Add ARK_FMU_V6X to RCS netman
Remove arkv6x rc single wire
Fix arkv6x mtd
arkv6x bootloader init all pins to prevent power cycling peripherals on boot
arkv6x don't power cycle sd card on boot
arkv6x add UART4 Telem 4
Also applies to Loiters that are started due to the previous mode being over (Takeoff,
VTOL_Takeoff, Mission).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
landing airspeed was previously defined by a scale factor multiplied by minimum airspeed. this commit changes this parameter to an explicit speed, and when unspecified, defaults to the minimum airspeed
Use kClearanceAltitudeBuffer for it, which is also used to ensure that during takeoff an
altitude setpoint above the clearance altitdue is set.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
MIS_LTRMIN_ALt was used to limit the go-to altitude of a LOITER_TO_ALT (not the exit altitude,
but the altitude that the vehicle went to to fly to WP), and during landing abort to climb to
at least this altitude. The min entry altitude of LOITER_TO_ALT I remove with this commit, while
for the min alt during abort I added the new parameter MIS_LND_ABRT_ALT.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
previously, the next position setpoint in the triplet was left unchanged during an abort, which meant that the abort loiter current point combined with land next point triggered the early landing config logic. this commit is only a hack to make things work temporarily.. this needs to be handled better.
- explicitly defined takeoff airspeed setpoint
- dont use climbout mode
- allow max climb on takeoff
- dont handle post clearance altitude case (navigator will switch anyway)
Completely detach the steering wheel logic from the yaw controller (beside using the
same manual stick input in a manual flight mode).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- also put flaring internal states into a struct to organize a bit
- one concern with blending the throttle setpoint like this with the flare time param is that folding prop belly landing airframes may want to have a separate param for shorter throttle kill and still use the flare time ramps for everything else
abruptly changing to a heading setpoint on flare can cause the aircraft to roll and deviate from the runway, this commit
- maintains path following control during the flare not to disrupt the tracking just before touchdown
- (unfortunately for crosswind landing) removes the body axis alignment for runway bearing - this is a compromise
to achieve both runway bearing body axis alignment AND a specific touchdown point, either
1. the wind would need to be considered, and an appropriate diagonal approach (obstructions allowing) defined to the runway
2. slip control added, keeping path following outputs only commanding roll (controlling airspeed vector) and using yaw-rate command (only actuated by e.g. rudder) to align body axis with the runway
Peter van der Perk
Matthias Grob
Silvan Fuhrer
benjinne
bresch
alexklimaj
Daniel Agar
David Sidrane
Thomas Stastny