Jetpack/u-boot/board/freescale/m5329evb/nand.c

74 lines
1.6 KiB
C

/*
* (C) Copyright 2000-2003
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* Copyright (C) 2004-2007, 2012 Freescale Semiconductor, Inc.
* TsiChung Liew (Tsi-Chung.Liew@freescale.com)
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <config.h>
#include <common.h>
#include <asm/io.h>
#include <asm/immap.h>
DECLARE_GLOBAL_DATA_PTR;
#if defined(CONFIG_CMD_NAND)
#include <nand.h>
#include <linux/mtd/mtd.h>
#define SET_CLE 0x10
#define SET_ALE 0x08
static void nand_hwcontrol(struct mtd_info *mtdinfo, int cmd, unsigned int ctrl)
{
struct nand_chip *this = mtd_to_nand(mtdinfo);
volatile u16 *nCE = (u16 *) CONFIG_SYS_LATCH_ADDR;
if (ctrl & NAND_CTRL_CHANGE) {
ulong IO_ADDR_W = (ulong) this->IO_ADDR_W;
IO_ADDR_W &= ~(SET_ALE | SET_CLE);
if (ctrl & NAND_NCE)
*nCE &= 0xFFFB;
else
*nCE |= 0x0004;
if (ctrl & NAND_CLE)
IO_ADDR_W |= SET_CLE;
if (ctrl & NAND_ALE)
IO_ADDR_W |= SET_ALE;
this->IO_ADDR_W = (void *)IO_ADDR_W;
}
if (cmd != NAND_CMD_NONE)
writeb(cmd, this->IO_ADDR_W);
}
int board_nand_init(struct nand_chip *nand)
{
gpio_t *gpio = (gpio_t *) MMAP_GPIO;
/*
* set up pin configuration - enabled 2nd output buffer's signals
* (nand_ngpio - nCE USB1/2_PWR_EN, LATCH_GPIOs, LCD_VEEEN, etc)
* to use nCE signal
*/
clrbits_8(&gpio->par_timer, GPIO_PAR_TIN3_TIN3);
setbits_8(&gpio->pddr_timer, 0x08);
setbits_8(&gpio->ppd_timer, 0x08);
out_8(&gpio->pclrr_timer, 0);
out_8(&gpio->podr_timer, 0);
nand->chip_delay = 60;
nand->ecc.mode = NAND_ECC_SOFT;
nand->cmd_ctrl = nand_hwcontrol;
return 0;
}
#endif