px4-firmware/msg/EscReport.msg

26 lines
1.3 KiB
Plaintext

uint64 timestamp # time since system start (microseconds)
uint32 esc_errorcount # Number of reported errors by ESC - if supported
int32 esc_rpm # Motor RPM, negative for reverse rotation [RPM] - if supported
float32 esc_voltage # Voltage measured from current ESC [V] - if supported
float32 esc_current # Current measured from current ESC [A] - if supported
float32 esc_temperature # Temperature measured from current ESC [degC] - if supported
uint8 esc_address # Address of current ESC (in most cases 1-8 / must be set by driver)
uint8 esc_state # State of ESC - depend on Vendor
uint8 actuator_function # actuator output function (one of Motor1...MotorN)
uint16 failures # Bitmask to indicate the internal ESC faults
uint8 FAILURE_OVER_CURRENT = 0 # (1 << 0)
uint8 FAILURE_OVER_VOLTAGE = 1 # (1 << 1)
uint8 FAILURE_MOTOR_OVER_TEMPERATURE = 2 # (1 << 2)
uint8 FAILURE_OVER_RPM = 3 # (1 << 3)
uint8 FAILURE_INCONSISTENT_CMD = 4 # (1 << 4) Set if ESC received an inconsistent command (i.e out of boundaries)
uint8 FAILURE_MOTOR_STUCK = 5 # (1 << 5)
uint8 FAILURE_GENERIC = 6 # (1 << 6)
uint8 FAILURE_MOTOR_WARN_TEMPERATURE = 7 # (1 << 7)
uint8 FAILURE_WARN_ESC_TEMPERATURE = 8 # (1 << 8)
uint8 FAILURE_OVER_ESC_TEMPERATURE = 9 # (1 << 9)
uint8 ESC_FAILURE_COUNT = 10 # Counter - keep it as last element!