ardupilot/libraries/AP_HAL_ChibiOS/hwdef/DrotekP3Pro/hwdef-bl.dat

68 lines
1.4 KiB
Plaintext

# hw definition file for processing by chibios_hwdef.py
# for bootloader for FMUv4pro hardware (Pixhawk 3 Pro)
# MCU class and specific type
MCU STM32F4xx STM32F469xx
# board ID for firmware load
APJ_BOARD_ID 13
# crystal frequency
OSCILLATOR_HZ 24000000
# ChibiOS system timer
STM32_ST_USE_TIMER 5
# flash size
FLASH_SIZE_KB 2048
# location of application code
FLASH_BOOTLOADER_LOAD_KB 16
# bootloader loads at start of flash
FLASH_RESERVE_START_KB 0
# uarts and USB to run bootloader protocol on
SERIAL_ORDER OTG1 USART2 USART3
# this is the pin that senses USB being connected. It is an input pin
# setup as OPENDRAIN
PA9 VBUS INPUT OPENDRAIN
# now we define the pins that USB is connected on
PA11 OTG_FS_DM OTG1
PA12 OTG_FS_DP OTG1
# these are the pins for SWD debugging with a STlinkv2 or black-magic probe
PA13 JTMS-SWDIO SWD
PA14 JTCK-SWCLK SWD
# Another USART, this one for telem1
PD5 USART2_TX USART2
PD6 USART2_RX USART2
PD3 USART2_CTS USART2
PD4 USART2_RTS USART2
# the telem2 USART, also with RTS/CTS available
# USART3 serial3 telem2
PD8 USART3_TX USART3
PD9 USART3_RX USART3
PD11 USART3_CTS USART3
PD12 USART3_RTS USART3
# define a LED
PB1 LED_BOOTLOADER OUTPUT
PB11 LED_ACTIVITY OUTPUT
define HAL_LED_ON 1
# we need to tell HAL_ChibiOS/Storage.cpp how much storage is
# available (in bytes)
# Add CS pins to ensure they are high in bootloader
PC2 MPU9250_CS CS
PC15 20608_CS CS
PD7 BARO_CS CS
PE15 MAG_CS CS
PH5 EEPROM_CS CS
PD10 FRAM_CS CS