px4-firmware/ROMFS/mixers/FMU_AET.mix

61 lines
1.9 KiB
Plaintext

Aileron/elevator/throttle mixer for PX4FMU
==================================================
This file defines mixers suitable for controlling a fixed wing aircraft with
aileron, elevator and throttle controls using PX4FMU. The configuration assumes
the aileron servo(s) are connected to PX4FMU servo output 0, the elevator to
output 1 and the throttle to output 3.
Inputs to the mixer come from channel group 0 (vehicle attitude), channels 0
(roll), 1 (pitch) and 3 (thrust).
Aileron mixer
-------------
Two scalers total (output, roll).
This mixer assumes that the aileron servos are set up correctly mechanically;
depending on the actual configuration it may be necessary to reverse the scaling
factors (to reverse the servo movement) and adjust the offset, scaling and
endpoints to suit.
As there is only one output, if using two servos adjustments to compensate for
differences between the servos must be made mechanically. To obtain the correct
motion using a Y cable, the servos can be positioned reversed from one another.
Alternatively, output 2 could be used as a second aileron servo output with
separate mixing.
M: 1
O: 10000 10000 0 -10000 10000
S: 0 0 10000 10000 0 -10000 10000
Elevator mixer
------------
Two scalers total (output, roll).
This mixer assumes that the elevator servo is set up correctly mechanically;
depending on the actual configuration it may be necessary to reverse the scaling
factors (to reverse the servo movement) and adjust the offset, scaling and
endpoints to suit.
M: 1
O: 10000 10000 0 -10000 10000
S: 0 1 10000 10000 0 -10000 10000
Output 2
--------
This mixer is empty.
Z:
Motor speed mixer
-----------------
Two scalers total (output, thrust).
This mixer generates a full-range output (-1 to 1) from an input in the (0 - 1)
range. Inputs below zero are treated as zero.
M: 1
O: 10000 10000 0 -10000 10000
S: 0 3 0 20000 -10000 -10000 10000