46 lines
2.0 KiB
Bash
46 lines
2.0 KiB
Bash
# Enable IP forwarding
|
|
sudo sysctl \
|
|
-w # Write (or set) the value of a kernel parameter
|
|
net.ipv4.ip_forward=1 # Temporarily enable IP forwarding to forward network packets from one network interface to another
|
|
|
|
# Configure NAT for the bridge
|
|
sudo iptables \
|
|
-t nat # Specify the nat table used for Network Address Translation
|
|
-A POSTROUTING # Append this rule to the POSTROUTING chain, which alters packets as they are about to leave the network interface
|
|
-o wlp0s20f3 # Apply this rule to packets leaving the wlp0s20f3 interface (Wi-Fi interface)
|
|
-j MASQUERADE # Use the MASQUERADE target to change the source IP address to the IP address of the outgoing interface, enabling multiple devices on a private network to share a single public IP address
|
|
|
|
# Configure xbnet and bridge interfaces
|
|
sudo xbnet \
|
|
/dev/ttyUSB0 \ # Port where the XBee device is connected
|
|
tun # Create a TUN (network tunnel) interface for routing IP packets
|
|
|
|
sudo ip addr \
|
|
add 192.168.100.1/24 \ # Assign the IP address 192.168.100.1 with a subnet mask of 255.255.255.0
|
|
dev xbnet0 # to the xbnet0 interface
|
|
|
|
sudo ip link \
|
|
set dev xbnet0 up # Activate the xbnet0 interface
|
|
|
|
sudo brctl \
|
|
addbr br0 # Create a new bridge interface named br0
|
|
|
|
sudo brctl \
|
|
addif br0 wlp0s20f3 # Add the Wi-Fi interface wlp0s20f3 to the bridge br0
|
|
|
|
sudo brctl \
|
|
addif br0 xbnet0 # Add the xbnet0 interface to the bridge br0
|
|
|
|
sudo ip link \
|
|
set dev br0 up # Activate the bridge interface br0
|
|
|
|
sudo ip addr \
|
|
flush dev wlp0s20f3 # Remove any IP addresses assigned to the wlp0s20f3 interface
|
|
|
|
sudo ip addr \
|
|
add 192.168.7.122/24 \ # Assign the IP address 192.168.7.122 with a subnet mask of 255.255.255.0
|
|
dev br0 # to the bridge interface br0
|
|
|
|
sudo ip link \
|
|
set dev wlp0s20f3 up # Reactivate the wlp0s20f3 interface
|