ardupilot/ArduPlane/sensors.pde

101 lines
2.8 KiB
Plaintext
Raw Normal View History

// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
// filter altitude from the barometer with a low pass filter
static LowPassFilterInt32 altitude_filter;
static void init_barometer(void)
{
gcs_send_text_P(SEVERITY_LOW, PSTR("Calibrating barometer"));
2012-12-04 18:22:21 -04:00
barometer.calibrate();
// filter at 100ms sampling, with 0.7Hz cutoff frequency
altitude_filter.set_cutoff_frequency(0.1, 0.7);
gcs_send_text_P(SEVERITY_LOW, PSTR("barometer calibration complete"));
}
// read the barometer and return the updated altitude in centimeters
// above the calibration altitude
static int32_t read_barometer(void)
{
2012-08-16 21:50:15 -03:00
barometer.read();
return altitude_filter.apply(barometer.get_altitude() * 100.0);
}
2013-08-28 09:37:07 -03:00
/*
ask airspeed sensor for a new value
*/
static void read_airspeed(void)
{
if (airspeed.enabled()) {
airspeed.read();
calc_airspeed_errors();
}
}
static void zero_airspeed(void)
{
2012-12-04 18:22:21 -04:00
airspeed.calibrate();
gcs_send_text_P(SEVERITY_LOW,PSTR("zero airspeed calibrated"));
}
static void read_battery(void)
{
2012-08-16 21:50:15 -03:00
if(g.battery_monitoring == 0) {
battery.voltage = 0;
2012-08-16 21:50:15 -03:00
return;
}
if(g.battery_monitoring == 3 || g.battery_monitoring == 4) {
// this copes with changing the pin at runtime
2012-12-04 18:22:21 -04:00
batt_volt_pin->set_pin(g.battery_volt_pin);
battery.voltage = BATTERY_VOLTAGE(batt_volt_pin);
}
if (g.battery_monitoring == 4) {
uint32_t tnow = hal.scheduler->millis();
float dt = tnow - battery.last_time_ms;
// this copes with changing the pin at runtime
batt_curr_pin->set_pin(g.battery_curr_pin);
battery.current_amps = CURRENT_AMPS(batt_curr_pin);
if (battery.last_time_ms != 0 && dt < 2000) {
// .0002778 is 1/3600 (conversion to hours)
battery.current_total_mah += battery.current_amps * dt * 0.0002778f;
}
battery.last_time_ms = tnow;
2012-08-16 21:50:15 -03:00
}
if (battery.voltage != 0 &&
g.fs_batt_voltage > 0 &&
battery.voltage < g.fs_batt_voltage) {
low_battery_event();
}
if (g.battery_monitoring == 4 &&
g.fs_batt_mah > 0 &&
g.pack_capacity - battery.current_total_mah < g.fs_batt_mah) {
low_battery_event();
}
}
// read the receiver RSSI as an 8 bit number for MAVLink
// RC_CHANNELS_SCALED message
void read_receiver_rssi(void)
{
2012-12-04 18:22:21 -04:00
rssi_analog_source->set_pin(g.rssi_pin);
float ret = rssi_analog_source->voltage_average() * 50;
2012-12-18 22:36:00 -04:00
receiver_rssi = constrain_int16(ret, 0, 255);
}
/*
return current_loc.alt adjusted for ALT_OFFSET
This is useful during long flights to account for barometer changes
from the GCS, or to adjust the flying height of a long mission
*/
static int32_t adjusted_altitude_cm(void)
{
return current_loc.alt - (g.alt_offset*100);
}