Jetpack/u-boot/board/keymile/kmp204x/eth.c

72 lines
1.7 KiB
C

/*
* (C) Copyright 2013 Keymile AG
* Valentin Longchamp <valentin.longchamp@keymile.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <netdev.h>
#include <fm_eth.h>
#include <fsl_mdio.h>
#include <phy.h>
int board_eth_init(bd_t *bis)
{
int ret = 0;
#ifdef CONFIG_FMAN_ENET
struct fsl_pq_mdio_info dtsec_mdio_info;
printf("Initializing Fman\n");
dtsec_mdio_info.regs =
(struct tsec_mii_mng *)CONFIG_SYS_FM1_DTSEC1_MDIO_ADDR;
dtsec_mdio_info.name = DEFAULT_FM_MDIO_NAME;
/* Register the real 1G MDIO bus */
fsl_pq_mdio_init(bis, &dtsec_mdio_info);
/* DTESC1/2 don't have a PHY, they are temporarily disabled
* so that u-boot doesn't try to unsuccessfuly enable them */
fm_disable_port(FM1_DTSEC1);
fm_disable_port(FM1_DTSEC2);
/*
* Program RGMII DTSEC5 (FM1 MAC5) on the EC2 physical itf
* This is the debug interface, the only one used in u-boot
*/
fm_info_set_phy_address(FM1_DTSEC5, CONFIG_SYS_FM1_DTSEC5_PHY_ADDR);
fm_info_set_mdio(FM1_DTSEC5,
miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME));
ret = cpu_eth_init(bis);
/* reenable DTSEC1/2 for later (kernel) */
fm_enable_port(FM1_DTSEC1);
fm_enable_port(FM1_DTSEC2);
#endif
return ret;
}
#if defined(CONFIG_PHYLIB) && defined(CONFIG_PHY_MARVELL)
#define mv88E1118_PAGE_REG 22
int board_phy_config(struct phy_device *phydev)
{
if (phydev->addr == CONFIG_SYS_FM1_DTSEC5_PHY_ADDR) {
/* driver config is good */
if (phydev->drv->config)
phydev->drv->config(phydev);
/* but we still need to fix the LEDs */
phy_write(phydev, MDIO_DEVAD_NONE, mv88E1118_PAGE_REG, 0x0003);
phy_write(phydev, MDIO_DEVAD_NONE, 0x10, 0x0840);
phy_write(phydev, MDIO_DEVAD_NONE, mv88E1118_PAGE_REG, 0x0000);
}
return 0;
}
#endif