the primary height source
- moved height control into single function in order to decide which sensor
should be used for estimating height
- under certain conditions allow to use the range finder to estimate height
even if it's not the primary height source
- fixed a bug where the delta time for the baro offset calculation was always
zero
- use methods to set height control flags to reduce code duplication and
to prevent bugs
Signed-off-by: Roman <bapstroman@gmail.com>
Add calculation of a vertical position derivative to the output predictor. This will have degraded tracking relative to the EKF states, but the velocity will be closer to the first derivative of the position and reduce the effect inertial prediction errors on control loops that are operating in a pure velocity feedback mode.
Move calculation of IMU offset angular rate correction out of velocity accessor and into output predictor.
Provide separate accessor for vertical position derivative.
Use horizontal acceleration to check if yaw is observable independent of the magnetometer.
Use rotation about the vertical to check if mag raises are observable.
If neither yaw of mag biases are observable, save the magnetic field variances and switch to magnetic yaw fusion.
Use the last learned declination when using magnetic yaw fusion so that the yaw reference remains consistent.
When yaw or biases become observable, reinstate the saved variances and switch back to 3D mag fusion.
Add a bitmask parameter to control bias learning for individual axes. This is achieved by setting the disabled states to zero together with their corresponding covariances.
Minor cleanup of the covariance prediction comments.
Removal of unnecessary variable copy operations.
Replace index operations to initialise covariance to zero with the more efficient memset.
Use vertical velocity and position innovation failure to detect bad accelerometer data caused by clipping or aliasing which can cause large vertical acceleration errors and loss of height estimation. When bad accel data is detected:
1) Inhibit accelerometer bias learning
2) Force fusion of vertical velocity and height data
3) Increase accelerometer process noise
This was incorrectly using the IMU (1/250 sec) timestamp instead of the EKF (1/100 sec) value.
The corresponding accelerometer limit has been made a parameter and adjusted to match previous behaviour.
- if both gps position and velocity measurements are rejected for 7 seconds
do a reset
- if only gps position measurements are rejected then wait for 14 seconds
as we still have velocity measurements to constrain the drift in position
- introduced ecl internal parameter for the timeout
Signed-off-by: Roman <bapstroman@gmail.com>
Convert uncertainty in initial rotate vector into quaternion covariances using symbolic toolbox derived expressions.
Enable setting of initial angle uncertainty via a parameter
Roman
Paul Riseborough
CarlOlsson
Paul Riseborough
Daniel Agar
Lorenz Meier
Beat Küng
Roman Bapst
devbharat