px4-firmware/boards/mro/x21-777
Julian Oes 19b681ca1f Remove SYS_USE_IO param
The param is not really required anymore with the actuator
configuration. Also, when it is set to 0, RC doesn't work for some
boards which would be nice to avoid.

Signed-off-by: Julian Oes <julian@oes.ch>
2023-11-10 12:17:23 +13:00
..
extras NuttX 10.3+ upgrade (#20190) 2022-11-20 20:28:07 -05:00
init Remove SYS_USE_IO param 2023-11-10 12:17:23 +13:00
nuttx-config boards: increase init stack size by 100B 2023-10-02 09:37:06 +02:00
src NuttX 10.3+ upgrade (#20190) 2022-11-20 20:28:07 -05:00
default.px4board fw pos control: revert name until we delineate this module a bit more (#21442) 2023-04-13 17:00:04 +02:00
firmware.prototype