ardupilot/ArduCopter/control_land.cpp

325 lines
12 KiB
C++

#include "Copter.h"
static bool land_with_gps;
static uint32_t land_start_time;
static bool land_pause;
// land_init - initialise land controller
bool Copter::land_init(bool ignore_checks)
{
// check if we have GPS and decide which LAND we're going to do
land_with_gps = position_ok();
if (land_with_gps) {
// set target to stopping point
Vector3f stopping_point;
wp_nav->get_loiter_stopping_point_xy(stopping_point);
wp_nav->init_loiter_target(stopping_point);
}
// initialize vertical speeds and leash lengths
pos_control->set_speed_z(wp_nav->get_speed_down(), wp_nav->get_speed_up());
pos_control->set_accel_z(wp_nav->get_accel_z());
// initialise position and desired velocity
if (!pos_control->is_active_z()) {
pos_control->set_alt_target_to_current_alt();
pos_control->set_desired_velocity_z(inertial_nav.get_velocity_z());
}
land_start_time = millis();
land_pause = false;
// reset flag indicating if pilot has applied roll or pitch inputs during landing
ap.land_repo_active = false;
return true;
}
// land_run - runs the land controller
// should be called at 100hz or more
void Copter::land_run()
{
if (land_with_gps) {
land_gps_run();
}else{
land_nogps_run();
}
}
// land_gps_run - runs the land controller
// horizontal position controlled with loiter controller
// should be called at 100hz or more
void Copter::land_gps_run()
{
// if not auto armed or landed or motor interlock not enabled set throttle to zero and exit immediately
if (!motors->armed() || !ap.auto_armed || ap.land_complete || !motors->get_interlock()) {
#if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw
// call attitude controller
attitude_control->input_euler_angle_roll_pitch_euler_rate_yaw(0, 0, 0, get_smoothing_gain());
attitude_control->set_throttle_out(0,false,g.throttle_filt);
#else
motors->set_desired_spool_state(AP_Motors::DESIRED_SPIN_WHEN_ARMED);
// multicopters do not stabilize roll/pitch/yaw when disarmed
attitude_control->set_throttle_out_unstabilized(0,true,g.throttle_filt);
#endif
wp_nav->init_loiter_target();
// disarm when the landing detector says we've landed
if (ap.land_complete) {
init_disarm_motors();
}
return;
}
// set motors to full range
motors->set_desired_spool_state(AP_Motors::DESIRED_THROTTLE_UNLIMITED);
// pause before beginning land descent
if(land_pause && millis()-land_start_time >= LAND_WITH_DELAY_MS) {
land_pause = false;
}
land_run_horizontal_control();
land_run_vertical_control(land_pause);
}
// land_nogps_run - runs the land controller
// pilot controls roll and pitch angles
// should be called at 100hz or more
void Copter::land_nogps_run()
{
float target_roll = 0.0f, target_pitch = 0.0f;
float target_yaw_rate = 0;
// process pilot inputs
if (!failsafe.radio) {
if ((g.throttle_behavior & THR_BEHAVE_HIGH_THROTTLE_CANCELS_LAND) != 0 && rc_throttle_control_in_filter.get() > LAND_CANCEL_TRIGGER_THR){
Log_Write_Event(DATA_LAND_CANCELLED_BY_PILOT);
// exit land if throttle is high
set_mode(ALT_HOLD, MODE_REASON_THROTTLE_LAND_ESCAPE);
}
if (g.land_repositioning) {
// apply SIMPLE mode transform to pilot inputs
update_simple_mode();
// get pilot desired lean angles
get_pilot_desired_lean_angles(channel_roll->get_control_in(), channel_pitch->get_control_in(), target_roll, target_pitch, aparm.angle_max);
}
// get pilot's desired yaw rate
target_yaw_rate = get_pilot_desired_yaw_rate(channel_yaw->get_control_in());
}
// if not auto armed or landed or motor interlock not enabled set throttle to zero and exit immediately
if (!motors->armed() || !ap.auto_armed || ap.land_complete || !motors->get_interlock()) {
#if FRAME_CONFIG == HELI_FRAME // Helicopters always stabilize roll/pitch/yaw
// call attitude controller
attitude_control->input_euler_angle_roll_pitch_euler_rate_yaw(target_roll, target_pitch, target_yaw_rate, get_smoothing_gain());
attitude_control->set_throttle_out(0,false,g.throttle_filt);
#else
motors->set_desired_spool_state(AP_Motors::DESIRED_SPIN_WHEN_ARMED);
// multicopters do not stabilize roll/pitch/yaw when disarmed
attitude_control->set_throttle_out_unstabilized(0,true,g.throttle_filt);
#endif
// disarm when the landing detector says we've landed
if (ap.land_complete) {
init_disarm_motors();
}
return;
}
// set motors to full range
motors->set_desired_spool_state(AP_Motors::DESIRED_THROTTLE_UNLIMITED);
// call attitude controller
attitude_control->input_euler_angle_roll_pitch_euler_rate_yaw(target_roll, target_pitch, target_yaw_rate, get_smoothing_gain());
// pause before beginning land descent
if(land_pause && millis()-land_start_time >= LAND_WITH_DELAY_MS) {
land_pause = false;
}
land_run_vertical_control(land_pause);
}
/*
get a height above ground estimate for landing
*/
int32_t Copter::land_get_alt_above_ground(void)
{
int32_t alt_above_ground;
if (rangefinder_alt_ok()) {
alt_above_ground = rangefinder_state.alt_cm_filt.get();
} else {
bool navigating = pos_control->is_active_xy();
if (!navigating || !current_loc.get_alt_cm(Location_Class::ALT_FRAME_ABOVE_TERRAIN, alt_above_ground)) {
alt_above_ground = current_loc.alt;
}
}
return alt_above_ground;
}
void Copter::land_run_vertical_control(bool pause_descent)
{
bool navigating = pos_control->is_active_xy();
#if PRECISION_LANDING == ENABLED
bool doing_precision_landing = !ap.land_repo_active && precland.target_acquired() && navigating;
#else
bool doing_precision_landing = false;
#endif
// compute desired velocity
const float precland_acceptable_error = 15.0f;
const float precland_min_descent_speed = 10.0f;
int32_t alt_above_ground = land_get_alt_above_ground();
float cmb_rate = 0;
if (!pause_descent) {
float max_land_descent_velocity;
if (g.land_speed_high > 0) {
max_land_descent_velocity = -g.land_speed_high;
} else {
max_land_descent_velocity = pos_control->get_speed_down();
}
// Don't speed up for landing.
max_land_descent_velocity = MIN(max_land_descent_velocity, -abs(g.land_speed));
// Compute a vertical velocity demand such that the vehicle approaches LAND_START_ALT. Without the below constraint, this would cause the vehicle to hover at LAND_START_ALT.
cmb_rate = AC_AttitudeControl::sqrt_controller(LAND_START_ALT-alt_above_ground, g.p_alt_hold.kP(), pos_control->get_accel_z());
// Constrain the demanded vertical velocity so that it is between the configured maximum descent speed and the configured minimum descent speed.
cmb_rate = constrain_float(cmb_rate, max_land_descent_velocity, -abs(g.land_speed));
if (doing_precision_landing && rangefinder_alt_ok() && rangefinder_state.alt_cm > 35.0f && rangefinder_state.alt_cm < 200.0f) {
float max_descent_speed = abs(g.land_speed)/2.0f;
float land_slowdown = MAX(0.0f, pos_control->get_horizontal_error()*(max_descent_speed/precland_acceptable_error));
cmb_rate = MIN(-precland_min_descent_speed, -max_descent_speed+land_slowdown);
}
}
// update altitude target and call position controller
pos_control->set_alt_target_from_climb_rate_ff(cmb_rate, G_Dt, true);
pos_control->update_z_controller();
}
void Copter::land_run_horizontal_control()
{
int16_t roll_control = 0, pitch_control = 0;
float target_yaw_rate = 0;
// relax loiter target if we might be landed
if (ap.land_complete_maybe) {
wp_nav->loiter_soften_for_landing();
}
// process pilot inputs
if (!failsafe.radio) {
if ((g.throttle_behavior & THR_BEHAVE_HIGH_THROTTLE_CANCELS_LAND) != 0 && rc_throttle_control_in_filter.get() > LAND_CANCEL_TRIGGER_THR){
Log_Write_Event(DATA_LAND_CANCELLED_BY_PILOT);
// exit land if throttle is high
if (!set_mode(LOITER, MODE_REASON_THROTTLE_LAND_ESCAPE)) {
set_mode(ALT_HOLD, MODE_REASON_THROTTLE_LAND_ESCAPE);
}
}
if (g.land_repositioning) {
// apply SIMPLE mode transform to pilot inputs
update_simple_mode();
// process pilot's roll and pitch input
roll_control = channel_roll->get_control_in();
pitch_control = channel_pitch->get_control_in();
// record if pilot has overriden roll or pitch
if (roll_control != 0 || pitch_control != 0) {
ap.land_repo_active = true;
}
}
// get pilot's desired yaw rate
target_yaw_rate = get_pilot_desired_yaw_rate(channel_yaw->get_control_in());
}
#if PRECISION_LANDING == ENABLED
bool doing_precision_landing = !ap.land_repo_active && precland.target_acquired();
// run precision landing
if (doing_precision_landing) {
Vector2f target_pos, target_vel_rel;
if (!precland.get_target_position_cm(target_pos)) {
target_pos.x = inertial_nav.get_position().x;
target_pos.y = inertial_nav.get_position().y;
}
if (!precland.get_target_velocity_relative_cms(target_vel_rel)) {
target_vel_rel.x = -inertial_nav.get_velocity().x;
target_vel_rel.y = -inertial_nav.get_velocity().y;
}
pos_control->set_xy_target(target_pos.x, target_pos.y);
pos_control->override_vehicle_velocity_xy(-target_vel_rel);
}
#endif
// process roll, pitch inputs
wp_nav->set_pilot_desired_acceleration(roll_control, pitch_control);
// run loiter controller
wp_nav->update_loiter(ekfGndSpdLimit, ekfNavVelGainScaler);
int32_t nav_roll = wp_nav->get_roll();
int32_t nav_pitch = wp_nav->get_pitch();
if (g2.wp_navalt_min > 0) {
// user has requested an altitude below which navigation
// attitude is limited. This is used to prevent commanded roll
// over on landing, which particularly affects helicopters if
// there is any position estimate drift after touchdown. We
// limit attitude to 7 degrees below this limit and linearly
// interpolate for 1m above that
int alt_above_ground = land_get_alt_above_ground();
float attitude_limit_cd = linear_interpolate(700, aparm.angle_max, alt_above_ground,
g2.wp_navalt_min*100U, (g2.wp_navalt_min+1)*100U);
float total_angle_cd = norm(nav_roll, nav_pitch);
if (total_angle_cd > attitude_limit_cd) {
float ratio = attitude_limit_cd / total_angle_cd;
nav_roll *= ratio;
nav_pitch *= ratio;
// tell position controller we are applying an external limit
pos_control->set_limit_accel_xy();
}
}
// call attitude controller
attitude_control->input_euler_angle_roll_pitch_euler_rate_yaw(nav_roll, nav_pitch, target_yaw_rate, get_smoothing_gain());
}
// land_do_not_use_GPS - forces land-mode to not use the GPS but instead rely on pilot input for roll and pitch
// called during GPS failsafe to ensure that if we were already in LAND mode that we do not use the GPS
// has no effect if we are not already in LAND mode
void Copter::land_do_not_use_GPS()
{
land_with_gps = false;
}
// set_mode_land_with_pause - sets mode to LAND and triggers 4 second delay before descent starts
// this is always called from a failsafe so we trigger notification to pilot
void Copter::set_mode_land_with_pause(mode_reason_t reason)
{
set_mode(LAND, reason);
land_pause = true;
// alert pilot to mode change
AP_Notify::events.failsafe_mode_change = 1;
}
// landing_with_GPS - returns true if vehicle is landing using GPS
bool Copter::landing_with_GPS() {
return (control_mode == LAND && land_with_gps);
}