mirror of https://github.com/ArduPilot/ardupilot
77 lines
1.9 KiB
C++
77 lines
1.9 KiB
C++
#include <AP_HAL.h>
|
|
|
|
#if CONFIG_HAL_BOARD_SUBTYPE == HAL_BOARD_SUBTYPE_LINUX_NAVIO
|
|
|
|
#include <stdio.h>
|
|
#include <stdlib.h>
|
|
#include <unistd.h>
|
|
#include <fcntl.h>
|
|
#include <stdint.h>
|
|
#include <sys/ioctl.h>
|
|
|
|
#include "RCInput_Navio.h"
|
|
|
|
extern const AP_HAL::HAL& hal;
|
|
|
|
using namespace Linux;
|
|
|
|
// This is a prototype code for RC input decoding on Raspberry Pi.
|
|
// It uses pigpio daemon to sample GPIOs over DMA with 1 microsecond resolution.
|
|
// This code should be rewritten to configure DMA GPIO sampling without pigpio.
|
|
|
|
void LinuxRCInput_Navio::init(void*)
|
|
{
|
|
curtick = 0;
|
|
prevtick = 0;
|
|
width_s0 = 0;
|
|
width_s1 = 0;
|
|
|
|
// Kills pigpio daemon in case it was run with wrong parameters
|
|
|
|
system("killall pigpiod -q");
|
|
hal.scheduler->delay(1000);
|
|
|
|
// Starts pigpio daemon with 1 microsecond sampling resolution
|
|
|
|
system("pigpiod -s 1");
|
|
hal.scheduler->delay(1000);
|
|
|
|
// Configures pigpiod to send GPIO change notifications to /dev/pigpio0
|
|
|
|
system("pigs NO NB 0 0x10");
|
|
hal.scheduler->delay(1000);
|
|
|
|
// Configures /dev/pigpio0 for non-blocking read
|
|
|
|
pigpio = open("/dev/pigpio0", O_RDONLY);
|
|
|
|
if (pigpio == -1)
|
|
hal.scheduler->panic("No pigpio interface for RCInput");
|
|
}
|
|
|
|
void LinuxRCInput_Navio::_timer_tick()
|
|
{
|
|
while (true) {
|
|
int bytesAvailable;
|
|
ioctl(pigpio, FIONREAD, &bytesAvailable);
|
|
|
|
if (bytesAvailable >= 12)
|
|
::read(pigpio, reinterpret_cast<uint8_t*>(&gpioReport), 12);
|
|
else
|
|
break;
|
|
|
|
prevtick = curtick;
|
|
curtick = gpioReport.tick;
|
|
|
|
if (((gpioReport.level >> 4) & 0x01) == 0) {
|
|
width_s0 = curtick - prevtick;
|
|
}
|
|
else {
|
|
width_s1 = curtick - prevtick;
|
|
_process_rc_pulse(width_s0, width_s1);
|
|
}
|
|
}
|
|
}
|
|
|
|
#endif // CONFIG_HAL_BOARD_SUBTYPE
|