forked from Archive/PX4-Autopilot
41 lines
2.5 KiB
Plaintext
41 lines
2.5 KiB
Plaintext
# This is a struct used by the commander internally.
|
|
|
|
uint64 timestamp # time since system start (microseconds)
|
|
|
|
bool condition_calibration_enabled
|
|
bool condition_system_sensors_initialized
|
|
bool condition_system_hotplug_timeout # true if the hotplug sensor search is over
|
|
bool condition_system_returned_to_home
|
|
bool condition_auto_mission_available
|
|
bool condition_angular_velocity_valid
|
|
bool condition_attitude_valid
|
|
bool condition_local_altitude_valid
|
|
bool condition_local_position_valid # set to true by the commander app if the quality of the local position estimate is good enough to use for navigation
|
|
bool condition_local_velocity_valid # set to true by the commander app if the quality of the local horizontal velocity data is good enough to use for navigation
|
|
bool condition_global_position_valid # set to true by the commander app if the quality of the global position estimate is good enough to use for navigation
|
|
bool condition_home_position_valid # indicates a valid home position (a valid home position is not always a valid launch)
|
|
bool condition_power_input_valid # set if input power is valid
|
|
bool condition_battery_healthy # set if battery is available and not low
|
|
bool condition_escs_error # set to true if one or more ESCs reporting esc_status are offline
|
|
|
|
bool circuit_breaker_engaged_power_check
|
|
bool circuit_breaker_engaged_airspd_check
|
|
bool circuit_breaker_engaged_enginefailure_check
|
|
bool circuit_breaker_flight_termination_disabled
|
|
bool circuit_breaker_engaged_usb_check
|
|
bool circuit_breaker_engaged_posfailure_check # set to true when the position valid checks have been disabled
|
|
bool circuit_breaker_vtol_fw_arming_check # set to true if for VTOLs arming in fixed-wing mode should be allowed
|
|
|
|
bool offboard_control_signal_found_once
|
|
bool offboard_control_signal_lost
|
|
bool offboard_control_set_by_command # true if the offboard mode was set by a mavlink command and should not be overridden by RC
|
|
|
|
bool rc_signal_found_once
|
|
bool rc_input_blocked # set if RC input should be ignored temporarily
|
|
bool rc_calibration_valid # set if RC calibration is valid
|
|
bool vtol_transition_failure # Set to true if vtol transition failed
|
|
bool usb_connected # status of the USB power supply
|
|
|
|
bool avoidance_system_required # Set to true if avoidance system is enabled via COM_OBS_AVOID parameter
|
|
bool avoidance_system_valid # Status of the obstacle avoidance system
|