HAL_ChibiOS: pixracer and cube doc updates

This commit is contained in:
Andrew Tridgell 2018-11-20 15:09:51 +11:00
parent 8a85d9db69
commit 742d8b8933
2 changed files with 18 additions and 1 deletions

View File

@ -232,6 +232,16 @@ The pinout below for the SBUSo port is labelled so that GND is closest
to the cube. The 5V pin on the SBUS output port is connected to the to the cube. The 5V pin on the SBUS output port is connected to the
servo rail. servo rail.
When SBUS output is disabled (by setting BRD_SBUS_OUT to 0) you can
use the port for analog RSSI input from receivers. To enable for RSSI
input you need to set:
- BRD_SBUS_OUT 0
- RSSI_TYPE 1
- RSSI_PIN 103
You cannot have both SBUS output and analog RSSI input at the same time.
<table border="1" class="docutils"> <table border="1" class="docutils">
<tbody> <tbody>
<tr> <tr>
@ -547,6 +557,11 @@ The CubeBlack has 7 analog inputs
- ADC Pin15 -> ADC 6.6V port - ADC Pin15 -> ADC 6.6V port
- ADC Pin103 -> RSSI voltage monitoring - ADC Pin103 -> RSSI voltage monitoring
## IMU Heater
The IMU heater in the CubeBlack can be controlled with the
BRD_IMU_TARGTEMP parameter, which is in degrees C.
## Loading Firmware ## Loading Firmware
The board comes pre-installed with an ArduPilot compatible bootloader, The board comes pre-installed with an ArduPilot compatible bootloader,

View File

@ -375,7 +375,9 @@ receiver.
FrSky Telemetry is supported using SERIAL4, on the port marked as FrSky Telemetry is supported using SERIAL4, on the port marked as
FrSky. You need to set the following parameters to enable support for FrSky. You need to set the following parameters to enable support for
FrSky S.PORT FrSky S.PORT. You also need to cross-connect the TX and RX pins by
creating a cable that connects both the TX and RX pins of the FrSky
port to the FrSky S.Port pin on your receiver.
- SERIAL4_PROTOCOL 10 - SERIAL4_PROTOCOL 10
- SERIAL4_OPTIONS 0 - SERIAL4_OPTIONS 0