forked from rrcarlosr/Jetpack
190 lines
5.0 KiB
C
190 lines
5.0 KiB
C
/*
|
|
* Copyright 2016 Freescale Semiconductor, Inc.
|
|
*
|
|
* SPDX-License-Identifier: GPL-2.0+
|
|
*/
|
|
|
|
#ifndef __LS1012AQDS_H__
|
|
#define __LS1012AQDS_H__
|
|
|
|
#include "ls1012a_common.h"
|
|
|
|
|
|
#define CONFIG_DIMM_SLOTS_PER_CTLR 1
|
|
#define CONFIG_CHIP_SELECTS_PER_CTRL 1
|
|
#define CONFIG_NR_DRAM_BANKS 2
|
|
#define CONFIG_SYS_SDRAM_SIZE 0x40000000
|
|
|
|
#define CONFIG_SYS_MMDC_CORE_CONTROL_1 0x05180000
|
|
#define CONFIG_SYS_MMDC_CORE_CONTROL_2 0x85180000
|
|
|
|
/*
|
|
* QIXIS Definitions
|
|
*/
|
|
#define CONFIG_FSL_QIXIS
|
|
|
|
#ifdef CONFIG_FSL_QIXIS
|
|
#define CONFIG_QIXIS_I2C_ACCESS
|
|
#define CONFIG_SYS_I2C_FPGA_ADDR 0x66
|
|
#define QIXIS_LBMAP_BRDCFG_REG 0x04
|
|
#define QIXIS_LBMAP_SWITCH 6
|
|
#define QIXIS_LBMAP_MASK 0xf7
|
|
#define QIXIS_LBMAP_SHIFT 0
|
|
#define QIXIS_LBMAP_DFLTBANK 0x00
|
|
#define QIXIS_LBMAP_ALTBANK 0x08
|
|
#define QIXIS_RST_CTL_RESET 0x41
|
|
#define QIXIS_RCFG_CTL_RECONFIG_IDLE 0x20
|
|
#define QIXIS_RCFG_CTL_RECONFIG_START 0x21
|
|
#define QIXIS_RCFG_CTL_WATCHDOG_ENBLE 0x08
|
|
#endif
|
|
|
|
/*
|
|
* I2C bus multiplexer
|
|
*/
|
|
#define I2C_MUX_PCA_ADDR_PRI 0x77
|
|
#define I2C_MUX_PCA_ADDR_SEC 0x76 /* Secondary multiplexer */
|
|
#define I2C_RETIMER_ADDR 0x18
|
|
#define I2C_MUX_CH_DEFAULT 0x8
|
|
#define I2C_MUX_CH_CH7301 0xC
|
|
#define I2C_MUX_CH5 0xD
|
|
#define I2C_MUX_CH7 0xF
|
|
|
|
#define I2C_MUX_CH_VOL_MONITOR 0xa
|
|
|
|
/*
|
|
* RTC configuration
|
|
*/
|
|
#define RTC
|
|
#define CONFIG_RTC_PCF8563 1
|
|
#define CONFIG_SYS_I2C_RTC_ADDR 0x51 /* Channel 3*/
|
|
#define CONFIG_CMD_DATE
|
|
|
|
/* EEPROM */
|
|
#define CONFIG_ID_EEPROM
|
|
#define CONFIG_CMD_EEPROM
|
|
#define CONFIG_SYS_I2C_EEPROM_NXID
|
|
#define CONFIG_SYS_EEPROM_BUS_NUM 0
|
|
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x57
|
|
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
|
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
|
|
#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
|
|
|
|
|
|
/* Voltage monitor on channel 2*/
|
|
#define I2C_VOL_MONITOR_ADDR 0x40
|
|
#define I2C_VOL_MONITOR_BUS_V_OFFSET 0x2
|
|
#define I2C_VOL_MONITOR_BUS_V_OVF 0x1
|
|
#define I2C_VOL_MONITOR_BUS_V_SHIFT 3
|
|
|
|
/* DSPI */
|
|
#define CONFIG_FSL_DSPI1
|
|
#define CONFIG_DEFAULT_SPI_BUS 1
|
|
|
|
#define CONFIG_CMD_SPI
|
|
#define MMAP_DSPI DSPI1_BASE_ADDR
|
|
|
|
#define CONFIG_SYS_DSPI_CTAR0 1
|
|
|
|
#define CONFIG_SYS_DSPI_CTAR1 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
|
|
DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
|
|
DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
|
|
DSPI_CTAR_DT(0))
|
|
#define CONFIG_SPI_FLASH_SST /* cs1 */
|
|
|
|
#define CONFIG_SYS_DSPI_CTAR2 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
|
|
DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
|
|
DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \
|
|
DSPI_CTAR_DT(0))
|
|
#define CONFIG_SPI_FLASH_STMICRO /* cs2 */
|
|
|
|
#define CONFIG_SYS_DSPI_CTAR3 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
|
|
DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
|
|
DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
|
|
DSPI_CTAR_DT(0))
|
|
#define CONFIG_SPI_FLASH_EON /* cs3 */
|
|
|
|
#define CONFIG_SF_DEFAULT_SPEED 10000000
|
|
#define CONFIG_SF_DEFAULT_MODE SPI_MODE_0
|
|
#define CONFIG_SF_DEFAULT_BUS 1
|
|
#define CONFIG_SF_DEFAULT_CS 0
|
|
|
|
/*
|
|
* USB
|
|
*/
|
|
/* EHCI Support - disbaled by default */
|
|
/*#define CONFIG_HAS_FSL_DR_USB*/
|
|
|
|
#ifdef CONFIG_HAS_FSL_DR_USB
|
|
#define CONFIG_USB_EHCI
|
|
#define CONFIG_USB_EHCI_FSL
|
|
#define CONFIG_EHCI_HCD_INIT_AFTER_RESET
|
|
#endif
|
|
|
|
/*XHCI Support - enabled by default*/
|
|
#define CONFIG_HAS_FSL_XHCI_USB
|
|
|
|
#ifdef CONFIG_HAS_FSL_XHCI_USB
|
|
#define CONFIG_USB_XHCI_FSL
|
|
#define CONFIG_USB_MAX_CONTROLLER_COUNT 1
|
|
#define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2
|
|
#define CONFIG_USB_STORAGE
|
|
#endif
|
|
|
|
/* MMC */
|
|
#define CONFIG_MMC
|
|
#ifdef CONFIG_MMC
|
|
#define CONFIG_FSL_ESDHC
|
|
#define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
|
|
#define CONFIG_GENERIC_MMC
|
|
#define CONFIG_DOS_PARTITION
|
|
#endif
|
|
|
|
/* SATA */
|
|
#define CONFIG_LIBATA
|
|
#define CONFIG_SCSI
|
|
#define CONFIG_SCSI_AHCI
|
|
#define CONFIG_SCSI_AHCI_PLAT
|
|
#define CONFIG_CMD_SCSI
|
|
#define CONFIG_DOS_PARTITION
|
|
#define CONFIG_BOARD_LATE_INIT
|
|
|
|
#define CONFIG_SYS_SATA AHCI_BASE_ADDR
|
|
|
|
#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
|
|
#define CONFIG_SYS_SCSI_MAX_LUN 1
|
|
#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
|
|
CONFIG_SYS_SCSI_MAX_LUN)
|
|
#define CONFIG_PCI /* Enable PCI/PCIE */
|
|
#define CONFIG_PCIE1 /* PCIE controller 1 */
|
|
#define CONFIG_PCIE_LAYERSCAPE /* Use common FSL Layerscape PCIe code */
|
|
#define FSL_PCIE_COMPAT "fsl,ls1043a-pcie"
|
|
|
|
#define CONFIG_SYS_PCI_64BIT
|
|
|
|
#define CONFIG_SYS_PCIE_CFG0_PHYS_OFF 0x00000000
|
|
#define CONFIG_SYS_PCIE_CFG0_SIZE 0x00001000 /* 4k */
|
|
#define CONFIG_SYS_PCIE_CFG1_PHYS_OFF 0x00001000
|
|
#define CONFIG_SYS_PCIE_CFG1_SIZE 0x00001000 /* 4k */
|
|
|
|
#define CONFIG_SYS_PCIE_IO_BUS 0x00000000
|
|
#define CONFIG_SYS_PCIE_IO_PHYS_OFF 0x00010000
|
|
#define CONFIG_SYS_PCIE_IO_SIZE 0x00010000 /* 64k */
|
|
|
|
#define CONFIG_SYS_PCIE_MEM_BUS 0x08000000
|
|
#define CONFIG_SYS_PCIE_MEM_PHYS_OFF 0x04000000
|
|
#define CONFIG_SYS_PCIE_MEM_SIZE 0x80000000 /* 128M */
|
|
|
|
#define CONFIG_NET_MULTI
|
|
#define CONFIG_PCI_PNP
|
|
#define CONFIG_PCI_SCAN_SHOW
|
|
#define CONFIG_CMD_PCI
|
|
|
|
#define CONFIG_CMD_MEMINFO
|
|
#define CONFIG_CMD_MEMTEST
|
|
#define CONFIG_SYS_MEMTEST_START 0x80000000
|
|
#define CONFIG_SYS_MEMTEST_END 0x9fffffff
|
|
|
|
#define CONFIG_MISC_INIT_R
|
|
|
|
#endif /* __LS1012AQDS_H__ */
|