- track and publish validity based on hover thrust variance, innovation test ratio, and hysteresis
- only publish on actual updates or becoming inactive
- fix dt (previous timestamp wasn't being saved)
- use local position timestamp (corresponding) to accel data rather than current time to avoid unnecessary timing jitter
- check local position validity before using
- mc_hover_thrust_estimator: move from wq:lp_default -> wq:nav_and_controllers to ensure the hover thrust estimator runs after the position controller and uses the same vehicle_local_position data
- land_detector: check hover thrust estimate validity and adjust low throttle thresholds if hover thrust is available
- mc_pos_control: only use hover thrust estimate if valid
with measurement noise auto-tuning
The purpose of this estimator is to improve land detection and vertical
velocity feedforward
Recovery strategy:
This is required when the setpoint suddenly changes in air or that the
EKF is diverging. A lowpassed test ratio is used as a trigger for the recovery logic
Also, a lowpassed residual is used to estimate the steady-state value
and remove it when estimating the accel noise to avoid increasing the
accel noise when the redisual is caused by an offset.
Daniel Agar
bresch