ardupilot/libraries/AP_Motors/AP_MotorsSingle.h

72 lines
2.5 KiB
C++

// -*- tab-width: 4; Mode: C++; c-basic-offset: 4; indent-tabs-mode: nil -*-
/// @file AP_MotorsSingle.h
/// @brief Motor and Servo control class for Singlecopters
#ifndef __AP_MOTORS_SING_H__
#define __AP_MOTORS_SING_H__
#include <AP_Common.h>
#include <AP_Math.h> // ArduPilot Mega Vector/Matrix math Library
#include <RC_Channel.h> // RC Channel Library
#include "AP_Motors.h"
// feedback direction
#define AP_MOTORS_SING_POSITIVE 1
#define AP_MOTORS_SING_NEGATIVE -1
#define AP_MOTORS_SINGLE_SPEED_DIGITAL_SERVOS 250 // update rate for digital servos
#define AP_MOTORS_SINGLE_SPEED_ANALOG_SERVOS 125 // update rate for analog servos
#define AP_MOTORS_SINGLE_SERVO_INPUT_RANGE 4500 // roll or pitch input of -4500 will cause servos to their minimum (i.e. radio_min), +4500 will move them to their maximum (i.e. radio_max)
/// @class AP_MotorsSingle
class AP_MotorsSingle : public AP_Motors {
public:
/// Constructor
AP_MotorsSingle( RC_Channel& rc_roll, RC_Channel& rc_pitch, RC_Channel& rc_throttle, RC_Channel& rc_yaw, RC_Channel& servo1, RC_Channel& servo2, RC_Channel& servo3, RC_Channel& servo4, uint16_t speed_hz = AP_MOTORS_SPEED_DEFAULT) :
AP_Motors(rc_roll, rc_pitch, rc_throttle, rc_yaw, speed_hz),
_servo1(servo1),
_servo2(servo2),
_servo3(servo3),
_servo4(servo4)
{
AP_Param::setup_object_defaults(this, var_info);
};
// init
virtual void Init();
// set update rate to motors - a value in hertz
void set_update_rate( uint16_t speed_hz );
// enable - starts allowing signals to be sent to motors
virtual void enable();
// output_test - spin each motor for a moment to allow the user to confirm the motor order and spin direction
virtual void output_test();
// output_min - sends minimum values out to the motors
virtual void output_min();
// var_info for holding Parameter information
static const struct AP_Param::GroupInfo var_info[];
protected:
// output - sends commands to the motors
virtual void output_armed();
virtual void output_disarmed();
AP_Int8 _rev_roll; // REV Roll feedback
AP_Int8 _rev_pitch; // REV pitch feedback
AP_Int8 _rev_yaw; // REV yaw feedback
AP_Int16 _servo_speed; // servo speed
RC_Channel& _servo1;
RC_Channel& _servo2;
RC_Channel& _servo3;
RC_Channel& _servo4;
};
#endif // AP_MOTORSSINGLE