px4-firmware/msg/manual_control_setpoint.msg

45 lines
2.4 KiB
Plaintext
Raw Normal View History

2014-12-08 06:06:56 -04:00
uint8 SWITCH_POS_NONE = 0 # switch is not mapped
uint8 SWITCH_POS_ON = 1 # switch activated (value = 1)
uint8 SWITCH_POS_MIDDLE = 2 # middle position (value = 0)
uint8 SWITCH_POS_OFF = 3 # switch not activated (value = -1)
uint64 timestamp
# Any of the channels may not be available and be set to NaN
# to indicate that it does not contain valid data.
# The variable names follow the definition of the
# MANUAL_CONTROL mavlink message.
# The default range is from -1 to 1 (mavlink message -1000 to 1000)
# The range for the z variable is defined from 0 to 1. (The z field of
# the MANUAL_CONTROL mavlink message is defined from -1000 to 1000)
float32 x # stick position in x direction -1..1
# in general corresponds to forward/back motion or pitch of vehicle,
# in general a positive value means forward or negative pitch and
# a negative value means backward or positive pitch
float32 y # stick position in y direction -1..1
# in general corresponds to right/left motion or roll of vehicle,
# in general a positive value means right or positive roll and
# a negative value means left or negative roll
float32 z # throttle stick position 0..1
# in general corresponds to up/down motion or thrust of vehicle,
# in general the value corresponds to the demanded throttle by the user,
# if the input is used for setting the setpoint of a vertical position
# controller any value > 0.5 means up and any value < 0.5 means down
float32 r # yaw stick/twist positon, -1..1
# in general corresponds to the righthand rotation around the vertical
# (downwards) axis of the vehicle
float32 flaps # flap position
float32 aux1 # default function: camera yaw / azimuth
float32 aux2 # default function: camera pitch / tilt
float32 aux3 # default function: camera trigger
float32 aux4 # default function: camera roll
float32 aux5 # default function: payload drop
uint8 mode_switch # main mode 3 position switch (mandatory): _MANUAL_, ASSIST, AUTO
uint8 return_switch # return to launch 2 position switch (mandatory): _NORMAL_, RTL
uint8 posctl_switch # position control 2 position switch (optional): _ALTCTL_, POSCTL
uint8 loiter_switch # loiter 2 position switch (optional): _MISSION_, LOITER
uint8 acro_switch # acro 2 position switch (optional): _MANUAL_, ACRO
uint8 offboard_switch # offboard 2 position switch (optional): _NORMAL_, OFFBOARD