px4-firmware/ROMFS/px4fmu_common/init.d/30_io_camflyer

74 lines
1.2 KiB
Plaintext

#!nsh
echo "[init] 30_io_camflyer: PX4FMU+PX4IO on Camflyer"
#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
# Set all params here, then disable autoconfig
# TODO
param set SYS_AUTOCONFIG 0
param save
fi
#
# Force some key parameters to sane values
# MAV_TYPE 1 = fixed wing
#
param set MAV_TYPE 1
#
# Start MAVLink (depends on orb)
#
mavlink start -d /dev/ttyS1 -b 57600
usleep 5000
#
# Start the commander (depends on orb, mavlink)
#
commander start
#
# Start PX4IO interface (depends on orb, commander)
#
px4io start
#
# Allow PX4IO to recover from midair restarts.
# this is very unlikely, but quite safe and robust.
px4io recovery
#
# Set actuator limit to 100 Hz update (50 Hz PWM)
px4io limit 100
#
# Start the sensors (depends on orb, px4io)
#
sh /etc/init.d/rc.sensors
#
# Start logging (depends on sensors)
#
sh /etc/init.d/rc.logging
#
# Start GPS interface (depends on orb)
#
gps start
#
# Start the attitude and position estimator
#
att_pos_estimator_ekf start
#
# Load mixer and start controllers (depends on px4io)
#
mixer load /dev/pwm_output /etc/mixers/FMU_Q.mix
fw_att_control start
fw_pos_control_l1 start