
 2012-08-28 20:18:24 +10:00
Andrew Tridgell 9cf8cc590f APM: added XTRK_USE_WIND parameter 
when enabled this will use the wind estimation code to adjust the
navigation bearing, allowing the navigation code to cope with much
higher levels of wind while using a compass
 2012-08-25 17:49:26 +10:00
Andrew Tridgell 703ca469fe APM: added optional use of new APM_Control library 
thanks to Jon Challinger for the new controllers!
 2012-08-22 12:45:14 +10:00
uncrustify ce04d62815 uncrustify ArduPlane/Parameters.pde 2012-08-21 19:19:50 -07:00
Andrew Tridgell 1ec772f69c AHRS: fixed reference to AHRS var_info for APM and ACM 2012-08-21 15:58:32 +10:00
rmackay9 e5d8efdb7e ArduPlane: replaced many "int" with "int16_t", "long" with "int32_t" 2012-08-18 18:26:13 +09:00
Andrew Tridgell 2fb8a13ac6 APM: added parameter FBWB_ELEV_REV 
this fixes issue 343
 2012-08-17 15:04:53 +10:00
Andrew Tridgell efee2b1557 APM: added LAND_FLARE_ALT and LAND_FLARE_SEC 
these allow you to configure the altitude and time before touchdown to
flare the plane and lock the heading. Useful on larger planes.
 2012-08-15 18:11:16 +10:00
Andrew Tridgell 455e088c9f APM: rename RDRSTEER to WHEELSTEER 
thanks to Jon for the suggestion
 2012-08-15 16:28:59 +10:00
Andrew Tridgell 4b5d98e65b APM: added RDRSTEER_ PID for steering on ground 
this allows for rolling takeoff with steering, and use of rudder in
landing
 2012-08-15 12:39:35 +10:00
Andrew Tridgell 1b152ef9e0 APM: implement FENCE_ACTION_REPORT 
when FENCE_ACTION is set to FENCE_ACTION_REPORT a fence breach is
reported, but the flight mode is not changed
 2012-08-15 12:39:35 +10:00
Andrew Tridgell 93f45f232f APM: added 'OBC' failsafe module for ArduPlane 
this adds FS_* parameters for setting up APM to follow the outback
challenge failsafe rules.

This includes:

 - manual pin
 - heartbeat pin
 - waypoint for heartbeat failure
 - waypoint for GPS failure
 2012-08-15 12:39:34 +10:00
Andrew Tridgell 35c88dd418 INS: disable INS AP_Param table when not on APM1 hardware 
this could cause overwriting of memory with default values
 2012-08-11 22:06:03 +10:00
Andrew Tridgell 4c77cbcd0b APM: Added RST_MISSION_CH option 
this allows a pilot to reset the mission using a transmitter
switch. Very useful for repeating a mission during testing
 2012-08-09 10:33:16 +10:00
Andrew Tridgell 6e46db39a1 APM: Added STICK_MIXING option 
this replaces the compile time option. Disabling during long distance
flights when the transmitter may be out of range is useful.
 2012-08-09 08:53:29 +10:00
Amilcar Lucas 9a8fd4738e Add an optional second mount to ArduPlane and ArduCopter 2012-08-08 23:22:24 +02:00
Andrew Tridgell 67f076a9db APM: change variables to use _cm, _cd and _ms suffix for units 
this makes it less likely that we mix up units
 2012-08-08 12:12:30 +10:00
Andrew Tridgell b366205172 APM: removed cli slider and dipswitch options 
use mavlink/eeprom for all config
 2012-08-08 12:12:29 +10:00
Andrew Tridgell f98b887dbe AP_Param: update ArduPlane core for new AP_Param interface 2012-08-08 12:11:57 +10:00
rmackay9 95522fb8a3 ArduPlane: bug fix to global var_info parameter list for ahrs object. 2012-08-01 10:52:34 +09:00
Andrew Tridgell cc9712860b APM: fixed case of 'LAND_PITCH_CD' 
mavlink parameters are uppercase by convention
 2012-07-29 17:07:38 +10:00
rmackay9 717d0d25d4 ArduPlane: allow MPU6000's DMP to be used for attitude estimation. 
Enable by adding this line to APM_Config.h:
#define DMP_ENABLED ENABLED
 2012-07-28 19:50:40 +09:00
rmackay9 d9e92c0beb ArduPlane: change to Parameters.pde to support moving var_info from AP_AHRS to AP_AHRS_DCM 2012-07-28 14:31:01 +09:00
Andrew Tridgell 6243cf77a8 APM: added a SCALING_SPEED parameter 
this allows users to adjust the base speed used for scaling roll/pitch
PIDs. This can be used to make PIDs work for both airspeed and
non-airspeed control
 2012-07-26 11:30:23 +10:00
Andrew Tridgell caa16cbb54 APM: fixed HIL build 2012-07-26 10:09:07 +10:00
Jason Short dbcfbfe857 Added Oilpan INS group object param 2012-07-18 23:07:50 -07:00
Jeff Taylor c083ca5f35 APM: Fixed bug where landing_pitch wasnt initialized properly 
this adds a new LAND_PITCH_CD parameter to control the landing pitch
when an airspeed sensor is not being used
 2012-07-19 13:59:30 +10:00
Andrew Tridgell 2121491197 APM: rename airspeed_cruise to airspeed_cruise_cm to make the units clearer 
it is in cm/s, not m/s
 2012-07-19 11:50:41 +10:00
Amilcar Lucas 504809d146 ArduPlane parameters: re-order the files, looks like the second file gets ignored :( 2012-07-18 22:52:17 +02:00
Amilcar Lucas 61f0cd15be ArduPlane parameters: Add base class info as well 2012-07-18 22:39:49 +02:00
Amilcar Lucas d911e4f61e Support up to 11 servos in APM2 
Conflicts:

	ArduPlane/ArduPlane.pde
 2012-07-18 22:01:19 +02:00
Michael Oborne 45609b3e6f fix rc libray param gen 2012-07-18 07:03:39 +08:00
Andrew Tridgell ead41670c4 Airspeed: change APM to use new AP_Airspeed library 
the next step is AHRS dead reckoning
 2012-07-16 11:21:50 +10:00