mirror of https://github.com/ArduPilot/ardupilot
51 lines
2.3 KiB
Plaintext
51 lines
2.3 KiB
Plaintext
Make sure you update the libraries from the arducopter trunk and the latest code from the ardupilotmega branch.
|
|
I have a lot of setup commands now. I may reduce and consolidate these soon.
|
|
|
|
Radio:
|
|
ch1 = roll
|
|
ch2 = pitch
|
|
ch3 = throttle
|
|
ch4 = yaw
|
|
ch5 = mode switch - use your 3 position switch
|
|
ch6 = used for tuning - not currently active, search for "rc_6" to enable
|
|
ch7 = use to set throttle hold value while hovering (quick toggle), hold > 5 seconds on ground to reset the accelerometer offsets.
|
|
ch8 = not used
|
|
|
|
setup:
|
|
erase - run this first, just in case
|
|
reset - run this second
|
|
radio - run this third
|
|
esc - just ignore this for now
|
|
level - optional - sets accelerometer offsets
|
|
flat - optional - sets accelerometer offsets to 0
|
|
modes - interactive setup for flight modes
|
|
pid - optional - writes default PID values to eeprom
|
|
frame - optional - default is "+"
|
|
enable_mag - enables the compass
|
|
disable_mag - disables the compass
|
|
compass - interactive setup for compass offsets
|
|
declination - usage: "declination 14.25"
|
|
show - shows all values
|
|
|
|
Flight modes to try:
|
|
stabilize - yay
|
|
Alt_hold - You need to set your throttle_cruise value by toggling ch_7 for less than 1 second. (Mine is 330), altitude is controlled by the throttle lever.
|
|
FBW - Simulates GPS Hold with the sticks being the position offset. Manual Throttle.
|
|
position_hold - When selected, it will hold the current altitude, position and yaw. Yaw is user controllable. roll and pitch can be overridden with the radio.
|
|
RTL - not tested yet, will try and fly back to home at the current altitude.
|
|
Auto - not tested yet, i'm finishing a waypoint writing sketch and will be ready to test soon
|
|
|
|
- what's new
|
|
- CMD_ANGLE - will set the desired yaw with control of angle/second and direction.
|
|
- CMD_ALTITUDE - will send the copter up from current position to desired altitude
|
|
- CMD_R_WAYPOINT - is just like a waypoint but relative to home
|
|
- CMD_TRACK_WAYPOINT - coming soon, will point the copter at the waypoint no matter the position
|
|
|
|
Special note:
|
|
Any mode other than stabilize will cause the props to spin once the control switch is engaged.
|
|
The props will NOT spin in stabilize when throttle is in the off position, even when armed.
|
|
Arming is Yaw right for 1 sec, disarm is yaw left for 1 sec. Just give it some juice to confirm arming.
|
|
Good luck,
|
|
Jason
|
|
|