mirror of https://github.com/ArduPilot/ardupilot
158 lines
6.2 KiB
Plaintext
158 lines
6.2 KiB
Plaintext
/// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: t -*-
|
|
|
|
/*
|
|
ArduPlane parameter definitions
|
|
|
|
This firmware is free software; you can redistribute it and/or
|
|
modify it under the terms of the GNU Lesser General Public
|
|
License as published by the Free Software Foundation; either
|
|
version 2.1 of the License, or (at your option) any later version.
|
|
*/
|
|
|
|
#define GSCALAR(v, name) { g.v.vtype, name, Parameters::k_param_ ## v, &g.v }
|
|
#define GGROUP(v, name, class) { AP_PARAM_GROUP, name, Parameters::k_param_ ## v, &g.v, class::var_info }
|
|
#define GOBJECT(v, name, class) { AP_PARAM_GROUP, name, Parameters::k_param_ ## v, &v, class::var_info }
|
|
|
|
static const AP_Param::Info var_info[] PROGMEM = {
|
|
GSCALAR(format_version, "FORMAT_VERSION"),
|
|
GSCALAR(software_type, "SOFTWARE_TYPE"),
|
|
GSCALAR(sysid_this_mav, "SYSID_THIS_MAV"),
|
|
GSCALAR(sysid_my_gcs, "SYSID_MYGCS"),
|
|
GSCALAR(serial3_baud, "SERIAL3_BAUD"),
|
|
GSCALAR(kff_pitch_compensation, "KFF_PTCHCOMP"),
|
|
GSCALAR(kff_rudder_mix, "KFF_RDDRMIX"),
|
|
GSCALAR(kff_pitch_to_throttle, "KFF_PTCH2THR"),
|
|
GSCALAR(kff_throttle_to_pitch, "KFF_THR2PTCH"),
|
|
|
|
GSCALAR(crosstrack_gain, "XTRK_GAIN_SC"),
|
|
GSCALAR(crosstrack_entry_angle, "XTRK_ANGLE_CD"),
|
|
|
|
GSCALAR(altitude_mix, "ALT_MIX"),
|
|
GSCALAR(airspeed_ratio, "ARSPD_RATIO"),
|
|
GSCALAR(airspeed_offset, "ARSPD_OFFSET"),
|
|
|
|
GSCALAR(command_total, "CMD_TOTAL"),
|
|
GSCALAR(command_index, "CMD_INDEX"),
|
|
GSCALAR(waypoint_radius, "WP_RADIUS"),
|
|
GSCALAR(loiter_radius, "WP_LOITER_RAD"),
|
|
|
|
#if GEOFENCE_ENABLED == ENABLED
|
|
GSCALAR(fence_action, "FENCE_ACTION"),
|
|
GSCALAR(fence_total, "FENCE_TOTAL"),
|
|
GSCALAR(fence_channel, "FENCE_CHANNEL"),
|
|
GSCALAR(fence_minalt, "FENCE_MINALT"),
|
|
GSCALAR(fence_maxalt, "FENCE_MAXALT"),
|
|
#endif
|
|
|
|
GSCALAR(flybywire_airspeed_min, "ARSPD_FBW_MIN"),
|
|
GSCALAR(flybywire_airspeed_max, "ARSPD_FBW_MAX"),
|
|
|
|
GSCALAR(throttle_min, "THR_MIN"),
|
|
GSCALAR(throttle_max, "THR_MAX"),
|
|
GSCALAR(throttle_slewrate, "THR_SLEWRATE"),
|
|
GSCALAR(throttle_fs_enabled, "THR_FAILSAFE"),
|
|
GSCALAR(throttle_fs_value, "THR_FS_VALUE"),
|
|
GSCALAR(throttle_cruise, "TRIM_THROTTLE"),
|
|
|
|
GSCALAR(short_fs_action, "FS_SHORT_ACTN"),
|
|
GSCALAR(long_fs_action, "FS_LONG_ACTN"),
|
|
GSCALAR(gcs_heartbeat_fs_enabled, "FS_GCS_ENABL"),
|
|
|
|
GSCALAR(flight_mode_channel, "FLTMODE_CH"),
|
|
GSCALAR(flight_mode1, "FLTMODE1"),
|
|
GSCALAR(flight_mode2, "FLTMODE2"),
|
|
GSCALAR(flight_mode3, "FLTMODE3"),
|
|
GSCALAR(flight_mode4, "FLTMODE4"),
|
|
GSCALAR(flight_mode5, "FLTMODE5"),
|
|
GSCALAR(flight_mode6, "FLTMODE6"),
|
|
|
|
GSCALAR(roll_limit, "LIM_ROLL_CD"),
|
|
GSCALAR(pitch_limit_max, "LIM_PITCH_MAX"),
|
|
GSCALAR(pitch_limit_min, "LIM_PITCH_MIN"),
|
|
|
|
GSCALAR(auto_trim, "TRIM_AUTO"),
|
|
GSCALAR(switch_enable, "SWITCH_ENABLE"),
|
|
GSCALAR(mix_mode, "ELEVON_MIXING"),
|
|
GSCALAR(reverse_elevons, "ELEVON_REVERSE"),
|
|
GSCALAR(reverse_ch1_elevon, "ELEVON_CH1_REV"),
|
|
GSCALAR(reverse_ch2_elevon, "ELEVON_CH2_REV"),
|
|
GSCALAR(num_resets, "SYS_NUM_RESETS"),
|
|
GSCALAR(log_bitmask, "LOG_BITMASK"),
|
|
GSCALAR(log_last_filenumber, "LOG_LASTFILE"),
|
|
GSCALAR(reset_switch_chan, "RST_SWITCH_CH"),
|
|
GSCALAR(airspeed_cruise, "TRIM_ARSPD_CM"),
|
|
GSCALAR(min_gndspeed, "MIN_GNDSPD_CM"),
|
|
GSCALAR(pitch_trim, "TRIM_PITCH_CD"),
|
|
GSCALAR(RTL_altitude, "ALT_HOLD_RTL"),
|
|
GSCALAR(FBWB_min_altitude, "ALT_HOLD_FBWCM"),
|
|
GSCALAR(ground_temperature, "GND_TEMP"),
|
|
GSCALAR(ground_pressure, "GND_ABS_PRESS"),
|
|
GSCALAR(compass_enabled, "MAG_ENABLE"),
|
|
GSCALAR(flap_1_percent, "FLAP_1_PERCNT"),
|
|
GSCALAR(flap_1_speed, "FLAP_1_SPEED"),
|
|
GSCALAR(flap_2_percent, "FLAP_2_PERCNT"),
|
|
GSCALAR(flap_2_speed, "FLAP_2_SPEED"),
|
|
|
|
|
|
GSCALAR(battery_monitoring, "BATT_MONITOR"),
|
|
GSCALAR(volt_div_ratio, "VOLT_DIVIDER"),
|
|
GSCALAR(curr_amp_per_volt, "AMP_PER_VOLT"),
|
|
GSCALAR(input_voltage, "INPUT_VOLTS"),
|
|
GSCALAR(pack_capacity, "BATT_CAPACITY"),
|
|
GSCALAR(inverted_flight_ch, "INVERTEDFLT_CH"),
|
|
GSCALAR(sonar_enabled, "SONAR_ENABLE"),
|
|
GSCALAR(airspeed_enabled, "ARSPD_ENABLE"),
|
|
|
|
GGROUP(channel_roll, "RC1_", RC_Channel),
|
|
GGROUP(channel_pitch, "RC2_", RC_Channel),
|
|
GGROUP(channel_throttle, "RC3_", RC_Channel),
|
|
GGROUP(channel_rudder, "RC4_", RC_Channel),
|
|
GGROUP(rc_5, "RC5_", RC_Channel_aux),
|
|
GGROUP(rc_6, "RC6_", RC_Channel_aux),
|
|
GGROUP(rc_7, "RC7_", RC_Channel_aux),
|
|
GGROUP(rc_8, "RC8_", RC_Channel_aux),
|
|
|
|
GGROUP(pidNavRoll, "HDNG2RLL_", PID),
|
|
GGROUP(pidServoRoll, "RLL2SRV_", PID),
|
|
GGROUP(pidServoPitch, "PTCH2SRV_", PID),
|
|
GGROUP(pidNavPitchAirspeed, "ARSP2PTCH_", PID),
|
|
GGROUP(pidServoRudder, "YW2SRV_", PID),
|
|
GGROUP(pidTeThrottle, "ENRGY2THR_", PID),
|
|
GGROUP(pidNavPitchAltitude, "ALT2PTCH_", PID),
|
|
|
|
// variables not in the g class which contain EEPROM saved variables
|
|
GOBJECT(compass, "COMPASS_", Compass)
|
|
};
|
|
|
|
|
|
static void load_parameters(void)
|
|
{
|
|
// setup the AP_Var subsystem for storage to EEPROM
|
|
if (!AP_Param::setup(var_info, sizeof(var_info)/sizeof(var_info[0]), WP_START_BYTE)) {
|
|
// this can only happen on startup, and its a definate coding
|
|
// error. Best not to continue so the programmer catches it
|
|
while (1) {
|
|
Serial.println_P(PSTR("ERROR: Failed to setup AP_Param"));
|
|
delay(1000);
|
|
}
|
|
}
|
|
|
|
if (!g.format_version.load() ||
|
|
g.format_version != Parameters::k_format_version) {
|
|
|
|
// erase all parameters
|
|
Serial.printf_P(PSTR("Firmware change: erasing EEPROM...\n"));
|
|
AP_Param::erase_all();
|
|
|
|
// save the current format version
|
|
g.format_version.set_and_save(Parameters::k_format_version);
|
|
Serial.println_P(PSTR("done."));
|
|
} else {
|
|
unsigned long before = micros();
|
|
// Load all auto-loaded EEPROM variables
|
|
AP_Param::load_all();
|
|
|
|
Serial.printf_P(PSTR("load_all took %luus\n"), micros() - before);
|
|
}
|
|
}
|