px4-firmware/ROMFS/scripts/rc.PX4IOAR

98 lines
1.4 KiB
Plaintext

#!nsh
#
# Flight startup script for PX4FMU on PX4IOAR carrier board.
#
# Disable the USB interface
set USB no
# Disable autostarting other apps
set MODE ardrone
echo "[init] doing PX4IOAR startup..."
#
# Start the ORB
#
uorb start
#
# Init the parameter storage
#
echo "[init] loading microSD params"
param select /fs/microsd/parameters
if [ -f /fs/microsd/parameters ]
then
param load /fs/microsd/parameters
fi
#
# Force some key parameters to sane values
# MAV_TYPE 1 = fixed wing, 2 = quadrotor, 13 = hexarotor
# see https://pixhawk.ethz.ch/mavlink/
#
param set MAV_TYPE 2
#
# Start the sensors.
#
sh /etc/init.d/rc.sensors
#
# Start MAVLink
#
mavlink start -d /dev/ttyS0 -b 57600
usleep 5000
#
# Start the commander.
#
commander start
#
# Start the attitude estimator
#
attitude_estimator_ekf start
#
# Configure PX4FMU for operation with PX4IOAR
#
fmu mode_gpio_serial
#
# Fire up the multi rotor attitude controller
#
multirotor_att_control start
#
# Fire up the AR.Drone interface.
#
ardrone_interface start -d /dev/ttyS1
#
# Start GPS capture
#
gps start
#
# Start logging
#
sdlog start -s 10
#
# Start system state
#
if blinkm start
then
echo "using BlinkM for state indication"
blinkm systemstate
else
echo "no BlinkM found, OK."
fi
#
# startup is done; we don't want the shell because we
# use the same UART for telemetry
#
echo "[init] startup done"
exit