ardupilot/libraries/AP_HAL_ChibiOS/hwdef/BeastF7v2/hwdef.dat

72 lines
1.6 KiB
Plaintext
Raw Normal View History

# hw definition file for processing by chibios_pins.py
# for iFlight Beast F7 v2 hardware, based on Beast F7 v1
# thanks to betaflight for pin information
include ../BeastF7/hwdef.dat
undef APJ_BOARD_ID
undef HAL_SERIAL3_PROTOCOL
undef IMU
undef BARO
undef PD15
undef PE9 PE11 PB8 PB9 PB11 PB10 PA10 PA9 PA3 PA2
undef HAL_DEFAULT_INS_FAST_SAMPLE DMA_PRIORITY DMA_NOSHARE
undef STM32_PWM_USE_ADVANCED
undef I2C1
# board ID for firmware load
APJ_BOARD_ID 1057
# V2 has different motor mapping
PB4 TIM3_CH1 TIM3 PWM(2) GPIO(51) BIDIR # 2
PB5 TIM3_CH2 TIM3 PWM(3) GPIO(52) # 3
# only one I2C bus
I2C_ORDER I2C2
# order of UARTs (and USB)
SERIAL_ORDER OTG1 USART1 USART2 USART3 UART4 EMPTY EMPTY UART7
# Buzzer - DMA timer channel use by LEDs
PD2 BUZZER OUTPUT GPIO(80) LOW
# USART1 (DJI)
PA10 USART1_RX USART1
PA9 USART1_TX USART1 NODMA
# USART2 (DJI RCIN)
PA3 USART2_RX USART2
PA2 USART2_TX USART2 NODMA
define HAL_SERIAL2_PROTOCOL SerialProtocol_RCIN
# USART3 (RCIN)
PB11 USART3_RX USART3
PB10 USART3_TX USART3
# I2C2 for compass. These pins can also be used as USART3
PB10 I2C2_SCL I2C2 ALT(1)
PB11 I2C2_SDA I2C2 ALT(1)
# spi devices
SPIDEV bmi270 SPI1 DEVID1 BMI270_CS MODE3 10*MHZ 10*MHZ
DMA_PRIORITY USART1* TIM3*
# no built-in compass
define HAL_PROBE_EXTERNAL_I2C_COMPASSES
# one IMU
IMU BMI270 SPI:bmi270 ROTATION_ROLL_180_YAW_225
# v2 has no BARO
define HAL_BARO_ALLOW_INIT_NO_BARO 1
# save some flash
include ../include/save_some_flash.inc
2022-09-20 04:37:47 -03:00
define AP_GRIPPER_ENABLED 0
define HAL_PARACHUTE_ENABLED 0
define HAL_SPRAYER_ENABLED 0
define AP_BATTERY_SMBUS_ENABLED 0
# only include ublox GPS driver
include ../include/minimal_GPS.inc